A three-phase A-connected generator has an inter-nal impedance of 9 + j90 m2/þ. When the load isremoved from the generator, the magnitude of theterminal voltage is 13,800 V. The generator feeds aA-connected load through a transmission line withan impedance of 20 + j180 m2/þ. The per-phaseimpedance of the load is 7.056 + j3.417 N.a) Construct a single-phase equivalent circuit.b) Calculate the magnitude of the line current.c) Calculate the magnitude of the line voltage atthe terminals of the load.d) Calculate the magnitude of the line voltage atthe terminals of the source.

Since it has 4 sub parts we will answer the first two sub parts . If you want the remaning please…

A three-phase A-connected generator has an inter- nal impedance of 9 + j90 mN/4. When the load is removed from the generator, the magnitude of the terminal voltage is 13,800 V. The generator feeds a A-connected load through a transmission line with an impedance of 20 + j180 mN/4. The per-phase impedance of the load is 7.056 + j3.417 N. a) Construct a single-phase equivalent circuit. b) Calculate the magnitude of the line current.

A three-phase A-connected generator has an inter- nal impedance of 9 + j90 mN/4. When the load is removed from the generator, the magnitude of the terminal voltage is 13,800 V. The generator feeds a A-connected load through a transmission line with an impedance of 20 + j180 mN/4. The per-phase impedance of the load is 7.056 + j3.417 N. a) Construct a single-phase equivalent circuit. b) Calculate the magnitude of the line current.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.19P: Consider a single-phase load with an applied voltage v(t)=150cos(t+10)volts and load current...

See similar textbooks

Similar questions

If the load is connected to the generator thgrough an inductive line and the voltage at the load side is the same as the voltage at the terminals of the generator, which of the following must be true? O A. The reactive power is flowing from the generator to the load and from load to the generator at the same time. O B. The load is disconnected, and no power is delivered to the load. O C. The load has a poor power factor and it's absorbing too much reactive power. O D. None of the other choices are correct O E. The generator is unable to produce reactive power; therefore, the reactive power is flowing from the load to the generator.
Suppose you have a three-phase generator that provides 120 Vac per phase and works at a frequency of 60 Hz, this generator can be connected in both delta and star. Also consider the following 6 load impedances, which will be connected at the same time to the generator as follows: ZA, ZB and Zc are connected in star, while Zp, Zg and Zp are connected in delta. j20 j3n Za j20 ZA j30 j3n -j20 j 30 -j20 Zo -j20 ZE j30 -j2n j 3n. ZF Assume the generator is star-connected with neutral, calculate total system power, total power factor, and current in neutral.
A load has a leading power factor. a) Is it a capacitive or inductive load? b) Is the reactive power positive or negative? c) Repeat for a load with lagging power factor
Suppose you have a three-phase generator that provides 120 Vạc per phase and works at a frequency of 60 Hz, this generator can be connected in both delta and star. Also consider the following 6 load impedances, which will be connected at the same time to the generator as follows: ZA, ZB and Zc are connected in star, while Zp, Zg and Zp are connected in delta. j20 Za -j20 ZA j 30 j 30 -j20 j3a -j20 Zo -j20 ZE j30 -j20 j 30. Assume the generator is star connected with no neutral, calculate the total power of the system and the total power factor. mm m
A 100-MVA synchronous generator supplies 62.5 MVA of power at 0.8 lagging power factor. The reactance between the load and the generator is normally 1.0 pu, but it increases to 3.0 pu because of a sudden three-phase short circuit. The fault is subsequently cleared and the generator then supplies 43.75 MVA at 0.8 lagging power factor. Determine the critical clearing angle. Select one: a. 88.58 b. None c. 78.58 d 68.58
A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a 3-phase transmission line as shown in figure. The neutral of the alternator and the star point of the load are solidly grounded. The phase voltages of the alternator are Ea = 1020°, Eb = 102-90°, Ec = 10/120⁰ E E E The positive sequence component of the load current is (A) 1.3102-107⁰ A (B) 0.332Z –120° A (C) 0.9962-120° A (D) 3.5104-81⁰ A +) + j1.002 0000 j1.002 0000 j1.0Ω vovo j1.0Ω 0000 j2.002 voor j3.002 oooo
Suppose you have a three-phase generator that provides 120 Vac per phase and works at a frequency of 60 Hz, this generator can be connected in both delta and star. Also consider the following 6 load impedances, which will be connected at the same time to the generator as follows: ZA, ZB and Zc are connected in star, while Zp, Zg and Zp are connected in delta. 10 ZA j 20 j30 Za j20 j30 j3Ω -j20 j3a -j2n Ze Zo •j20 j 30 j30. ZE -j20 Assume the generator is connected in delta, calculate the total power of the system and the total power factor.
Given the following phase currents: Ia= 3.5+j3.5; Ib=-j3; and Ic+-2.6+j1.5. Determine the negative sequence current for phase A. A. 0.313+j0.678 B. -0.313 -j0.678 C. -0.313+j0.678 D. 0.313-j0.678
H* 3G zain IQ Asiacell The generator convert from PV to PQ if the active power of the generator exceed the * maxinum and minimum limits between the maximum and mimium limit equal to the load power Non of them With base voltage of 450 kV. The actual voltage of the generator is 560 kV. The magnitude voltage in the parameter of the PV generator in the nepaln software is * O 1.2444 pu O 450 kV O 124.44 % O 0.8036 pu 80.36 % Non of them
Two three-phase alternators operate in parallel and the excitation is such that theinduced emfs are 1 kV/ph. The load admittance is (0,427 – j0,214) S. Theadmittance/phase of the machines are (0,0262 – j0,499) S and (0,0218 – j0,312) Srespectively. The emf of B leads A by 10°e. Calculate:(a) the terminal voltage(b) the current supplied by A(c) the power factor of B
An alternator is at lagging power factor when it is normally excited O True O False
A 3 phase 50 Hz alternator is connected to the bus bars through an oil circuitbreaker. Due to short circuit occurring at bus bars, the circuit breaker opens when the r.m.s value of the current was 8000 amperes. The reactance of each phase of the alternator is 2.5 mH and the capacitance to earth between the circuit breaker and the alternator is 1.4 x 10^-7 uF. Determine: (i) Frequency of oscillations(ii) The maximum value of RRRV(iii) Time taken to achieve RRRV value in (ii)