Concept explainers
Obtain two soda cans and a cardboard tube that has a smaller diameter than the can.
1. How can you arrange the two soda cans so that (a) they appear to be equally wide and (b) one can appears wider than the other?
In the space below, draw a top view diagram for each case that can be used to compare the apparent widths of the cans.
2. How can you arrange one can and the tube so that (a) the two objects appear to be equally wide and (b) the tube appears wider than the can?
In the space below, draw a top view diagram for each case that can be used to compare the apparent widths of the two objects.
3. What quantities affect the apparent size of an object? Describe how increasing or decreasing each quantity affects the apparent size of that object.
Explain how you can use a top view diagram to determine whether one object appears wider or narrower than another object to an observer at a particular location.
Want to see the full answer?
Check out a sample textbook solutionChapter 10 Solutions
Tutorials in Introductory Physics
Additional Science Textbook Solutions
Essential University Physics: Volume 2 (3rd Edition)
University Physics Volume 1
Introduction to Electrodynamics
Physics for Scientists and Engineers with Modern Physics
Conceptual Physics (12th Edition)
College Physics: A Strategic Approach (3rd Edition)
- The meter stick lies on the bottom of a 100-cm-long tank with its zero mark against the left edge. You look into the tank at a 30° angle, with your line of sight just grazing the upper left edge of the tank. (Figure 1) (Note: nwater = 1.33) Part A What mark do you see on the meter stick if the tank is empty? Express your answer with the appropriate units. ? cm Submit Request Answer Figure 1 of 1 Line of sight 30° 50 cm Zero Meter stick 100 cmarrow_forwardProblem 9: Two converging lenses with focal lengths of 40 cm and 20 cm are 10 cm apart. A 2.0 cm tall object is 15 cm in front of the 40 cm focal length lens. a. Use ray tracing to find the position and height of the image. Determine the image distance and image height by making accurate measurements on your diagram. Calculate the image height and position relative to the second lens. Compare with your ray-tracing answers in part a. b. c. Clearly mark the object, image, object distance, image distance and focal length for both the lenses. d. Show all your calculations. e. Write down the image characteristics of each image.arrow_forwardA nature photographer taking a close-up shot of an insect replaces the standard lens on his camera with a lens that has a shorter focal length and is positioned farther from the CCD detector. Part A Explain why he does this. Drag the terms on the left to the appropriate blanks on the right to complete the sentences. Reset Help 1 The object distance, image distance, and focal length are related by f smaller 1 1 Inspecting this expression, we see that for a fixed focal length, as the object s' f distance gets smaller the image distance must get in order to +! = } f maintain the equality. s' larger Due to the construction of the camera, there is a limit to how big the image distance can be and still get a sharp image on the detector. In order to allow smaller object distances (which is the case for a close-up shot), the photographer can use a focal length lens.arrow_forward
- You hold a spherical salad bowl 50 cm in front of your face with the bottom of the bowl facing you. The salad bowl is made of polished metal with a 48 cm radius of curvature. Part A Where is the image of your 5.0-cm-tall nose located? Follow the sign rules. Enter the magnitude of the distance from the salad bowl. Express your answer with the appropriate units. s' Submit Part B Value y' = Request Answer What is the image's size? Express your answer with the appropriate units. μА Units Value Units ? ?arrow_forwardIn the figure at right the light is crossing a vertical interface with the normal Medium n1 marked as a dashed line. The light is coming from the left and crossing to the right.. Medium n2 normal Which is larger? The index of refraction is larger The speed of light is faster in Choose the equation or equations that you will need to use to calculate n2 given the angles of incidence and refraction and then to find the speed of light in medium n2. Select one or more: a. Force on an object mass m moving in a circle of radius R: F = mv2/R b. B-field of a long straight wire: B = Hol/2nR c. Snell's law: n;sin0, = n2sin02 d. Doppler shift: f' = f(1 ± u/c) e. C = = fA f. Magnetic Force on a moving charge: F = qvBsin0 g. Force on a current carrying wire: F = BILsine h. Mirror or Thin Lens Equation: 1/d, + 1/d; =1/f, h/h¡ = -d/d;arrow_forwardProblem 3: In the figure below, an image of the object is formed by the following 2 steps: 1. Light from the object first refracts through the diverging lens. 2. This refracted light then refracts through the converging lens. (a) What is g2? The location of the final image, as measured from the converging lens? (b) What is the magnification of the final image? (c) Sketch a ray diagram for this problem. Make sure to include 2 ray diagrams. The first ray diagram is for Step 1 above and the second ray diagram is for Step 2 above. fi = 30 ст f2 = 3 —10 ст Object 50 ст d 3 90 стarrow_forward
- Light rays fall normally on the vertical surface of a glass prism (n = 2.05) as shown in Figure. 1) What is the largest value of 0 such that the ray is totally internally reflected at the slanted face? (Express your answer to three significant figures.) Submit 0 2) Repeat the calculation if the prism is immersed in water with n = 1.33. (Express your answer to three significant figures.) Submit O Oarrow_forwardWhen fully dilated, the pupil of a cat is approximately 12.5 mm wide. For 621 THz light ("T" stands for "tera" and means 1012), determine the minimum angle that can be resolved for the cat eye. Express your answer in degrees. Omin The diagram below shows a cat looking at two trees. The cat is just able to resolve the two trees. The distance between the two trees is 8 m. For the 0min you just determined, determine the distance between the cat & the trees. distance between the cat & the trees =arrow_forwardA Two-Lens System 19 of 22 Constants A compound lens system consists of two converging lenses, one at z = -20.0 cm with focal length fi = +10.0 cm, and the other at z = +20.0 cm with focal length fa = +8,00 cm, (Figure 1)An obiect 1.00 centimeter tall is placed at a = -50.0 cm. Part A What is the location of the final image produced by the compound lens system? Give the x coordinate of the image. Express your answer in centimeters, to three significant figures or as a fraction. > View Available Hint(s) z = 31.8 cm Submit Previous Answers v Correct Part B How tall is the image? Express your answer in centimeters, to three significant figures or as a fraction. • View Available Hint(s) Yim = 0.236 cm Submit Previous Answers v Correct Correct answer shown. Your answer 0,2352 cm was either rounded differently or used a different number of significant figures than required for this part. Figure Part C Is the final image upright or inverted, relative to the original object at z = -50 cm? O…arrow_forward
- A horizontal light ray initially in air (n1 = 1) approaches a prism as shown in the diagram below. The prism is in the shape of a right triangle and has an index of refraction of 1.5 (i.e. n2=1.5). a. Draw the trajectory of the light ray to show how it enters and exits the prism. b. Calculate the angle (with respect to the normal) at which it both enters and exits the prism. Show your work. 60arrow_forwardPlease only answer question 9. I included question 8 as well to give the background of the question. Please give a detailed explanation for why the total internal reflection occurs when the incident angle is greater than the critical angle. Please explain each step carefully with good reasoning.arrow_forwardAn object O is placed at the location shown in front of a concave spherical mirror. Use ray tracing to determine the location and size of the reflected image. As you work, keep in mind the following properties of principal rays: Part A Trace the path of a ray emitted from the tip of the object through the focal point of the mirror and then the reflected ray that results. Start by extending the existing ray emitted from the tip of the object. Then create the reflected ray. 1. A ray parallel to the axis, after reflection, passes through the focal point Fof a concave mirror or appears to come from the (virtual) focal point of a convex mirror. 2. A ray through (or proceeding toward) the focal point Fis reflected parallel to the axis. 3. A ray along the radius through or away from the center of curvature C intersects the surface normally and is reflected back along its original path 4. A ray to the vertex Vis reflected, forming equal angles with the optic axis. Draw the vector for the…arrow_forward
- College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningUniversity Physics (14th Edition)PhysicsISBN:9780133969290Author:Hugh D. Young, Roger A. FreedmanPublisher:PEARSONIntroduction To Quantum MechanicsPhysicsISBN:9781107189638Author:Griffiths, David J., Schroeter, Darrell F.Publisher:Cambridge University Press
- Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningLecture- Tutorials for Introductory AstronomyPhysicsISBN:9780321820464Author:Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina BrissendenPublisher:Addison-WesleyCollege Physics: A Strategic Approach (4th Editio...PhysicsISBN:9780134609034Author:Randall D. Knight (Professor Emeritus), Brian Jones, Stuart FieldPublisher:PEARSON