i)List any two uses of RLC circuits.ii) A coil of inductance 40 mH, resistor of resistance 300 Q and a capacitor of capacitance|19.9 µF are connected in series with a 80 Hz AC source that gives 330 V peak voltage.Estimate:(a) impedance,(b) maximum current in the circuit,(c) average power dissipated in the circuit.

Answered: Image /qna-images/answer/ddbfb157-e9f4-4c1a-99c2-66d2fd73b6ab.jpg

Answered: i) List any two uses of RLC circuits.

Science

Physics

i) List any two uses of RLC circuits.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter21: Alternating-Current Circuits And Electromagnetic Waves

Section: Chapter Questions

Problem 19P: A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits...

See similar textbooks

Related questions

Q: The electricity supplied through a city power line is transmitted at 14,300 V. On each city block…

A: Given Primary voltage, V1 = 14300 V Secondary voltage, V2= 120 V No of turns in primary coil, N1…

Q: Problem 4: The plug-in transformer for a laptop computer puts out 7.50 V and can supply a maximum…

A: Given Output voltage (Vo) = 7.50 V Input voltage (Vi) = 240 V Maximum output current (Io) = 2.2 A…

Q: (II) Determine (a) the maximum instantaneous power dissipated by a 2.2-hp pump connected to a 240…

Q: Snow White has just baked a pie. Its temperature is initially 248 degrees Celsius. The room temp is…

A: Hi there! Since there are multiple questions posted and it is not mentioned what is to be answered,…

Q: The plug-in transformer for a laptop computer puts out 7.20 V and can supply a maximum current of…

Q: At very low frequencies a series R-C circuit behaves as almost purely a. capacitive O b. none of…

A: Impedance of RC AC circuit is given by: Z = sqrt (R^2 + (XL - Xc)^2) Since R = 0, So Z = sqrt (0^2 +…

Q: 1. Derive the expression for the frequency of a LC circuit.

Q: 17) For an LRC series circuit containing a resistance of 11.0-22, a capacitance of 2.0-µF, and an…

Q: 1. Refer to the series RLC circuit below, calculate the following: a. Impedance b. Resonant…

A: Given Resistance R = 12 ohm Inductance L = 0.15 H Capacitance C = 100 uF = 100 × 10-6 F frequency…

Q: 47. (II) (a) What is the maximum instantaneous power dissi- pated by a 3.0-hp pump connected to a…

A: Power rating of pump = 3 Hp Vrms = 240 Volts

Q: When a wire is connected between the two ends of a solenoid, the resulting circuit can oscillate…

Q: (II) A 3.5 kΩ resistor and a 3.0μ F capacitor are connectedin series to an ac source. Calculate the…

A: Given quantities: Resistance (R) = 3.5 kilo ohm capacitance (C) = 3.0 micro Farad Let, the impedance…

Q: List any two applications of A. C. Circuit.

A: When a circuit is excited using an alternating source instead of direct current, then this type of…

Q: circuits

A: Ohm's law is one of the fundamental relationships that is found in maximum electronic circuits.…

Q: Calculate the peak voltage of a generator that rotates its 220–turn, 0.100 m diameter coil

Q: Consider the RLC series circuit with a peak voltage of 40 V, f = 60 Hz, R = 10 Q, L = 1.2 mH, C =…

Q: (II) Determine the resistance of a coil if its impedance is 235Ω and its reactance is 115Ω

A: The resistance, impedance and reactance are related as Z2=R2+X2

Q: 22) Determine the, , (rms), of a half-wave rectifier circuit connected to 1 KO. 1:1 230 V V ip :1 K

A: Primary to secondary turns is: N1/N2= 1 RMS primary voltage =…

Q: 1. What do you mean by emf and what are the factors affecting emf?

A: Since you have mentioned multiple questions and did not specify any number, I will be solving the…

Q: (III) Design a dc transmission line that can transmit 925 MWof electricity 185 km with only a 2.5%…

A: The power, P=925 MW=925×106 W The length, l=2×185 km×1000 m1 km=3.7×105 m The voltage, V=660 kV

Q: The current in the RL circuit shown below reaches half its maximum value in 0.5 ms after the switch…

Q: . When electric lights are operated on low-frequency ac (say,5 Hz), they flicker noticeably. Why?

A: The formula for measuring the time period is given as the reciprocal of the frequency. If the…

Q: Is this circuit capacitive or inductive? Give two reasons.

A: Given:- A circuit is given above in the figure The R, C, and L are in the series. Find:- Is the…

Q: 4. If the resistance of an RLC circuit is doubled, but inductance and capacitance do not change, the…

A: In this problem, it is asking about the resonance frequency, when the resistance of a RLC circuit is…

Q: In an A.C circuit, if the phase difference () is -35°, then it it will be an RL circuit. Select one:…

Q: Consider the RLC series circuit with a peak voltage of 40 V, f = 60 Hz, R = 10 Q, L = 1.2 mH, C =…

A: Given data: A RLC series circuit L = 1.2 mH = 1.2×10-3 H C = 300 μF = 300×10-6 F Required: The…

Q: The expression for current in a RL circuit is I=I0(1-exp(-t/T)). Derive an expression for current in…

Q: Suppose you want to increase the time constant of an RL circuit. How might you do that? Increase R…

Q: 20. Consider the voltage phasor diagram of an AC circuit shown below. What is the value of the…

A: Given that Io= 5A ωt=60 To determine that what is value of voltage at that instant?

Q: A plug-in transformer, as shown, supplies 9.00 V to a video game system. (a) How many turns are…

A: a. the number of turns in the secondary coil can be calculated from the transformer equation.

Q: 11 - Four resistors, one uncharged capacitor and two inductors are arranged as shown in the figure.…

A: Just after the switch is closed. Capacitor will behave as a wire And, Inductor will behave as open…

Q: 6. Give one condition for resonance to occur in a series RLC circuit.

Q: (II) The peak value of an alternating current in a 1500-Wdevice is 6.4 A. What is the rms voltage…

A: The power dissipated in AC source is, Pavg=IrmsVrms ...... (1) The rms…

Q: 28b) When load current increases, the terminal voltage of DC shunt Generator is reduced. Justify

Q: 23. Consider an LC circuit-that is, an RLC circuit with R = 0-with input voltage E(t) = Eo sin wt.…

Q: Explain how the relative phase between voltage and current is given for an RLC circuit?

Q: The current in the RL circuit shown below reaches one- fourth its maximum value in 2.75 ms after the…

Q: In an RLC circuit, the resistance R does NOT change with frequency. Why would VR change with…

Q: An ideal transformer produces an output voltage that is 500% larger (e.g. a 6-fold increase) than…

A: Ratio of output voltage to input voltage = 6 VoutVinp = 6 Input rms current (Iinprms) = 13 A

Q: In an A.C circuit, if the phase difference (φ) is zero, then power dissipation will be maximum.…

A: Power dissipation in AC circuit is P=Vrms.Irms Cos(φ) where φ=phase difference between current and…

Q: Sketch the current in an RL circuit over time.

A: Fig(a) An RL circuit with a switch to turn current on and off. When in position 1, the resistor,…

Question

i)
List any two uses of RLC circuits.
ii) A coil of inductance 40 mH, resistor of resistance 300 Q and a capacitor of capacitance
|19.9 µF are connected in series with a 80 Hz AC source that gives 330 V peak voltage.
Estimate:
(a) impedance,
(b) maximum current in the circuit,
(c) average power dissipated in the circuit.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
A series RLCcircuit contains a 20.0- resistor, a 0.750-F capacitor, and a 120-mH inductor. (i) 11 a sinusoidally varying rms voltage of 120 V at f = 500 Hz is applied across this combination of elements, what is the rms current in the circuit? (a) 2.33 A (b) 6.00 A (c) 10.0 A (d) 17.0 A (e) none of those answers (ii) What If? W hat is the rms current in the circuit when operating at its resonance frequency? Choose from the same possibilities as in part (i).
An RLC series circuit hag a 1.00 k(register, a 150 (H inductor, and a 25.0 nF capacitor. (a) Find the circuit’s impedance at 500 Hz. (b) Find the circuit’s impedance at 7.50 kHz. (c) It the voltage source has Vrms = 408 V, what is Irms at each frequency? (d) What is the resonant frequency of the circuit? (e) What is Irms at resonance?
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
An RLC series circuit consists of a 10 resistor, an 8.0F capacitor, and a 50-mH inductor. A 110-V (rms) source of variable frequency is connected across the combination. What is the power output of the source when its frequency is set to one-half the resonant frequency of the circuit?
A 1.5k resistor and 30-mH inductor are connected in series, as below, across a120-V(rms)ac power source oscillating at 60-Hz frequency. (a) Find the current in the circuit. (b) Find the voltage drops across the resistor and inductor. (C) Find the impedance of the circuit. (d) Find the power dissipated in the resistor. (e) Find the power dissipated in the inductor. (1) Find the power produced by the source.
In a series RLC circuit with a maximum current of 0.250 A, an AC source with Vmax= 115 V operating at 60.0 Hz is connected to a 325-mH inductor, a 7.50-F capacitor, and a resistor with unknown resistance R. Draw a phasor diagram for this circuit, including the current, the potential difference across each of the circuit elements, and the source emf. Draw your diagram with the current phasor pointing upward along the vertical axis.
A 60.0-ft resistor is connected in series with a 30.0-F capacitor and a source whose maximum voltage is 120 V, operating at 60.0 Hz. Find (a) the capacitive reactance of the circuit, (b) the impedance of the circuit, and (c) the maximum current in the circuit. (d) Does the voltage lead or lag the current? (e) How will adding an inductor in series with the existing resistor and capacitor affect the current? Explain.
A 20-mH inductor is connected across an AC source with a variable frequency and a constant-voltage amplitude of 9.0 V. (a) Determine the reactance of the circuit and the maximum current through the inductor when the frequency Is set at 20 kHz. (b) Do the same calculations for a frequency of 60 Hz.