Answered: What would be the maximum weight W of…

What would be the maximum weight W of the block, shown in the following figure, so that the tension developed in any cable does not exceed 900 N: A 30°

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 47P: By how much does a 65.0kg mountain climber stretch her 0.800cm diameter nylon rope when she hangs...

See similar textbooks

Related questions

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

Q: In the figure shown, if the weight of the beam is 300 N. What is the force exerted ?by the beam on…

A: Given data: Weight of the beam = 300 N Need to determine the reaction force in the leg A.

Q: A board is 10ft. long. How high will one end be raised so that the block on it will just begin to…

A: 1. Given:- L= length of the board= 10 ft. μ= coefficient of friction= 0.3 Let the one end be raised…

Q: An 800-N billboard worker stands on a 4.0-m scaffold weighing 500 N and supported by vertical ropes…

Q: Consider the following figure. (a) What force (in N) must be exerted by the wind to support a 2.00…

A: a) The equation to find torque due to weight of the chicken is τ=Fweightrweight=mgrweight Substitute…

Q: After an unfortunate accident occurred at a local warehouse, you were contracted to determine the…

Q: A crane boom is 10 m long and has a mass of 2000 kg. The crane is holding a load of 8000 kg. The…

A: Consider the weight of the crane boom be w, its mass and length be m and l, respectively, the angle…

Q: A person is sitting with one leg outstretched and stationary, so that it makes an angle of 30…

Q: F= 5.2+35 Q5/ Compute the magnitude of force (F) and the vertical reaction at point (A) of…

A: The applied force at the point B is given as, The x and y-components of an applied force are given…

Q: During a walk on a rope, a tightrope walker creates a tension of 3.94 × 103 N in a wire that is…

Q: A 6 m long board is held up at each end by a vertical rope. Assume the board has negligible mass. A…

A: Given: The length of the board is 6 m. The mass of the box is 60 kg. The position of the box is 4 m…

Q: You want to suspend a 2.8 kg 0.8 m long rod in place so that when your brother enters the room it…

Q: Consider the position of the human head and neck shown below, in static equilibrium: FM FJ FM: The…

A: Here position of all the forces are given We are going to calculate the components of all the…

Q: A homogenous block of weight W rests upon the incline as shown in figure below if the coefficient of…

Q: A spring, with a spring constant of 750 N/m, is hung vertically from the ceiling. If a mass of 500…

Q: What factors would affect the elasticity of an object?

A: Required : Factors that affect elasticity.

Q: The center of gravity of the crate is at a height of 3.5ft and a distance 1.5ft from the forward…

Q: a bar of length L is 3m and weight w is 131.7N it is supported at one end by a bolt in a wall and at…

Q: 400 P. IN 6. A 400KN block is resting on a rough horizontal surface for which the coefficient of…

A: given weight of block W = 400 KN coefficient of friction μ = 0.04

Q: From the step ladder shown in the figure, sides AC and CE are each 2.44 m long and hinged at point…

Q: For a body of mass "m" on a rough inclined plane with a constant but arbitrary coefficient of…

Q: 600 mm C. 3 kN 2 kN 350 mm 350 mm

Q: A ladder of length L and negligible weight leans against a frictionless vertical wall making an…

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

Q: In the figure the blocks are initially at rest, so that the system is in equilibrium assuming that…

A: Given masses are, m=2 kgM==15 kg The inclination is θ=60°.

Q: A block with a mass of 0.350kg is placed on a rough planar surface that is inclined 30° above the…

A: The mass of the block, m=0.350 kg The angle of inclination, θ=30° The coefficient of static…

Q: 300 kN 50 kN 180 kN 90 kN 60°

Q: A block of wood with mass 1kg is clamped to a vertical board with a force of 10N. What is the…

A: Draw the free-body diagram of the block.

Q: In rolling, if the maximum draft is 13 mm, & the coefficient of friction is 0.3, thus the minimum…

A: As per bartleby guideline for more than one question asked only first is to be answered please…

Q: After an unfortunate accident occurred at a local warehouse, you were contracted to determine the…

Q: Why Does A Cyclist Lean To One Side, While Going Along A Curve? In What Direction Does He Lean?

A: The cyclist bends slightly inwards while going on a curved road because by doing that the cyclist is…

Q: The 60-lb collar A can slide on the frictionless vertical rod and it is connected to a 65-lb…

Q: A person’s weight is 438 N is standing on a level floor and have a center of gravity that is 1.28 m…

A: Given data: Weight of the person, Wp=438 N Center of gravity of person, Xp=1.28 m Weight of his…

Q: A 90-m wire is suspended between two points at the same elevation that are 60 m apart. Knowing that…

A: (a) Draw the free-body diagram for the half span.

Q: A meter stick is supported by a knife-edge at the 50-cm mark. Doug hangs masses of 0.40 and 0.60 kg…

Q: An elastic rope is stretched between the tops of two identical posts. A man is to walk along the…

Q: A meter stick is supported by a knife-edge at the 50-cm mark. You hang masses of 0.40 kg and 0.60 kg…

Q: A force of 39 lb is required to hold a 62 lb toolbox on an incline. What angle does the incline make…

Q: After an unfortunate accident occurred at a local warehouse, you were contracted to determine the…

Q: against the wall, where it is held by friction as shown in the figure below. The coefficient of…

Q: In the figure, a thin horizontal bar AB of negligible weight and length L = 2.4 m is hinged to a…

A: Given : L = 2.4 m θ = 41° W = 250 N x = 1.51 m

Q: cm from the elbow, and the biceps muscle can supply a maximum force of 775. N (with the forearm in a…

A: Given:- The forearm has a mass of 5.00 kg. The distance from the elbow to the hand is 34 cm. If the…

Q: The upper end of a wide-skid W 8 × 21 steel column (E = 30 × 103 ksi) is supported laterally between…

A: Write the given values of the problem- E=30x103 ksi W 8X21 L=13 ft

Q: As shown in the figure below, a uniform beam is supported by a cable at one end and the force of…

A: Let the tention in the string be T. T will have two components, one upward (Tsinθ) and another…

Q: bridge, with L, consists of a weight neld up one suppor and a second support 80% of the way across…

Q: After an unfortunate accident occurred at a local warehouse, you were contracted to determine the…

A: Given,mass of steel beam, λ = 81.70 kg per metertension in the cable, T = 12170 Nmaximum load, m =…

Concept explainers

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics.

Equilibrium of Forces

The tension created on one body during push or pull is known as force.

Question

... M
VoMiFi
What would be the maximum weight W of the block, shown in the following figure, so that
the tension developed in any cable does not exceed 900 N:
A
30°
II

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Can compress stress be applied to a rubber band?
A suspender rod of a suspension bridge is 25.0 m long. If the rod is made of steel, what must its diameter be so that it does not stretch more than 1.0 cm when a 2.5104kg tuck passes by it? Assume that the rod supports all of the weight of the truck.
By how much does a 65.0kg mountain climber stretch her 0.800cm diameter nylon rope when she hangs 35.0m below a rock outcropping? (For nylon, Y=1.35109Pa. )
A copper wire is 1.0 m long and it diameter is 1.0 mm. if the wire hangs vertically how much weight must be added to its free end in order to stretch it 3.0mm?
The boom of the wall crane 4m long is held at right angles to the wall by a wire that is attached to the wall 3m above the foot of the boom. If the load lifted is 45000N, find the tension in the wire and the compression force in the boom. Neglect the weight of the boom. Don't forget to draw an illustration.
A pair of wedges is used to lift a crate as shown in The crate weighs 4000 lb, the wedge angle e is Fig. 18°, and the coefficient of friction is 0.15 at all surfaces. The weight of the wedges is negligible. Determine The force P necessary to remove the wedge or to pre- vent the wedge from slipping out W
A 25-ft chain with a weight of 30 lb is suspended between two points at the same elevation. Knowing that the sag is 10 ft, determine (a) the distance between the supports, (b) the maximum tension in the chain.
A leg has 1.4 m shaft of bone with an average cross sectional area of 3x10-4 m². What is the amount of shortening when all of the body weight of 800 N is supported on this leg assuming young modulus = 1.8x1010 N/m.? O 0.15 mm O 3.0 m O 0.43 mm O 0.21 mm
The following forces are acting on the bracket below. The bracket has a width w of 2 inches and a height h of 3 inches. The bracket is in equilibrium (not accelerating). Determine F3y knowing F1x-98 lbf and F1y=195 lbf. For this question, what is F3.y in Ibf? Note that the y- direction is pointing up, so if the force is pushing down on the bracket, it has a negative magnitude. 39
a steel wire of diameter 1mm can support a tension of 0.2kN. a cable to support of 20kN should have diameter of what order of magnitude?
A 29.0 m long aluminum cable with a cross-sectional area of 2.01 x 103 m² is used to suspend a 3.20 x 10° kg container. By how much will the cable stretch (in m) once bearing the load? (Young's modulus for aluminum is Y = 7.0 x 1010 Pa.) HINT m Need Help? Read It Watch It
Bone has a Young’s modulus of 18 x 109 Pa. Under compression, it can withstand a stress of about 160 x 106 Pa before breaking. Assume that a femur (thigh bone) is 0.50 m long, and calculate the amount of compression this bone can withstand before breaking.