The heating element of a water heater in an apartment building has a maximum power output of 26kW. Four residents of the building take showers at the same time, and each receives heated water at avolume flow rate of 16x10-5 m³/s. If the water going into the heater has a temperature of 18°C, what isthe maximum possible temperature of the hot water that each showering resident receives?21°

Approach to solving the question:Please see attached photos for detailed solutions. Thank you.…

Answered: The heating element of a water heater…

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter2: The Kinetic Theory Of Gases

Section: Chapter Questions

Problem 56P: (a) If the partial pressure of water vapor is 8.05 torr, what is the dew point? (760 torr = I atm...

See similar textbooks

Similar questions

A hollow aluminum cylinder 20.0 cm deep has an internal capacity of 2.000 L at 20.0C. It is completely filled with turpentine at 20.0C. The turpentine and the aluminum cylinder are then slowly warmed together to 80.0C. (a) How much turpentine overflows? (b) What is the volume of the turpentine remaining in the cylinder at 80.0C? (c) If the combination with this amount of turpentine is then cooled back to 20.0C, how far below the cylinders rim does the turpentines surface recede?
(a) What is the rate of heat conduction through the 3.00-cm-thick fur of a large animal having a I .40-m surface area? Assume that the animal's skin temperature is 32.0 , that the air temperature is 5.00 , and that has the same thermal conductivity as air. (b) What food intake will the animal need in one day to replace this heat transfer?
In 1986, a gargantuan iceberg broke away from the Ross Ice Shelf in Antarctica. It was approximately a rectangle 160 km long, 40.0 km wide, and 250 m thick. (a) What is the mass of this iceberg, given that the density of ice is 917kg/m3 ? (b) How much heat transfer (in joules) is needed to melt it? (c) How many years would it take sunlight alone to melt ice this thick, if the ice absorbs an average of 100W/m2, 12.00 h per day?
(a) If the partial pressure of water vapor is 8.05 torr, what is the dew point? (760 torr = I atm 101, 325 Pa) (b) On a warn day when the air temperature is 35 and the dew point is 25 , what are the partial of the water in the air and the relative humidity?
(a) The number of kilocalories in food is determined by calorimetry techniques in which the food is burned and the amount of heat transfer is measured. How many kilocalories per gram ale there in a 5.00-g peanut if the energy from burning it is transferred to 0. 500 kg of water held in a 0.100-kg aluminum cup, causing a 54.9- temperature increase? Assume the process takes place in an ideal calorimeter, in other words a perfectly insulated container. (b) Compare your answer to the following labeling information found on a package of dry roasted peanuts: a sewing of 33 g contains 200 calories. Comment on whether the values are consistent.
The thermal conductivities of human tissues vary greatly. Fat and skin have conductivities of about 0.20 W/m K and 0.020 W/m K, respectively, while other tissues inside the body have conductivities of about 0.50 W/m K. Assume that between the core region of the body and the skin sin face lies a skin layer of 1.0 mm, fat layer of 0.50 cm, and 3.2 cm of other tissues. (a) Find the R-factor for each of these layers, and the equivalent R-factor for all layers taken together, retaining two digits. (b) Find the rate of energy loss when the core temperature is 37C and the exterior temperature is 0C. Assume that both a protective layer of clothing and an insulating layer of unmoving air a absent, and a body area of 2.0 m2.
Bananas are to be cooled from 24 to 13°C at a rate of 215 kg/h by a refrigeration system. The power input to the refrigerator is 1.4 kW. Determine the rate of cooling, in kJ/min, and the COP of the refrigerator. The specific heat of banana above freezing is 3.35 kJ/kg·°C.
In order to determine the heat capacity of their latest phone, CrabappleTM engineers cool the phone in the freezer to -39.9ºC. They then drop it into a calorimeter with some water in it that is at a temperature of 59.2ºC. The calorimeter (including the water) has a total heat capacity of 773.59 J/ºC. After a few minutes the temperature of the calorimeter is stabilized to 30.2ºC. What is the heat capacity of the phone? Enter your answer with at least 3 sig figs assuming units of J/ºC.
A 450 g metal cube which is originally at 110 degree(s) C oven is dropped into 0.003 m3 of water in a at 70 degrees Celcuis in an insulated cup. After both water and cube reached thermal equilibrium, the final temp is 78 degrees Celsius. What is the specific heat capacity of the uknown metal cube? cWater= 4200 j/kgK cCube=? A. 2800 j/kgk B. 7000 j/kgk C. 6500 j/kgk D. 5100 j/kgk E. None
A cube of ice is taken from the freezer at -8.4°C and placed in a 94 g zinc cup filled with 307 g of water. Both the water & the cup are at 20.1°C. Eventually the system reaches thermal equilibrium at 18.4°C. Determine Qcup Qwater (for the water initially in the cup), Qice, & the mass of the ice. Qcup = Qwater Specific heat Solids (J/kg.K) Aluminum 900 Liquids Specific heat (J/kg.K) Brass 402 Bromine 473 Copper 377 Ethyl 2400 Alcohol Glass 840 Gasoline 2220 Gold 126 Glycerin 2430 Ice 2095 Mercury 140 Iron 461 Water 4186 Qice mice = Lead 130 Nickel 502 Latent Heat Substance (J/kg) Silver 239 Steam water 2,260,000 Styrofoam 1131 Ice water 333,000 Zinc 390
A family comes home from a long vacation with laundry to do and showers to take. The water heater has been turned offduring the vacation. If the heater has a capacity of 50.0 gallons and a 4 800-W heating element, how much time is required to raise the temperature of the water from 20.0°C to 60.0°C? Assume the heater is well insulated and no water is withdrawn from the tank during that time.
A building with an internal volume of 400 m3 is to be heated by a 30-kW electric resistance heater placed in the duct inside the building. Initially, the air in the building is at 14°C, and the local atmospheric pressure is 95 kPa. The building is losing heat to the surroundings at a steady rate of 450 kJ/min. Air is forced to flow through the duct and the heater steadily by a 250-W fan, and it experiences a temperature rise of 5°C each time it passes through the duct, which may be assumed to be adiabatic. (a) How long will it take for the air inside the building to reach an average temperature of 24°C? (b) Determine the average mass flow rate of air through the duct.

SEE MORE QUESTIONS

Recommended textbooks for you

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781285737027

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

SEE MORE TEXTBOOKS