ladder 4m long is leaning against a frictionless wall with its lower end 1.6m away from the wall. If the ladder weighs 150N, what forces does it exert on the wall F1 and on the ground F2? Show complete solution including FBD.

ladder 4m long is leaning against a frictionless wall with its lower end 1.6m away from the wall. If the ladder weighs 150N, what forces does it exert on the wall F1 and on the ground F2? Show complete solution including FBD.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter4: Newton's Laws Of Motion

Section: Chapter Questions

Problem 91AP: The board sandwiched between two other boards in Figure P4.91 weighs 95.5 N. If the coefficient of...

See similar textbooks

Related questions

Q: why should the center weight be less than the sum of the left and right weights?

A: An object is considered to be in a condition of equilibrium when all of the forces acting on it are…

Q: Could a ladder on a level floor lean against a wall in static equilibrium if there were no friction…

Q: How much compression acts on the hip during two-legged standing, given that the joint supports 250 N…

A: Looking at the components Rcosα=Fmcos70=600cos70Rsinα=mg+Fmsin70=250+600sin70

Q: An 800-N billboard worker stands on a 4.0-m scaffold weighing 500 N and supported by vertical ropes…

Q: The leg and cast in the figure below weigh 258 N (w, ). Determine the weight w, and the angle a…

A: The free body diagram,

Q: A light board that is 14 m long is supported by two sawhorses, one at one end of the board and a…

Q: C D 35.0° 77.0° 45.0 kg

Q: A 12m long post is bolted to the wall on its left end. It's right end is held horizontal by a wire…

A: GivenLength of post L = 12 mMass of post m = 13 kgAngle Ѳ =35

Q: The horizontal boom supporting a lamp is of uniform construction and weighs 50 N. If the lamp…

Q: Three forces F, = 20 N, F, = 10 N and F, = 5.0 N act on the structure shown in fi fourth force F4 to…

A: Analyzing the horizontal forces (which add tozero) we find Fh = F3 = 5.0 N. Equilibrium of vertical…

Q: F= 5.2+35 Q5/ Compute the magnitude of force (F) and the vertical reaction at point (A) of…

A: The applied force at the point B is given as, The x and y-components of an applied force are given…

Q: A window washer stands on a uniform plank of mass 125 kg and length 7m supported by a rope attached…

A: 4018 N

Q: A 3.0 m-long weightless beam is supported at each end by cables. A painter weighing 900 N stands 1.0…

Q: The box B weighs 50 lb. The coefficients of friction between the cable and the fixed round supports…

A: To solve this problem we will use the concept of friction. First we will use free body diagrams to…

Q: A massless, 6.00 m long beam is held fixed horizontally between a triangular support and a rope at…

Q: A window washer is standing on a scaffold supported by a vertical rope at each end. The scaffold…

A: Given : Weight of scaffold (w1) = 206 N Length (L) = 3.5 m Weight of worker (w2) = 698 N Distance…

Q: The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces…

A: Given data: The forces on beam has shown in the diagram. Upward force F1 = 1.95 kN Angle for upward…

Q: P= 800 N Aa 8 m T= 600 N B 6 m C 60% D y I L--x

A: Given:- A diagram is given as Find:- Combine the two forces P and T, which act on the fixed…

Q: A 3 m long weightless beam is supported at each end by cables. A painter weighing 900 N stands 1 m…

A: Given data: Length of beam is, L=3 m. Weight of painter is, Wp=900 N. Distance of painter from left…

Q: How far would the worker stand from one of the supporting ropes

A: Given data: The weight of the billboard worker is: W = 650 N The length of scaffold is: L= 4.05…

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

Q: 2.30 m long and has a mass m = 15.0 kg. It leans at rest against a smooth wall making an angle 0 =…

Q: Write the two equations of equilibrium, Fx = 0and Fy 0. 600N 60 (a) 200 N 105 60 F (b)

Q: A 80-kg block is suspended as shown. The beam is weightless and is hinged to the wall at A. The…

Q: Where must a 500 N weight be hung on a uniform 150 N pole with a length of 5 m so that a girl at one…

A: The diagram is given below that shows the above situation. The force applied by the girl is given…

Q: A 160-N child sits on a light swing and is pulled back and held with a horizontal force of 120 N.The…

A: The components of tension can be written as

Q: A uniform picute frane weighing 10.0 N is supported as shown in the image, where the right side…

Q: What is the tension force present on the string attached to the ceiling making an angle of 34° if a…

Q: A 12m long post is bolted to the wall on its left end. It's right end is held horizontal by a wire…

A: Draw the schematic diagram of the arrangement.

Q: a ladder 4m long is leaning against a frictionless wall with its lower end 1.6m away from the wall.…

Q: Calixta whose mass is 60 kg stands 1.5 m away from one end of a uniform 6.0-m-long plank of mass…

Q: A person is standing on a section of uniform scaffolding as shown has a ms = 22.0 kg mass and is…

A: A person is standing on a section of uniform scaffolding as shown in the figure. The section of…

Q: You have been tasked with retrieving a crate from a 4-m long beam that is suspended by two cables,…

A: Given Data: The length of the beam is: l=4 m The distance of the person from the left end of the…

Q: A window washer is standing on a scaffold supported by avertical rope at each end. The scaffold…

Q: A window washer is standing on a scaffold supported by a vertical rope at each end. The scaffold…

Q: Scientists have studied how snakes grip and climb ropes. In one study, they found that an important…

Q: The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces…

A: Equivalent moment An equivalent moment is equal to the sum of the moments acting about a point and…

Q: A uniform beam of length 1.0 m and mass 10 kg is attached to a wall by a cable as shown. What is…

Q: Find the tension in the two cords shown in the figure. Neglect the mass of the cords and assume that…

Q: The leg and cast in the figure below weigh 374 N (w,). Determine the weight w, and the angle a…

A: Given : Weight of leg plus cast, w1 = 374 N

Q: A cubic crate of side s= 2.0 m is top-heavy: its CG is 18 cm above its true center. How steep an…

A: given cube side length (s) = 2m.g. is 18 cm

Q: A bag of cement weighing 525 N hangs in equilibrium from three wires as suggested in the figure…

A: The weight of the cement bag is 525N. The tension T3 will be equal to the weight of the cement bag.

Q: A scaffold of mass 47 kg and length 5.0 m is supported in a horizontal position by a vertical cable…

A: Given:- A mass m1 = 47 kg length L = 5.0 m is supported in a horizontal position by a vertical…

Q: .Six equal rods AB, BC, CD, DE, FE and FA are each of weight W and are freely jointed at there…

Q: 8. A 20 kg uniform beam 10m long is attached to a wall with a cable. The cable is attached to the…

Q: y T F, F, An object is subjected to three forces as shown in the figure. Assume F1 = 80.0 N and F2 =…

A: Given The force F1 is F1=80 N. The force F2 is F2=95 N. From the given diagram, The tension in…

Q: The two structural members, one of which is in tension and the other in compression, exert the…

A: We have two forces F1=4.2 kN which makes an angle of 63o with the +x axis directed inwards and…

Q: The fgure below shos abeam of untum density wth amass of 35Sg and alengtht . issupended from a catle…

A: Given data- mass of beam m=35.5 kg length l=5.95 m, distance d=1.20 m

Q: Consider the person lifting a heavy box with his back, shown in Figure,The mass of the upper body is…

Question

A ladder 4m long is leaning against a frictionless wall with its lower end 1.6m away from the wall. If the ladder weighs 150N, what forces does it exert on the wall F1 and on the ground F2?

Show complete solution including FBD.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

A 20.0-kg horizontal plank 4.00 in long rests on two supports, one at the left end and a second 1.00 m from the right end. What is the magnitude of the force exerted on the plank by the support near the right end? (a) 32.0 N (b) 45.2 N (c) 112 N (d) 131 N (e) 98.2 N
The board sandwiched between two other boards in Figure P4.91 weighs 95.5 N. If the coefficient of friction between the boards is 0.663, what must be the magnitude of the compression forces (assumed to be horizontal) acting on both sides of the center board to keep it from slipping? Figure P4.91
A ladder 4m long is leaning against a frictionless wall with its lower end 1.6m away from the wall. If the ladder weighs 150N, what forces does it exert on the wall F1 and on the ground F2?
a ladder 4m long is leaning against a frictionless wall with its lower end 1.6m away from the wall. if the ladder weighs 150n, what forcesdoes it exert on the wall F1 and on the ground F2? show step by step solution with fbd
A 25-kg ladder, 4 m long, rests on a rough floor and against a vertical wall. The ladder makes an angle of 35° with the horizontal. It starts to slip when a man weighing 75 kg has dlimbed halfway up. f= 0.20 at the wall. Ladder Wall 350 10) What is the coefficient of friction at the floor in three decimal places?
A 5 kg beam 2 meters long is used to support a 10 kg sign by means of a cable attached to a building. The signs hangs from the end of the 2 m long beam, and the cable makes a 40 degree angle with the beam. What is the tension in the cable?
A 3.0-mm -long ladder, leans against a frictionless wall. The coefficient of static friction between the ladder and the floor is 0.50. What is the minimum angle the ladder can make with the floor without slipping?
A ladder 7.50 m long is leaning against a smooth (frictionless) wall at a point 7.0 m above the ground. The ladder weighs 200 N and an 800-N painter stands two-thirds of the way up the ladder. What frictional force must act on the bottom of the ladder to prevent it from slipping for the painter to be safe? Kindly show a complete solution including the free body diagram. Thank you!
F, y mg AF f.y F, fx e Axis The ladder in the picture has a mass of 39 kilograms and a length 3 meters. What is the normal force pushing the ladder up from the floor? This force is labeled Ff y in the picture. FN N. %D Assume that the ladder's weight is evenly distributed, so it can be treated as a single force through the middle. If the ladder is at a 69° angle from the ground, what is the torque exerted by the weight (using the floor as the pivot point)? N.m The torque from the ladder must be balanced by the torque caused by the normal force on the wall, labeled Fw in the picture. Calculate this force. Fw - N. The normal force from the wall must be balanced by the friction force from the floor, labeled Ff x.in the picture. Determine the minimum coefficient of friction to keep the
A window washer is standing on a scaffold supported by avertical rope at each end. The scaffold weighs 200 N and is3.00 m long. What is the tension in each rope when the 700-Nworker stands 1.00 m from one end?
A 500-N tightrope walker stands at the center of the rope. If the rope can withstand a tension of 1800 N without breaking, what is the minimum angle the rope can make with the horizontal?
A uniform horizontal beam with a length of 8 m and a weight of 200 N is attached to a wall by a pin connection. Its far end is supported by a cable that makes an angle of 53° with the beam. If a 600-N person stands 2 m from the wall. What is the tension in the cable? 53.0% 8.00 m O A. 502 N O B. 410 N O C. 196 N D. None O E. 313 N