Physics for Scientists and Engineers
Physics for Scientists and Engineers
6th Edition
ISBN: 9781429281843
Author: Tipler
Publisher: MAC HIGHER
bartleby

Concept explainers

bartleby

Videos

Question
Book Icon
Chapter 7, Problem 99P

(a)

To determine

The magnitude of the combined force of friction at 20m/s and at 30m/s .

(a)

Expert Solution
Check Mark

Answer to Problem 99P

The magnitude of the combined force of friction at 20m/s is 491N and at 30m/s is 981N .

Explanation of Solution

Given:

On a 2.87° hill, speed of car is 20m/s ,on a 5.74° hill, speed of car is 30m/s and total mass of the car is 1000kg .

Formula used:

Magnitude of force of friction at 20m/s is F20 and magnitude of force of friction at 30m/s is F30 .

The diagram representing the situation is given below.

  Physics for Scientists and Engineers, Chapter 7, Problem 99P , additional homework tip  1

Write the equation of resultant along the incline in equilibrium position.

  Fx=0

Here, Fx is summation of all the forces along incline.

Substitute mgsinθFf for Fx in above equation.

  mgsinθFf=0

Rearrange above equation.

  Ff=mgsinθ …... (1)

Here, mgsinθ is component of Fg along the incline and Ff is the frictional force.

Calculation:

Whenspeed of car is 20m/s .

Substitute 2.87° for θ , 1000kg for m and 9.81m/s2 for g in equation (1).

  F20=(1000kg)(9.81 m/s2)sin(2.87°)491N

Whenspeed of car is 30m/s .

Substitute 5.74° for θ , 1000kg for m and 9.81m/s2 for g in equation (1).

  F30=(1000kg)(9.81 m/s2)sin(5.74°)981N

Conclusion:

Thus, the magnitude of the combined force of friction at 20m/s is 491N and at 30m/s is 981N .

(b)

To determine

The power delivered by the engine to drive the car on a level road at 20m/s and at 30m/s .

(b)

Expert Solution
Check Mark

Answer to Problem 99P

The power delivered by the engine to drive the car on a level road at 20m/s and at 30m/s is 9.8kW and 29kW respectively.

Explanation of Solution

Given:

On a 2.87° hill, speed of car is 20m/s , on a 5.74° hill, speed of car is 30m/s , total mass of the car is 1000kg the magnitude of the combined force of friction at 20m/s is 491N and at 30m/s is 981N .

Formula used:

Power delivered by the engine to drive the car on a level road at 20m/s is P20 and power delivered by the engine to drive the car on a level road at 30m/s is P30 .

Power delivered by the engine to drive the car on a level road in order to overcome friction is calculated by the expression given below.

Write the expression for power delivered.

  P=Ffv ........(2)

Here, P is the power delivered and v is the speed of the car.

Calculation:

Substitute 491N for Ff and 20m/s for v in equation (2).

  P20=(491N)(20m/s)=9820W=9.8kW

Substitute 981N for Ff and 30m/s for v in equation (2).

  P30=(981N)(30m/s)=29430W=29kW

Conclusion:

Thus, the power delivered by the engine to drive the car on a level road at 20m/s and at 30m/s is 9.8kW and 29kW respectively.

(c)

To determine

The angle of the steepest incline up which can be maintained by car at steady speed of 20m/s .

(c)

Expert Solution
Check Mark

Answer to Problem 99P

The angle of the steepest incline up which can be maintained by car at steady speed of 20m/s is 8.8° .

Explanation of Solution

Given:

On a 2.87° hill, speed of car is 20m/s , on a 5.74° hill, speed of car is 30m/s , total mass of the car is 1000kg the magnitude of the combined force of friction at 20m/s is 491N and at 30m/s is 981N .

Formula used:

The diagram representing the situation is given below.

  Physics for Scientists and Engineers, Chapter 7, Problem 99P , additional homework tip  2

Write the equation of resultant along the incline in equilibrium position.

  Fx=0

Here, Fx is summation of all the forces along incline.

Substitute FmgsinθFf for Fx in above equation.

  FmgsinθFf=0

Rearrange above equation.

  F=mgsinθ+Ff

Here, F is the external force.

Substitute Pv for F in above equation.

  Pv=mgsinθ+Ff

Rearrange above equation for θ .

  θ=sin1[PvFfmg] …... (3)

Calculation:

Substitute 20m/s for v , 40kW for P , 1000kg for m , 491N for Ff and 9.81m/s2 for g in equation (3).

  θ=sin1[ 40kW 20m/s491N( 1000kg)( 9.81 m/s 2 )]=sin1[15099810]=8.8°

Conclusion:

Thus, the angle of the steepest incline up which can be maintained by car at steady speed of 20m/s is 8.8° .

(d)

To determine

The total useful work in kilometers per liter when engine goes at 30m/s .

(d)

Expert Solution
Check Mark

Answer to Problem 99P

The total useful work in kilometers per liter when engine goes at 30m/s is 6.36km/L .

Explanation of Solution

Given:

The magnitude of the combined force of friction at 20m/s is 491N and at 30m/s is 981N .

Formula used:

Write the expression for work done by engine.

  W=FΔs

Here, W is the work done, F is the force and Δs is the distance in kilometers per liter.

From the condition of equivalence:

  F20Δs20=F30Δs30

Here, Δs20 is the distance in kilometers per liter when speed is 20m/s and Δs30 is the distance in kilometers per liter when speed is 30m/s .

Rearrange above equation.

  Δs30=F20F30Δs20 ........(4)

Calculation:

Substitute 491N for F20 , 981N for F30 and 12.7km/L for s20 in equation (4).

  Δs30=491N981N(12.7km/L)=6.36km/L

Conclusion:

Thus, the total useful work in kilometers per liter when engine goes at 30m/s is 6.36km/L .

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!
Students have asked these similar questions
HW 11 Steep safety ramps are built beside mountain highways to enable vehi- cles with defective brakes to stop. A 10-ton truck enters a 15° ramp at a high speed vo 108 ft/s and travels for 6 s before its speed is reduced to 36 ft/s. Assuming constant deceleration, determine (a) the magnitude of the braking force, (b) the additional time required for the truck to stop. Neglect air resistance and rolling resistance. %3D RAIL INES 00 15°
A car traveling at 30 m/s runs out of gas while traveling up a 10o slope.  How far up the hill will it coast before starting to roll back down?  Select the best answer.
Sand moves without slipping at 6.0 m/s down a conveyer that is tilted at 150. The sand enters a pipe h = 5z m below the end of the conveyer belt, as shown in the figure below. Assume that the sand is in free fall. The coordinate system is also shown in the figure. (A) What is the acceleration in the horizontal and vertical direction? (B) How long the sand will be in the air (starting from the when it leaves the belt i.e. at origin until it enters the pipe)? (C) What is the horizontal distance “d” between the conveyer belt and the pipe? (D) What is the x-component of sand’s velocity when it enters the pipe? (E) What is the y-component of the sand’s velocity when it enters the pipe? The first 3 sub-parts were already answered for me, I just need parts D and E please.

Chapter 7 Solutions

Physics for Scientists and Engineers

Ch. 7 - Prob. 11PCh. 7 - Prob. 12PCh. 7 - Prob. 13PCh. 7 - Prob. 14PCh. 7 - Prob. 15PCh. 7 - Prob. 16PCh. 7 - Prob. 17PCh. 7 - Prob. 18PCh. 7 - Prob. 19PCh. 7 - Prob. 20PCh. 7 - Prob. 21PCh. 7 - Prob. 22PCh. 7 - Prob. 23PCh. 7 - Prob. 24PCh. 7 - Prob. 25PCh. 7 - Prob. 26PCh. 7 - Prob. 27PCh. 7 - Prob. 28PCh. 7 - Prob. 29PCh. 7 - Prob. 30PCh. 7 - Prob. 31PCh. 7 - Prob. 32PCh. 7 - Prob. 33PCh. 7 - Prob. 34PCh. 7 - Prob. 35PCh. 7 - Prob. 36PCh. 7 - Prob. 37PCh. 7 - Prob. 38PCh. 7 - Prob. 39PCh. 7 - Prob. 40PCh. 7 - Prob. 41PCh. 7 - Prob. 42PCh. 7 - Prob. 43PCh. 7 - Prob. 44PCh. 7 - Prob. 45PCh. 7 - Prob. 46PCh. 7 - Prob. 47PCh. 7 - Prob. 48PCh. 7 - Prob. 49PCh. 7 - Prob. 50PCh. 7 - Prob. 51PCh. 7 - Prob. 52PCh. 7 - Prob. 53PCh. 7 - Prob. 54PCh. 7 - Prob. 55PCh. 7 - Prob. 56PCh. 7 - Prob. 57PCh. 7 - Prob. 58PCh. 7 - Prob. 59PCh. 7 - Prob. 60PCh. 7 - Prob. 61PCh. 7 - Prob. 62PCh. 7 - Prob. 63PCh. 7 - Prob. 64PCh. 7 - Prob. 65PCh. 7 - Prob. 66PCh. 7 - Prob. 67PCh. 7 - Prob. 68PCh. 7 - Prob. 69PCh. 7 - Prob. 70PCh. 7 - Prob. 71PCh. 7 - Prob. 72PCh. 7 - Prob. 73PCh. 7 - Prob. 74PCh. 7 - Prob. 75PCh. 7 - Prob. 76PCh. 7 - Prob. 77PCh. 7 - Prob. 78PCh. 7 - Prob. 79PCh. 7 - Prob. 80PCh. 7 - Prob. 81PCh. 7 - Prob. 82PCh. 7 - Prob. 83PCh. 7 - Prob. 84PCh. 7 - Prob. 85PCh. 7 - Prob. 86PCh. 7 - Prob. 87PCh. 7 - Prob. 88PCh. 7 - Prob. 89PCh. 7 - Prob. 90PCh. 7 - Prob. 91PCh. 7 - Prob. 92PCh. 7 - Prob. 93PCh. 7 - Prob. 94PCh. 7 - Prob. 95PCh. 7 - Prob. 96PCh. 7 - Prob. 97PCh. 7 - Prob. 98PCh. 7 - Prob. 99PCh. 7 - Prob. 100PCh. 7 - Prob. 101PCh. 7 - Prob. 102PCh. 7 - Prob. 103PCh. 7 - Prob. 104PCh. 7 - Prob. 105PCh. 7 - Prob. 106P
Knowledge Booster
Background pattern image
Physics
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.
Similar questions
SEE MORE QUESTIONS
Recommended textbooks for you
Text book image
Classical Dynamics of Particles and Systems
Physics
ISBN:9780534408961
Author:Stephen T. Thornton, Jerry B. Marion
Publisher:Cengage Learning
Text book image
Glencoe Physics: Principles and Problems, Student...
Physics
ISBN:9780078807213
Author:Paul W. Zitzewitz
Publisher:Glencoe/McGraw-Hill
Text book image
University Physics Volume 1
Physics
ISBN:9781938168277
Author:William Moebs, Samuel J. Ling, Jeff Sanny
Publisher:OpenStax - Rice University
Text book image
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Kinematics Part 3: Projectile Motion; Author: Professor Dave explains;https://www.youtube.com/watch?v=aY8z2qO44WA;License: Standard YouTube License, CC-BY