Answered: RLC circuit with AC power supply, find…

Science

Physics

RLC circuit with AC power supply, find reactance for C

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 64P: What is the self-inductance of an LC circuit that oscillates at 60 Hz 1ien the capacitance is 10 F ?

See similar textbooks

Related questions

Q: The maximum Current in 0,19H inductor connecled an AC ge nera ler with a frequency To of 68 4z is…

A: Inductance (L) = 0.18 Henry Frequency (f) = 68 Hz MAximum current (i) = 0.18 A

Q: Write your understanding on resonance condition for an RLC circuit. What are the reactance's for a…

A: In RLC circuit, Resonance is the condition where the value of inductive reactance is equal to the…

Q: at is the new impedance of this circuit? at is the new current flowing out of the age source? d) How…

A: The solution can be given as follows :-

Q: series RL Circuit

Q: onside snown below) consisting Voltage source: V(t)=Vosin(wt) connected in series to a capacitor C…

Q: Calculate the impedance and admittance of the Branch AB and CD of the circuit shown in Figure 6.…

A: When the steady current flows through the circuit, the resistance gives the measure of the…

Q: Find the impedance of a a circuit that consist of a 252 Ohm resistor and a 9 mH inductor and runs at…

Q: An AC current in a 10 ohm resistance produces thermal energy at the rate of 360W. Determine the…

A: Given data: The resistance, R=10 Ω. The average power, P=360 W. The average power in an…

Q: i resistor R, inductor L, and capacitor C are all connected in parallel to an AC source of EFM. What…

A: Given data: The RLC circuit is arranged in parallel manner. To calculate : maximum current To draw:…

Q: Give any four characteristics of series RLC circuit at resonance.

A: RLC circuit = It is an electric circuit that consists of Resistance(R), Inductor(L), and…

Q: PI EXPlain The effect of increasing The filter Capacitance on The outPut Voltage in The half - wave…

A: To explain: The effect of increasing the filter Capacitance on the output voltage in half wave…

Q: A single phase 208V AC control power to R=4 2 load if the desired output power is 3 KW, determine…

A: Given data: The voltage supplied, V=208 V. The load resistance, R=4 Ω. The desired output power,…

Q: Obtain the resonant frequency ca, of a series LCR circuit with L = 2.0 H C = 32 micro F and R = 10…

A: Given that - Inductance Capacitance Resistance To Find - We have to determine the Q value of the…

Q: Give any four characteristics of series L-C-R circuit at resonance.

Q: Identify the first step of mesh analysis a. Kirchhoff's KVL is implemented for every loop O b.…

A: According to question we need to find that which option is correct.

Q: Consider the following circuit 402 ww +1.5V 60 ww +3V 302 ww Calculate the current in the left loop,…

A: Emf of cell in left loop is V1 = 1.5 V Emf of cell in the right loop is V2 = 3 V

Q: A series circuit has a capacitor of - Farad, a resistor of 3 Ohms and an inductor of 1 Henry. If the…

A: we have following data as given in question Resistance of resistor R = 3 ohm Capacitance of…

Q: If cross sectional area of the coil increases, then the inductance value

A: Given cross section area of coil is increased

Q: LC-Circuit. This is an RLC-circuit with negligibly small R (analog of an undamped mass-spring…

A: We have a L-C circuit with L=0.5 H and C=0.005 F and AC voltage E(t)=sin(t) V. We need to find the…

Q: If the response is overdamped, calculate s1 and s2 using the equationsin Table 8.3;

A: Note the formulas given in the table as follows: α=12RCω0=1LCs1=-α+α2-ω02s2=-α-α2-ω02 Here, α…

Q: Electrosurgical units (ESUs) supply high - frequencyelectricity from resonant RLC circuits to cut,…

A: (a)Write the expression for resonant frequency.

Q: An RLC series circuit has a 1.00 kΩ resistor, a 150 μH inductor, and a 25.0 nF capacitor. Find the…

A: Resistance, R = 1 kΩ Inductance, L = 150 μH capacitance C = 25 nF frequency, f =500 Hz

Q: ohms - f (Hz) The graph of reactance against frequency, shown in the picture is for a impedance of…

A: shows a graph of inductive reactance against frequency for a particular value of inductance, with XL…

Q: mH A charged 30 uF capacitor inductor. What is the angular frequency of free oscillations of the…

A: The angular frequency refers to the angular displacement of any wave element per unit of time or the…

Q: In a series RLC circuit, at resonance, voltage leads the current. Select one: O True False

A: Answer-False

Q: What is the impedance of a series RLC circuit at resonance?(a) XL (b) XC (c) R (d) XL - XC (e) 0

A: Write the equation for resonance of RLC circuit

Q: I am doing a lab about Analysis of AC circuits and am not sure about this activiy. How do we…

A: In a pure ohmic resistor the voltage waveforms are “in-phase” with the current. In a pure inductance…

Q: A series RL circuit has a 1 k ohm resistor and a 5 mH inductor. What is the time constant for the…

Q: An ideal neon sign transformer provides 9 250 V at 30.0 mAwith an input voltage of 115 V. Calculate…

A: (a) For an ideal transformer, the power input equals the power output. The input power of the…

Q: A coil of self-inductance L is connected in series with a bulb B and an AC source. Brightness of the…

Q: An RLC series circuit has a 45.0 Ohm resistor, a 75.0-uH (micro-Henry) inductor, and an 45.0-uF…

A: Given data The resistance is R=45.0 Ω The inductance is L=75.0 μH The capacitance is, C=45.0 μF The…

Q: Draw a circuit diagram for a series circuit containing a R = 100-ohm resistance, a coil with L = 0.1…

Q: i) List any two uses of RLC circuits.

Q: Using the loop rule, derive the differential equation for an LC circuit

A: The LC circuit is shown as, Initially, capacitor was charged, and the i=stored in it was Q0. As we…

Q: Q3) an LRC circuit is set up with an inductance of 1/5 henry, a resistance of 1 ohm, and a…

A: In the given LRC circuit, given that the value of inductance and capacitance and resistance and also…

Q: In an A.C circuit, if the phase difference (φ) is zero, then power dissipation will be maximum.…

A: Power dissipation in AC circuit is P=Vrms.Irms Cos(φ) where φ=phase difference between current and…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

RLC circuit with AC power supply, find reactance for C

Expert Solution

Step 1

V_c = IX_c that is the voltage across capacitor C and it lags the current I by an angle of 90 degrees.When XL < XC, the phase angle ϕ is negative, and the circuit acts as a series RC circuit in which the current leads the voltage by 90 degrees.

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

What is the self-inductance of an LC circuit that oscillates at 60 Hz 1ien the capacitance is 10 F ?
Check Your Understanding Show that the tins voltages across a resistor, a capacitor, and an inductor in an ac circuit where the tins current is Irmsare given by IrmsR,IrmsXC , and IrmsXL, respectively. Determine these values for the components of the RLC circuit of Equation 15.12. Pave=12t0v0cos (15.12)
Check Your Understanding Find the voltages across the resistor, the capacitor, and the inductor in the circuit of Figure 15.11using v(t)=v0sint asthe output of the ac generator.
Check Your Understanding The resonant angular frequency of an RLC series circuit is 4.0102 rad/s. An ac source operating at this frequency transfers an average power of 2.0102W to the circuit. The resistance of the circuit Is 0.50 Q. Write an expression for the emf of the source.
Check Your Understanding A transformer steps the line voltage down from 110 to 9.0 V so that a current of 0.50 A can be delivered to a doorbell (a) What is the ratio of the number of turns in the primary and secondary windings? (b) What is the current in the primary winding? (c) What is the resistance seen by the 110-V source?
The current in the RL circuit shown here increases to 40% of its steady-state value in 2.0 s. What is the time constant of the circuit?
The resonant frequency of RLC series circuits is 2.0103Hz , If the self-inductance in the circuit is 5.0 mH, what is the capacitance in the circuit?
Check Your Understanding The angular frequency of the oscillations in an LC circuit is 2.0103rad/s . (a) If L = 0.10H, what is C? (b) Suppose that at t = 0, all the is stored in the inductor. What is the value of ? (c) A second identical capacitor is connected in parallel with the original capacitor. What is the angular frequency of this circuit?
At what time is the voltage across the inductor of the RL circuit of Figure 14.12(b) a maximum?
The average ac current delivered to a circuit is zero. Despite this, power is dissipated in the circuit. Explain.
Check Your Understanding If a European ac voltage source is considered, what is the time difference between the zero crossings on an ac voltage-versus-time graph?
What is the resistance R in the circuit shown below if the amplitude of the ac through the inductor is 4.24 A?