Answered: A grating has 3800 slits per cm. It…

A grating has 3800 slits per cm. It produces a second order bright fringe at a 22 degree angle. What wavelength of light is being used?

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter4: Diffraction

Section: Chapter Questions

Problem 114AP: If a diffraction grating produces a first-order maximum for the shortest wavelength of visible light...

See similar textbooks

Related questions

Q: The Velocity Selector In experiments where all the charged particles in a beam are required to have…

Q: Find the mass m of the counterweight needed to balance a truck with mass M = 1 360 kg truck on an…

A: The mass of the vehicle is The angle of inclination is Find:Mass of the object.

Q: ou want to hang a 9.60 kg picture on the wall. If the wire used to hang the picture will break if…

Q: Two parallel plates are separated by 3 cm. They are connected to a 1200 V power supply. A 20 nC…

A: The objective of the question is to calculate the electrostatic force on a charge placed between two…

Q: A hollow, spherical shell with mass 3.00 kg rolls without slipping down a 36.0 ∘slope. Find the…

A: (a) 3.456 m/s⁠⁠⁠⁠⁠⁠⁠2 (b) 6.91 N (c) 0.29Explanation:

Q: Determine the maximum angle θ for which the light rays incident on the end of the pipe in the figure…

A: The required maximum incident angle is 67.190Explanation:

Q: Q8. Show the resultant of the two waves Yi A sin [wt-k(x+Ax)] Y2= A sin (W y=2Acos (kAx/2) sin…

Q: A dump truck uses a hydraulic cylinder, as the drawing illustrates. When activated by the operator,…

A: Write the provided data.Here, Pabs is the absolute presssure, Patm is the atmospheric pressure, r is…

Q: 17. A 40.0 g bullet is fired at 100.0 m/s and embeds in a wooden block on a smooth surface…

A: The objective of this question is to find the mass of the wooden block. This can be achieved by…

Q: A series RLC circuit consists of a 40 2 resistor, a 2.6 mH inductor, and a 610 nF capacitor. It is…

A: Phase angle = 0.168 degree Explanation:Step 1: Step 2: Step 3: Step 4:

Q: 4) Consider the sliding bar AB of length = 1.00 m. If the end B is sliding down at 0.5 m/s at the…

Q: If the ratio of the outer radius to the inner radius of a rectangular toroid is doubled how does the…

A: Option (a) "The answer can not be determined from the information given" is correct.Explanation:Step…

Q: 1 C F Object 8 6 Match the ray shown in the figure to its description as C-,P-, F-ray, or indicate…

A: To findMatch the rays shown in the figure to their description as C, P, F, or indicate if it is none…

Q: The following figure shows a copper wire bent into a circular shape with a radius of 0.50 m. B (into…

Q: 6. A planet of mass m is orbiting around the sun, mass M, with a mean orbital radius R. Its orbital…

A: Done11.9 yearsExplanation:Step 1:a) Expressions for Orbital Speed vi. In terms of the periodic time…

Q: The coefficient of static friction between a block and a ramp is given by μ = tan(θ) where θ is the…

A: The objective of the question is to calculate the uncertainty of the coefficient of static friction…

Q: A long wire carrying a 6.0 AA current perpendicular to the xy-plane intersects the x-axis at…

A: To understand the situation and its implications, we should break it down into several key…

Q: G Google × G Google Account b Account Details | bart X M Pdf corinamandujar X ℗ Mastering Physics -…

A: All answers are given in the explanation.Explanation:Given radius of the circular orbit (r) =…

Q: You wake up one morning to find yourself in a strange room with opaque walls, and no visible doors…

A: 1850 NExplanation:

Q: A 127 ohm resistor, a 26 uF capacitor, and a 3.4 H inductor are all connected together in series.…

A: The objective of the question is to calculate the total AC impedance of a series circuit that…

Q: An early method of measuring the speed of light makes use of a rotating slotted wheel. A beam of…

Q: In the figure, a thin uniform rod (mass 4.6 kg, length 5.5 m) rotates freely about a horizontal axis…

Q: phy.1

A: The objective of the question is to find the magnitude of the magnetic field. The force required to…

Q: A golf ball is moving at speed vo to the East. After deflecting off a tree, it moves at a speed of…

A: The objective of the question is to determine which of the given statements are true regarding the…

Q: A 1,300 N shaft is held in place by a light wire at an angle 0 = 29.0° to the horizontal as shown in…

Q: object a, slding on a frictionless surface at 3.2 m/s hits a 2.0 kg object, which is motionless. The…

A: The objective of the question is to find the mass of object A given that it collides elastically…

Q: (a) If the speaker is at its lowest frequency (f= 2,000 Hz) that produces destructive interference…

Q: 16. A steel ball of mass 0.50 kg moving with a velocity 1.5 m/s strikes a second ball of mass 0.300…

A: The objective of this question is to determine the velocity of the second ball after a glancing…

Q: Nuclear Fusion Reaction In a human-scale model of a nuclear fusion reaction, two "deuterons" smash…

Q: 58. A point charge q is located at point P(0, -4, 0), while a 10 nC charge is uniformly distributed…

A: .

Q: How a transformers work: • TRANSFORMERS The primary coil is connected to an outside power line. AC…

A: The objective of the question is to understand the working of a transformer and to calculate the…

Q: In exercise physiology studies, it is sometimes important to determine the location of a person's…

Q: A light source emits visible light of two wavelengths, 429nm and 499nm. The light impinges upon a…

Q: A uniform disk with mass 40.0 kg and radius 0.200 m is pivoted at its center about a horizontal,…

Q: A woman with mass 50 kg is standing on the rim of a large horizontal disk that is rotating at 0.80…

A: The objective of the question is to calculate the total angular momentum of the woman-disk system.…

Q: 2.5. Four equal point charges of 3.0 μC are held in place at the four corners of a square that is…

A: a)Draw the schematic diagram of the system of charges.

Q: Please asap

A: The objective of the question is to find out the distance between the two cars when the Chemwagon…

Q: Problem 4: To get it spinning, you exert a force of 180 N perpendicular to the radius of a 0.28 m…

A: The exerted force perpendicular to the grindstone is The radius of the grindstone is The mass of the…

Q: 4. Two positive charges sit in an (x, y)-coordinate system. The first one has charge q₁ = 0.40 μC…

A: The objective of the question is to find the electric potential at the origin due to two charges…

Q: A bridge of length 50.0 m and mass 7.60 × 104 kg is supported on a smooth pier at each end as shown…

A: normal force at point A = 5.9878 x 105 N normal force at point B = 4.69 x 105 N Explanation:Approach…

Q: 3. A 7.17 nC charge is located 1.66 m from a 4.42 nC point charge. a. What is the magnitude of the…

Q: S grune ni aoins) art ai jadw.. If M = 3.0 kg, and the tension in the string connecting M and 2M is…

A: The objective of the question is to find the force F acting on the mass of 2M. The given parameters…

Q: 8. * Limits of human vision The wavelength limits of human vision are 400 nm to 700 nm. What range…

A: The visible range of wavelength is 400 nm–700 nm.Speed of light (c) = 3 × 108 m/s

Q: A bicycle racer is going downhill at 12.9 m/s when, to his horror, one of his 2.27 kg wheels comes…

A: Part A : 30.8287 m/s Part B : 2157.43 JExplanation:

Q: Exercise 3.23 A projectile is released horizontally from A and strikes the target at B as shown.…

Q: In the diagram a gas undergoes a change in pressure from a to b followed by a compression from b to…

Q: In the figure, four long straight wires are perpendicular to the page, and their cross sections form…

Q: The x, y, and z components of a magnetic field are Bx = 0.13 T, By = 0.19 T, and B₂ = 0.15 T. A…

A: 0.26 NExplanation:

Q: An athlete holds a 34.0 N pole in equilibrium by exerting an upward force U with her left hand and a…

A: Weight of the pole is Lengths are , and The system is in equilibrium.Find:(a) The magnitude of…

Q: A solenoid used to produce magnetic fields for research purposes is 2.1 m long, with an inner radius…

A: The objective of this question is to calculate the magnitude of the magnetic field inside a…

Question

A grating has 3800 slits per cm. It produces a second order bright fringe at a 22 degree angle. What wavelength of light is being used?

Video Video

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Show that the distribution of intensity in a double-slit pattern is given by Equation 36.9. Begin by assuming that the total magnitude of the electric field at point P on the screen in Figure 36.4 is the superposition of two waves, with electric field magnitudes E1=E0sintE2=E0sin(t+) The phase angle in in E2 is due to the extra path length traveled by the lower beam in Figure 36.4. Recall from Equation 33.27 that the intensity of light is proportional to the square of the amplitude of the electric field. In addition, the apparent intensity of the pattern is the time-averaged intensity of the electromagnetic wave. You will need to evaluate the integral of the square of the sine function over one period. Refer to Figure 32.5 for an easy way to perform this evaluation. You will also need the trigonometric identity sinA+sinB=2sin(A+B2)cos(AB2)
In Figure P37.18, let L = 120 cm and d = 0.250 cm. 0T he slits are illuminated with coherent 600-nm light. (Calculate the distance y from the central maximum for which the average intensity on the screen is 75.0% of the maximum.
In Figure P27.7 (not to scale), let L = 1.20 m and d = 0.120 mm and assume the slit system is illuminated with monochromatic 500-nm light. Calculate the phase difference between the two wave fronts arriving at P when (a) = 0.500 and (b) y = 5.00 mm. (c) What is the value of for which the phase difference is 0.333 rad? (d) What is the value of for which the path difference is /4?
Figure 24.26 shows the interference pattern of two radio antennas broadcasting the same signal. Explain how this is analogous to the interference pattern for sound produced by two speakers. Could this he used to make a directional antenna system that broadcasts preferentially in certain directions? Explain. Figure 24.26 An overhead view of two radio broadcast antennas sending the same signal, and the interference pattern they produce.
In Figure P36.10 (not to scale), let L = 1.20 m and d = 0.120 mm and assume the slit system is illuminated with monochromatic 500-nm light. Calculate the phase difference between the two wave fronts arriving at P when (a) = 0.500 and (b) y = 5.00 mm. (c) What is the value of for which the phase difference is 0.333 rad? (d) What is the value of for which the path difference is /4? Figure P36.10
A microwave of an unknown wavelength is incident on a single slit of width 6 cm. The angular width of the central peak is found to be 25°. Find the wavelength.
A monochromatic light of unknown wavelength is incident on a slit of width 20 m. A diffraction pattern is seen at a screen 2.5 m away where the central maximum is spread over a distance of 10.0 cm. Find the wavelength.
A beam of monochromatic green light is diffracted by a slit of width 0.550 mm. The diffraction pattern forms on a wall 2.06 m beyond the slit. The distance between the positions of zero intensity on both sides of the central bright fringe is 4.10 mm. Calculate the wavelength of the light.
A spacer is cut from a playing card of thickness 2.90 104 m and used to separate one end of two rectangular, optically flat. 3.00-cm long glass plates with n = 1.55, as in Figure P24.24. Laser light at 594 nm shine straight down on the top plate. The plates have a length of 3.00 cm. (a) Count the number of phase reversals for the interfering waves. (b) Calculate the separation between dark interference Kinds observed on the lop plate.
What is the distance between lines on a diffraction grating that produces a second-order maximum for 760-nm red light at an angle of 60.0°?
If a diffraction grating produces a first-order maximum for the shortest wavelength of visible light at 30.0°, at what angle will the first-order maximum be for the largest wavelength of visible light?
When unpolarized light passes through a diffraction grating, does it become polarized? (a) No, it does not. (b) Yes, it does, with the transmission axis parallel to the slits or grooves in the grating. (c) Yes, it does, with the transmission axis perpendicular to the slits or grooves in the grating. (d) It possibly does because an electric field above some threshold is blocked out by the grating if' the field is perpendicular to the slits.