A uniform beam of length L = 7.10 m and weight 4.05 x 102 N is carried by two workers, Sam and Joe, as shown in thefigure below. Determine the force that each person exerts on the beam.SamJoe-1.00 m-2.00 m-LiF= 148.02Sam Your response is within 10% of the correct value. This may be due to roundoff error, or you could have a mistake inyour calculation. Carry out all intermediate results to at least four-digit accuracy to minimize roundoff error. NNF= 253Joe

Answered: Image /qna-images/answer/13391b8c-b436-46f2-b6e9-93941955ee90.jpg

A uniform beam of length L = 7.10 m and weight 4.05 × 10² N is carried by two workers, Sam and Joe, as shown in the figure below. Determine the force that each person exerts on the beam. Sam Joe = 148.02 1.00 m 2.00 m- L FSam Your response is within 10% of the correct value. This may be due to roundoff error, or you could have a mistake your calculation. Carry out all intermediate results to at least four-digit accuracy to minimize roundoff error. N = 253 FJoe N

A uniform beam of length L = 7.10 m and weight 4.05 × 10² N is carried by two workers, Sam and Joe, as shown in the figure below. Determine the force that each person exerts on the beam. Sam Joe = 148.02 1.00 m 2.00 m- L FSam Your response is within 10% of the correct value. This may be due to roundoff error, or you could have a mistake your calculation. Carry out all intermediate results to at least four-digit accuracy to minimize roundoff error. N = 253 FJoe N

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

SAQ 1 1.2 m D C 80 kN m An 80-kn.m couple shown in the plate is caused by a pair of parallel forces of magnitude F (not shown). 1.6 m Determine: a) the smallest possible value of F, and b) the value of F if the forces act at points A and C and are parallel to the dashed line shown at A. A В 60°
The pulley system holding a crate of unknown weight is at equilibrium. Cord BD can support a maximum load of FBD = 1860 N. www D 01 A B a. Determine the maximum weight of the crate, W. b. Determine the angle 0₁. Round your final answers to 3 significant digits/figures. ) N W = 0₁ = 12 5 13 degrees
Calculate the mass of object A necessary to balance the beam shown if object B's mass is 40.0Kg, distance X is 4.00 m and distance Y is 8.00m. в A
SAQ 1 1.2 m D C An 80-kn'm couple shown in the plate is caused by a pair of parallel forces of magnitude F (not shown). Determine: 80 kN m a) the smallest possible value of F, and 1.6 m b) the value of F if the forces act at points A and C and are parallel to the dashed line shown at A. A В 60°
Find the resultant of force Y 390 Ib MATHalino.com 12 30 1 1 300 lb 722 Ib Figure P-265
The upper leg muscle (quadriceps) exerts a force of Fo= 1300 N, which is carried by a tendon over the kneecap (the patella) at the angles shown in the figure below. 55 Fo 75° Find the magnitude in newtons and direction in degrees counter-clockwise from an axis directed to the left of the force exerted by the kneecap on the upper leg bone (the femur). magnitude N direction ° counter-clockwise from an axis directed to the left
A manual roller of weight mg = 337.5 N is pushed with a force 182.8N at an angle 0, such that sin(e) = 0.4, with the horizontal direction. What is the force exerted by the floor on the box? F cose F sine mg
500 mm Situation 1. A hand truck is used to move two kegs, each of mass 40 kg. Neglecting the mass of the hand truck, determine (a) the vertical force P that should be applied to the handle to maintain equilibrium when a = 35°, (b) the corresponding 350 min A 80 mm X P reaction at each of the two wheels. В 300 mm
A uniform plank of length 2.00 m and mass 31.0 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 685-N person is d = 0.500 m from the left end. magnitude of IN N magnitude of T magnitude of ₂ N Need Help? L 1₁. T₂C -2.00 m Read It Watch It 40,0⁰
The figure below shows a claw hammer being used to pull a nail out of a horizontal board where 25.9°. The mass of the hammer is 1.00 kg. A force of 175 N is exerted horizontally as shown, and the nail does not yet move relative to the board. Assume the force the hammer exerts on the nail is parallel to the nail. 30.0 cm direction Single point of contact 5.00 cm (a) Find the force exerted by the hammer claws on the nail. 1.5 magnitude What is the net torque acting on the hammer about the point of contact with the surface? kN above the horizontal = Enter a number. (b) Find the force exerted by the surface on the point of contact with the hammer head. Î + Ĵ) N (
MY NOTES ASK YOUR TEACHER A uniform plank of length 2.00 m and mass 27.0 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 690-N person is d = 0,500 m from the left end. magnitude of T, magnitude of T magnitude of Ta 40.0° 2.00 m Submit Answer
The figure below shows a clawhammer as it is being used to pull a nail out of a horizontal board. A force of magnitude 180 N is exerted horizontally as shown. (Assume that the force the hammer exerts on the nail is parallel to the nail and perpendicular to the position vector from the point of contact. The 2.jp x-component of this force's lever arm is 5 cm.) 30.0 cm ymedio locume Single point of contact /30.09 plogy 5.00 cm (a) Find the force exerted by the hammer claws on the nail. (Enter the magnitude.) ter 3 (b) Find the force exerted by the surface at the point of contact with the hammer head. (Assume the positive x-axis is to the right.) magnitude direction o counterclockwise from the +x-axis Need Help? Read It