Whether the material have negative Poisson’s ratio or not.

Question

Want to see the full answer?

Answer 1

Question

Chapter 2, Problem 2.39Q

To determine

Whether the material have negative Poisson’s ratio or not.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

The lower yield point for a certain plain carbon steelbar is found to be 135 MPa, while a second bar of the samecomposition yields at 260 MPa. Metallographic analysisshows that the average grain diameter is 50μm in the firstbar and 8μm in the second bar.a. Predict the grain diameter needed to cause a loweryield point of 205 MPa.b. If the steel could be fabricated to form a stablegrain structure of 500 nm grains, what strengthwould be predicted?c. Why might you expect the upper yield point to bemore alike in the first two bars than the lower yieldpoint?

Question 1 You are working on a design team at a small orthopaedic firm. You have been asked to select a cobalt- chrome-molybdenum (CoCr) material that will not experience plastic deformation under a specific mechanical test, as follows... A tensile stress is applied along the long axis of a solid cylindrical rod that has a diameter of 10 mm. An applied load of some magnitude F produces a 7x10³ mm change in diameter (see figure below, original shape is blue, elongated shape is unshaded). Q1F: How would the "new alloy" material (with different properties as shown below) behave, assuming it has the same initial diameter (10mm) and applied load (F) in the tensile test? That is, would it experience plastic deformation (yield) under the conditions of this problem?

The lower yield point for a certain plain carbon steel bar is found to be 135 MPa, while a second bar of the same composition yields at 260 MPa. Metallographic analysis shows that the average grain diameter is 50 µm in the first bar and 8 µm in the second bar. Predict the grain diameter needed to cause a lower yield point of 205 MPa.