Engineering surveying If the magnetic declination in the area of Christ is w' 6° 50, it is found that the magnetic quadrilateral directions of the nonlinear ones are as shown in the table below. What will be the values of these directions when the value of magnetic declination changes to 3?

Engineering surveying If the magnetic declination in the area of Christ is w' 6° 50, it is found that the magnetic quadrilateral directions of the nonlinear ones are as shown in the table below. What will be the values of these directions when the value of magnetic declination changes to 3?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A transit with a stadia interval factor of 100.8 was set at C on the line between points A and B,…

Q: Using the Google Earth Pro application, a BSGE student measured the dimensions of the main academic…

A: Surveys are the procedures used to decide the three-layered places of focuses. It incorporates…

Q: The observed interior angles of a triangle are A = 35°14'37", B = 96° 30' 09", and C= 48°15'05".…

Q: Using a 1 second theodolite the following clockwise angles were measured in a closed traverse. What…

A: The given data is: The traverse angle is given as: 163 27' 36" 3240 18' 22" 620 39' 27" 330 19' 18"…

Q: Problem no. 1: The difference in elevation between observed points A and B is 47 m and the…

A: Solution: Given Data: Difference in elevation between observed points A and B is 47 m. Horizontal…

Q: The observed angles of a triangle are as follows: A = 340 20' 36" B = 490 16' 34" C = 960 22' 41"…

Q: A pipeline transporting natural gas is to be laid out on the side of a hill (from pt. A to pt. B) as…

Q: What is the most probable value of the distance measured?

A: Most probable value of the distance measured is 3.358±0.041 m

Q: From the ff data of measuring over level ground, determine the: a) Length of line BA b) Mean length…

Q: In order to carry out tacheometric surveying, following observations were taken through a…

A: Reduced level or reduced line is also one element while surveying to measure the level of the point…

Q: IN THE FIGURE, THE WIDTH OF A RIVER BEING OBSERVED IS 63m. ASSUMING THE TRANSIT BEING USED HAS AN…

Q: A group of students were tasked to measure a certain distance. 3 students measured it as 3.352 m, 5…

A: Given Distances measured 3 students measured it as 3.352 m, 5 students measured it 3.307 m, and 7…

Q: Measurement of Horizontal Distance in Elementary Surveying: The following values of a line were…

A: The tape measurements are 2050.67 m, 2050.86 m, 2050.41 m, 2050.18 m, 2050.68 m,2050.03 m.

Q: Problem 3 Given in the tabulation below are the observed forward and backward bearings of an open…

A: Given data:

Q: Problem 3 Given in the tabulation below are the observed forward and backward bearings of an open…

A: 1) convert all the quadrantal bearings into whole circle bearing and plot the traverse then proceed…

Q: 4.7.2 (This problem is adapted from the Ground Water Manual.") Drawdown versus time data for an…

A: In this question we use Theis euqation Theis equation depicts radial limited groundwater flow in an…

Q: A stream function is given by = 3x 3 - y³. What is the magnitude of velocity components at the point…

A: Using the relation between stream function and velocity components. The x and y components of…

Q: 12. PROBABLE ERROR. A surveying instructor sent all the 10 students in his class out to measure a…

A: Answer Let us first calculate the Mean and Standard deviation of measurements Mean x =…

Q: Linear Error of Closure Given a closed traverse with sum of south latitudes exceeds the sum of…

Q: In horizontal distance measurement, the slope is considered as an error which must be corrected.…

Q: •The following are the observed magnetic bearings of a closed compass traverse: FORWARD BACKWARD…

Q: calibration curve sometimes do not pass through the origin and mat have relatively large intercept…

A: Answer:- Calibration curve:- It is a regression model used to predict the unknown concentration of…

Q: Q3: In the sample traverse figure below, calculate the angular error of closure, and balance the…

Q: Solve the following problems showing your complete solutions. Draw the figure completely labelled…

A: Consider the traverse diagram;

Q: WEIGHTED MEASUREMENTS. If is desired to determine the most probable value of an angle which has been…

A: Given: The angle obtained in the 2 measurements is 74o39’45”. The angle obtained in the 4…

Q: An angle APB is measured at different times using various instruments and procedures. The results,…

A: Most probable value: The value of an angle at a triangulation station that is found from the value…

Q: A distance was measured on an 8% slope and found to be 2620.30 m. What is the horizontal distance…

Q: The observed interior angles of a triangle are A= 35 14'37", B= 96°30'09", C= 48 15'05". Determine…

Q: The observed interior angles of a triangle are A =35°14’37”, B = 96°30’09”, C= 48°15’05”. Determine…

A: Surveying is the branch that works on the principle to measure from whole to part. This means the…

Q: The ff. data are the observed elevation of a point by running a line of levels over four different…

Q: If the four angles of a triangle each have a standard error of ±2" what is the total error in the…

A: Given data: The four angles of a triangle each have a standard error of ±2'' n=4e=±2 Total error,…

Q: . A stadia survey was conducted to determine the width of a river using a survey instrument with an…

Q: A surveying instructor sent out six groups of students to measure a distance between two points…

A: given data : A surveying instructor sent out six groups of students to measure a distance between…

Q: The similar triangle method can be defined as: a. One of the simplest methods used for determining…

A: Triangulation survey is a method in which tracing and measurement of a series or network of…

Q: The observed interior angles of triangle ABC and their corresponding number of times measured as…

Q: Question 1 Table 1 shows the summary of a closed loop traverse carried out in campus by a group of…

Q: Given the following data in a sample D = 5°, Sta PC = 1+234.56. Azimuth of the back and forward…

Q: The most probable value of several measurements of a line is 546.75 m. If 0.15 represents the…

Q: It is desired to determine the most probable value of an angle which has been measured at different…

A: Most probable value is the value which is most likely to occur during any experiment or test or…

Q: AN ANGLE ABC IS MEASURED AT DIFFERENT TIMES USING VARIOUS INSTRUMENTS AND PROCEDURES. THE RESULTS,…

A: Angle ABC is measured using various instruments and methods Result 1:- Angle ABC = 75°05'26'' weight…

Q: Given the following data in a sample D = 5°, Sta PC = 1+234.56. Azimuth of the back and forward…

Q: 3. It is desired to determine the most probable value of an angle which has been measured at…

A: In surveying, the measurement is done manually or digitally and during this process, errors may…

Q: In the figure, the width of a river being observed is 80m, assuming the transit being used has a K…

Q: 1) Complete the missing data and determine the difference in elevation of BM1 and BM2. Show complete…

A: Here Height of instrument(HI) = elevation + Back sight (BS) Elevation = HI - Fore sight (FS)

Q: A theodolite traverse carried out between two points A and B on the line of a proposed tunnel…

A: lattitude=Lcosθ and Departure=Lsinθ LINE LENGTH(m) BEARING LATITUDE DEPARTURE A-(i) 128.88 086°…

Q: A pipeline transporting natural gas is to be laid out on the side of a hill (from pt. A to pt. B) as…

Q: Q1) A bird flies 110 m east from an apple tree, then 180 m northwest making an angle 47 degree north…

A: Given Data- The given situation can be shown with the help of this diagram-

Q: The most probable value of several measurements of a line is 546.75 m. If 0.15 represents the…

A: The most probable value of measurement of line = 546.75m probable error = 0.15m

Q: The angles about a point have the following observed values: 130°15’20", 142°37’30", and 87°07°40".…

A: Given Data: Angles about a point are: 130°15’20", 142°37’30", and 87°07°40" It is asked to…

Q: Problem 3 Given in the tabulation below are the observed forward and backward bearings of an open…

A: To Determine Plot the traverse and adjust the forward and backward bearing of each course. Tabulate…

Question

SIDE
М.Br
AB
N 02° 10' E
BC
S 02° 10' E
CD
S 88° 20' E
DE
N 87° 05' E

Determining the relative position of points on the Earth's surface and measuring the angle and distance between them in order to calculate the required parameters such as elevation and enclosed area.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

LINE AB BC CD DE EA C 118°37 105°22' 108° 28' E B 120°28' AZIMUTH from North N30°00'W MERIDIAN 87°05' BEARING
The people in Metropolis made a tribute for Clark Kent and performed a survey to form his crest as shown in the figure. The course of the traverse is alphabetical (A-B-C-D-E-A). Determine the following: a. The unknown angle at point E. b. The bearings and azimuths (from north and south) of all the lines of the traverse assuming that line AB has a bearing of S 75°30' E.
Find the position of NA if 250*350 mm Ast is 1200 mm sq FE250. M25
O O 9:0V Mark u out or1o ?What is the elevation of point BM1 in the below table if you know that the elevation of BM2 is 26.89 m Elevation 77? Elevation of BM2 FS HI BS Point No 1.532 BM1 1.873 BM2 الجواب 28.76 II The correct answer is: 27.231
1Q is 18 7T is 72
Q3/ complete (LAT, DEP) of travers ABCDE Station Azimuth Length Latitude Departure A 26 10' 285.10 104 35' 610.45 195 30' 720.48 358 18' 203.00 306 54' 647.02 A Misclosure Q4) Alcomplete the flowing (choose 5) 1 Tempereture Ct = 2_Area of ellipse = 3 Azimutu dic (175 30°) in bearing = 4_The angle (100grad 50 c.grad) in sexagesimel = 5_The angle 30° in radians = 6 Types of leveling survey are 1_ 2_ 3_ B) Draw graphical scale calinear scale of (1\5000) ?
Determine the force of all members using METHOD OF JOINT. Answer in 3 decimal places only. TRUSS MEMBERS ● FORCE COMPRESSION OR TENSION
SITUATION 1- Hissing Data Given: Traverse with omitted measurements. (a) Calculate the distance of line GA (b) Determine the bearing of line CD TRAVERSE DATA W/ OHITTED MEASUREMENTS UNE LENGTH (m) BEARING AB 550.00 S 80.00° W BC 295.00 N 40.00° W CD 610.00 DE 885.00 S 72.00° E EF 455.00 S 18.00° E FG 500.00 S 80.00° W GA N 30.00 W
TP1 4.20 6.02 21+80 5.80 22+00 5.95 22+50 6.05 BM2 5.83 451.06 3. The bearing of line AB is N 50°16'08" E, and the bearing of line AC is N 64°23'32" W. What is angle +C BAC? 4. Suppose that a line has been observed 10 times using the same equipment and procedures. The results are shown below and it is assumed that no mistakes exist, and that the observations have already been corrected for all systematic errors. Compute the most probable value for the line length and the standard deviation. 64.25.32 Length (ft) 538.57 538.39 538.37 538.39 538.48 538.49 538.33 538.46 538.47 538.55 5. For the section shown, sections S1 and S2 are spaced 100 ft apart. The dimensions of Si and S2 are as given in the table below. Determine the area of the midsection in a prismoidal computation of the volume of dirt removed. Section 40.0 ft 5.67 ft 0.5 50.0 ft 7.14 ft 0.5 S1 S2
Using the previous example, balance the departures and latitudes using the transit rule. CD ΙΣ DEPI CL (LAT of course) ΙΣLAT Corrpep (DEP of course) CorrLAT
Q3: A: Draw the diagram of traverse classification. B: In closed traverse ABCD. The partial coordinates were known as shown below. Determine its area by DMD method. 04 N Dofland OWODY dienstl it with (nm) dinostim Mem. AB BC CD DA ΔΧ 40 -80 -50 AY 60 100 -70
Station BS HI FS Elevation BM-125 920.00 ТР-1 3.11 X 1.27 920.47 ТР-2 Y 926.28 1.11 ТР-3 2.74 2.00 BM-126 1.33 What is the value of Y?