Tutorials in Introductory Physics
1st Edition
ISBN: 9780130970695
Author: Peter S. Shaffer, Lillian C. McDermott
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 11.5, Problem 2cT
Suppose that the width of both slit, a, were gradually decreased (while keeping the distance between the centers of the slits the same).
Which minima would move as a is decreased?
Choose two or more relative intensity graphs below that illustrate such a change.
(Enlargements of these graphs have also been provided.)
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Green light shines through a 100-μm-diameter hole and is observed on a screen. If the hole diameter is increased by 20%, does the circular spot of light on the screen decrease in diameter, increase in diameter, or stay the same?
Explain.
Match the words in the left column to the appropriate blanks in the sentences on the right.
The wavelets do not interfere
in this case
The diameter of the central
maximum is inversely
proportional to the diameter
of the hole
The diameter of the central
maximum is proportional to
the diameter of the hole
Submit
The hole is too large to
observe the diffraction
increases
decreases
does not change
Request Answer
diameter.
and so the diameter of the spot of light on the screen
Reset
with the hole's
Help
Use the following information for the Gas Identification part of the lab. The data below are angles that might be recorded by a student using a spectrometer to map bright lines in the emission spectrum of some unknown gas. Be sure to record both the gas ID number and the diffraction grating constant (slit spacing) to be used in the analysis.
In the answer field below, convert the first m=1 angle entry above to the corresponding wavelength expressed in nanometres. PLEASE SHOW THE STEPS FOR HOW TO CALCULATE
Solve the following exercises; document each step of the process.
1. Consider a double-slit Young interferometer:
If the initial state is a single-photon coherent state, what is the probability for a counter to clickat the observation screen?
Chapter 11 Solutions
Tutorials in Introductory Physics
Ch. 11.1 - Prob. 1TCh. 11.1 - Prob. 2aTCh. 11.1 - Prob. 2bTCh. 11.1 - Prob. 2cTCh. 11.1 - The representation that we have been using...Ch. 11.1 - Prob. 2eTCh. 11.1 - Prob. 2gTCh. 11.1 - Each of the photographs at right shows a part of a...Ch. 11.1 - Obtain a piece of paper and a transparency with...Ch. 11.2 - Obtain a pan of water and form a barrier in it...
Ch. 11.2 - Prob. 2aTCh. 11.2 - Obtain an enlargement of the diagram at right that...Ch. 11.2 - Suppose that the width of one of the slits were...Ch. 11.2 - Red light from a distant point source is incident...Ch. 11.2 - Compare the situation in part II (in which a...Ch. 11.2 - For each of the lettered points, determine D (in...Ch. 11.2 - Suppose that one of the slits were covered. At...Ch. 11.2 - The pattern produced by red light passing through...Ch. 11.2 - Consider point B, the first maximum to the left of...Ch. 11.3 - Red light from a distant point source is incident...Ch. 11.3 - In a previous homework, you found an expression...Ch. 11.3 - Suppose that the screen were semicircular, as...Ch. 11.3 - Consider a point M on the distant screen where...Ch. 11.3 - Consider a point N on the screen where there is a...Ch. 11.3 - Obtain a set of transparencies of sinusoidal...Ch. 11.3 - Suppose that coherent red light were incident on a...Ch. 11.3 - Generalize your results from the 2-slit, 3-slit,...Ch. 11.3 - Coherent red light is incident on a mask with two...Ch. 11.3 - Prob. 3dTCh. 11.4 - Red light from a distant point source is incident...Ch. 11.4 - Suppose that point X marks the location of the...Ch. 11.4 - Suppose that only slit 1 is uncovered, and all...Ch. 11.4 - Show how you could group all ten slits into five...Ch. 11.4 - Suppose that the number of slits is doubled and...Ch. 11.4 - If we continued to add slits in this way (i.e.,...Ch. 11.4 - How is this pattern different from what you would...Ch. 11.4 - Consider the following dialogue: Student 1: "l...Ch. 11.4 - The photograph at right shows the diffraction...Ch. 11.4 - The photograph at right shows the diffraction...Ch. 11.4 - Describe what you would see on the screen if the...Ch. 11.4 - If a diffraction pattern has several minima (like...Ch. 11.4 - In part A, you drew a diagram that showed how find...Ch. 11.4 - Use the model that we have developed to write an...Ch. 11.5 - The minima that occur in the case of a single slit...Ch. 11.5 - Consider the following dispute between two physics...Ch. 11.5 - A second slit, identical in size to the first, is...Ch. 11.5 - Both slits are now uncovered. For what angles will...Ch. 11.5 - Suppose that the width of both slit, a, were...Ch. 11.5 - Suppose instead that the distance between the...Ch. 11.5 - The four graphs from part C that show relative...Ch. 11.5 - Consider the relative intensity graph shown at...Ch. 11.5 - Consider the following comment made by a student:...Ch. 11.5 - You may have already noticed that the maxima are...Ch. 11.6 - Prob. 1TCh. 11.6 - Prob. 2aTCh. 11.6 - When comparing two materials of different indices...Ch. 11.6 - Consider light incident on a thin soap film, as...Ch. 11.6 - Light of frequency f=7.51014Hz is incident on the...Ch. 11.6 - Suppose that an observer were located on the left...Ch. 11.6 - Observer A is looking at the part of the film that...Ch. 11.6 - Observer B is looking at the part of the film that...Ch. 11.6 - Observer C is looking at the thinnest part of the...Ch. 11.6 - Describe the appearance of the film as a whole.Ch. 11.6 - What are the three smallest film thickness for...Ch. 11.6 - The thickness of the film is 1650 nm at the bottom...Ch. 11.7 - Look at the room lights through one of the...Ch. 11.7 - Hold a second polarizing filter in front of the...Ch. 11.7 - Do the room lights produce polarized light?...Ch. 11.7 - Suppose that you had two marked polarizers (i.e.,...Ch. 11.7 - Suppose that you had a polarizer with its...Ch. 11.7 - Prob. 2dTCh. 11.7 - An observer is looking at a light source through...Ch. 11.7 - Consider a beam of unpolarized light that is...
Additional Science Textbook Solutions
Find more solutions based on key concepts
A wire carrying 1.5 A passes through a 48-mT magnetic field. The wire is perpendicular to the field and makes a...
Essential University Physics: Volume 2 (3rd Edition)
7. (II) (a) A grinding wheel 0.35 m in diameter rotates at 2200 rpm. Calculate its angular velocity in rad/s. (...
Physics: Principles with Applications
The pV-diagram of the Carnot cycle.
Sears And Zemansky's University Physics With Modern Physics
The vectors −v→i , v→f and Δv→=v→f−v→i .
Physics (5th Edition)
Explain all answers clearly, with complete sentences and proper essay structure if needed. An asterisk (*) desi...
The Cosmic Perspective Fundamentals (2nd Edition)
Choose the best answer to etch of the following . Explain your reasoning. 2.Careful study of of community among...
Cosmic Perspective Fundamentals
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- Qualitatively sketch log(Ids) vs. Vg(assume Vds = Vdd) for the following Please pay attention to the positions of the curves relative to each other and label all curves.arrow_forwardSolve the following problems. Show your complete solutions legibly and concisely in the space below each item.arrow_forwardA mobile user who is 200 m from a particular base station has a received signal power of 2 mW. Use the inverse-fourth power relationship to find an approximation for the received signal power for a mobile user who is 800 m from the same base station. Give your answer to 3 significant figures. Show your working to obtain full marksarrow_forward
- In the figure 1 given below, b and c are filtered images of a. Identify the image that is low-pass filtered and the one is high-pass filtered and explain your answer.arrow_forwardSolve the following exercise; document each step of the process.Consider a double-slit Young interferometer: 1) Write down the evolution operator for propagation from the double slits to the observation screen.arrow_forwardOn the diagram below, mark the locations of all minima and principal maxima for the specific case of three identical slits separated by a distance d=2.41. Label each minimum and principal maximum with the corresponding value of FADadj and 0. Semicircular screen N 3 narrow slits (not shown) d = 2.4λ between adjacent slitsarrow_forward
- please reexplain this paragraph two-beam interference with the double exciter:the circular waves generated by the double exciter are super- posed at the points where they meet. The areas with no wave motion indicate cancellation (minima).the minima and maxima are positioned along hyperbolas with the excitation centers as focal points. the relationships given in the section h0rinciples” for the positions of the hyperbolas are confirmed experimentally.The interference patterns are determined by the distance be- tween exciters, and by the wavelength. the number of hyperbo- las increases with the exciter spacing and the wavelength, and the hyperbolas open further.arrow_forwardCircle and correct the statements below that are false about diffraction. Justify your corrections. (a) Diffraction of light is evidence that we can treat light as a particle. (b) For single slit diffraction, constructive interference of light will present as dark spots on screen. (c) For single slit diffraction, as the wavelength of the light decreases, the diffraction pattern shrinks with all fringes getting narrower. (d) When λ/w is large in this scenario [λ >> w], there are little to no effects of diffraction observed. (e) All of the above statements are true.arrow_forwardExplain qualitatively the phenomenon of interference of waves. What are the conditions for maxima and minima?arrow_forward
- For each ray (#1-4) what is the total phase shift of the ray along the path just due to reflection or refraction at the interfaces. (Your answer will either be zero or pi. Don't need to include phase shift differences due to path length differences).arrow_forwardAt what angle do you observe the 4th order maximum relative to the central maximum when 400 nm light is incident normally on two slits separated by 0.025 mm? Also, At what angle do you observe the 3rd order minimum? Set-up is the same as above and with a slit separation of 0.025 mm. Make sure to answer both parts of the question. Show all work.arrow_forwardThe two sources S1 and S2 shown in Fig. emit waves ofthe same wavelength λ and are in phase with each other. Suppose S1 isa weaker source, so that the waves emitted by S1 have half the amplitude of the waves emitted by S2. How would this affect the positions of the antinodal lines and nodal lines? Would there be total reinforcement at points on the antinodal curves? Would there be total cancellation at points on the nodal curves? Explain your answers.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- University Physics Volume 3PhysicsISBN:9781938168185Author:William Moebs, Jeff SannyPublisher:OpenStax
University Physics Volume 3
Physics
ISBN:9781938168185
Author:William Moebs, Jeff Sanny
Publisher:OpenStax
Spectra Interference: Crash Course Physics #40; Author: CrashCourse;https://www.youtube.com/watch?v=-ob7foUzXaY;License: Standard YouTube License, CC-BY