5(55.3).K1Brine Pond77565(47.1)3(39.1)3014(50.0)Scale: 1-in 50-ft6Depth to water(54.2) (Depth to Aquifer bottom)15(49.0)BreweryK2Figure 2. Flow lines and conductivity boundaries for the contaminated site.K3 An oil company has drilled a hydraulic fracturing well near your microbrewery in Anytown,U.S.A. It stores the wastewater in a holding pond on site until proper disposal techniques can beimplemented. On October 10 at 1200 hours, the company notified the town that they havedetected a leak in the holding pond and the brine water may have entered the water tableaquifer.Meanwhile, the Anytown Beer Brewery is happily making "Anytime Bitter IPA", known by itsslogan "Anytime you feel bitter, have an Anytime Bitter IPA". The source of water for theirproduct is a production well that taps the water table aquifer at a rate of 65 gpm. The monthlywater quality testing is due to occur on October 16 at 1600 hours.Complete the flow net using the angular relationships illustrated by the tangent law for refractedgroundwater.

Assessing the SituationHydraulic fracturing, or fracking, is a process of injecting high-pressure…

Answered: 5 (55.3). K1 Brine Pond 77 56 5 (47.1)…

Solid Waste Engineering

3rd Edition

ISBN:9781305635203

Author:Worrell, William A.

Publisher:Worrell, William A.

Chapter5: Separation Processes

Section: Chapter Questions

Problem 5.13P

See similar textbooks

Similar questions

A groundwater supply has been designated as vulnerable to fecal contamination, and the state has specified a disinfection level of 99.99% (4.0-log) virus inactivation. The peak hourly pumping rate is 2000 gpm from the well field through a 4200-ft pipe with a 16-in diameter to a reservoir in the town. The water temperature is 10°C. A. what is the contact time in the pipeline? B. What chlorine residual is required in the water at the outlet of the pipeline? F3 F4 F5 F6 F7 F8 F9 F10 F11 F12 %23 & 3 4 7 8 T Y D F G K CO LLI
An impellar blade unit operates at 50 rpm. Determine the degree of mixing? Also if the blade operates from 50 rpm to 100 rpm what is the percent increase?
A jar test reveals that the optimum alum coagulant dose is 50 mg/L at a pH of 8.1 and a temperature of 73 F. How many pounds per day of 49% alum are required for the whole plant? Total flow is 36 MGD with four parallel treatment plants, each designed for 12 MGD. Could use some guidance on setting up the equations.
5 ml wastewater is added to a 333 ml BOD flask. The initial dissolved O2 concentration was 13 mg/l and final dissolved O2 concentration was 4 mg calculate the BOD?
Note: Kindly provide a solution pls. The answer is already provided. Thank you! 1.19 A high concentrated solution having a volume of 120 liters is mixed by 9% alcohol and24% gasoline. It was found out that a 50-50 percent mixture is also appropriate in thesolution. How much gasoline (liters) should be added to the high concentrated solutionin order to have the 50-50 % mixture? Ans: 62.4
A wastewater treatment plant has been operating with the following specifications:flow rate = 7,630 m3/d, aeration tank volume = 1,270 m3, mixed liquor volatile suspendedsolids = 2,600 mg/l. The soluble BOD in the plant influent used to be 133 mg/l, but hasrecently changed to 222 mg/l. What is the new MLVSS this plant should use to maintain thesame F/M ratio as before? (Ans. Xnew = 4,340 mg MLVSS/l)
A 25 ml of sewage water sample was refluxed with 10 ml 0f 0.25 N K2Cr2O7 solution. The untreated dichromate requires 6.5 ml of 0.1 N FAS.10 ml of dichromate solution and 25 ml distilled water , under the same condition as sample required 27 ml of 0.1N FAS. Calculate the COD of sewage.
The below figure shows a pump that transfers a steady stream of 35 API crude oil from an oil tanker to a refinery storage tank, both free surfaces being open to the atmosphere. The effective length-including fittings-of the commercial steel pipe is 6,000 ft. The discharge at point 4 is 200 ft above the pump exit, which is level with the free surface of oil in the tanker. However, because of an intervening hill, point 3 is at a higher altitude than point 4. Losses between points 1 and 2 may be ignored. The crude oil has the following properties: Density p= 53 lbm/ft; Viscosity u= 13.2 cP3; Vapour Pressure Pv = 4.0 psia 1,000 ft 5,000 ft Storage tank 200 ft Oil tanker W hp
Questions: 1. The jar testing apparatus uses batch reactors, while a real treatment plant rapid mixing unit is using a completely mixed continuous flow reactor. Do you expect to have the same turbidity removal efficiency in both cases using the same optimum alum dosage? (written response). -Name of person who completed.
What is the standard level of potassium concentration that can be found on wastewater ?
Need solution in 30 min
(0 Awastewater sample is being analyzed to determine its BOD content. The sample is diluted in order to perform the test: 295 ml. of distilled water are added to 5 ml of sample to fill the 300 ml BOD bottie. The bottle has an initial dissolved oxygen concentration of 7.9 mg/L After incubating 5 days, the dissolved oxygen concentration is 45 mg/L a. What is the S-day BOD of the wastewater? h. The deoxygenation rate constant, k. is 0.013 day What is the ultin BOD of the wastewater? ) A community normally levies a sewer charge of 20 cents/m' (S0.20/m).

SEE MORE QUESTIONS

Recommended textbooks for you

Solid Waste Engineering

Civil Engineering

ISBN:

9781305635203

Author:

Worrell, William A.

Publisher:

Cengage Learning,

Solid Waste Engineering

Civil Engineering

ISBN:

9781305635203

Author:

Worrell, William A.

Publisher:

Cengage Learning,

SEE MORE TEXTBOOKS