a.
State the mass of the new model of automobile.
a.
Explanation of Solution
Discussion:
In recent days there are many new model of automobile models are introduced in the worldwide market. Consider on of the recent model of automobile choice is Honda Accord Hybrid. According to the model prescript the mass of automobile is 1620 kg.
Conclusion:
Thus, the new model of automobile is 1620 kg. It might differ for each of the new automobile.
b.
State the mass of an earth.
b.
Answer to Problem 1P
The mass of the earth is
Explanation of Solution
Discussion:
Earth is an astronomical object, which is the third planet from the Sun. The approximate mass of the earth is
Conclusion:
Thus the mass of the earth is
c.
State the mass of a fully loaded Boeing 777.
c.
Answer to Problem 1P
The fully loaded mass of Boeing 777 is
Explanation of Solution
Discussion:
The Boeing 777 is the wide-body jet airliner, which is developed and manufactured by the Boeing Commercial Airplanes.
The maximum take-off weight of Boeing 777 is known as the fully-loaded mass of the airliner.
Conclusion:
Thus the fully loaded mass of Boeing 777 is
d.
State the mass of an ant.
d.
Explanation of Solution
Discussion:
Ant is an insect of eusocial species group. The average mass of an ant is considered approximately
Conclusion:
Thus, the average mass of an ant is
Want to see more full solutions like this?
Chapter 9 Solutions
ENGINEERING FUNDAMENTALS
- 4. An object is constructed of a material lighter than water. It weighs 50N in air and a force of 10 N is required to hold it under water. What is its density, specific weight, and specific gravity?arrow_forward•Which object has more momentum: a car traveling at a speed of 10 km/hr or a baseball pitched at 150 km/hr. Explain your answerarrow_forwardYou're calculating the volume of a cube with an edge length of 0.250 inches. Which of the following should be used to express the cube's volume? Assume a round-up rule if the digit in the next lower decimel place is "5" or greater. Group of answer choices 1.56E-2 cubic inches 1.6E-2 cubic inches 1.563E-2 cubic inchesarrow_forward
- Using a density of 35 lb/ft°, how much does a 2x4, 20 feet long, weigh? Round to three digits and include units with your answer.arrow_forwardDetermine the density, specific volume, and volume of an object that weighs 3N 2 in water and 4N in oil with specific gravity of 0.83 draw figurearrow_forward50 N SCALE 50 N with a The figure shows two masses weight of 50 H, Suspended off the edge of a table onnected to Spring Scale. All objects are at rest. What is the reading on the scale? B) What is the het force on the spring scale? aarrow_forward
- As an engineer working for the oil-based multinational company Petronas, you are re- checking the calculations done by the consultants as shown in Figure 3. However, upon submission, your chief engineer told you to sit down and asks you to re-calculate the following back to check if you really understood the calculations; (a) Find the distance ỹ to the centroid of the beam's cross-sectional areas and calculate the moment of inertia about the x'axis. (b) What is the moment of inertia of the beam's cross sectional area about the y- axis? (c) Your chief engineer further asks "It is often the case that the moment of an inertia for an area is known about an axis passing through its centroid. What can then be said about the moment of inertia of the same area about a corresponding parallel axis?" 50 mm 50 mm 300 mm 100 mm -200 mm Figure 3arrow_forwardWhat are the resistance forces that attribute to acceleration varying with respect to speed? O grade resistance force O aerodynamic resistance force O rolling resistance force all of the abovearrow_forwardA cylindrical tank 2m in diameter, 3m high is full of oil. If the specific gravity of oil is 0.9, what is the mass of oil in the tank? (neat hand written)arrow_forward
- A particle of mass 0.128 kg is rotating at 1170 rpm at a radius of 185 mm. At t=2.2s the radius begins to expand at a rate of 32 mm.s Answer all questions to at least 3 significant figures. Enter your numerical answers in SI units but do not enter the units. What is the radial force at t=2.1s [N] What is the arc length traveled by the mass at t=2.1 s? [m] What is the transverse force on the mass at t=4.4s? [N]arrow_forwardThe material has a specific weight y = 70 lb/ft². (Figure 1) Figure 0.25 ft 0.5 ft 1 ft 2 ft 1 ft ▼ Part A Determine the moment of inertia of the wheel about an axis which is perpendicular to the page and passes through point O Express your answer to three significant figures and include the appropriate units. μA Io = 91.972 slug ft² ● Submit Previous Answers Request Answer ? X Incorrect; Try Again; 5 attempts remaining < Return to Assignment Provide Feedbackarrow_forwardAfter a long day of online classes and watching KPop videos, you decided to close the lid of your laptop (Figure 1). You then realized that your laptop can be idealized as a rigid thin plate BD (mass = 0.370 kg and centroidal mass moment of inertia l = 37/19200 kg-m²) pinned at one end with its side view as shown in Figure 2. The lid with a side length of 250 mm is initially at rest when a load of P = 5.00 N is applied. 10⁰ D P CHESS- Figure 1 250 mm 50⁰ B Figure 2arrow_forward
- Engineering Fundamentals: An Introduction to Engi...Civil EngineeringISBN:9781305084766Author:Saeed MoaveniPublisher:Cengage Learning