A cylinder of internal cross-sectional area 2 sq.m. is submerged in a liquid to a depth of 1 m. The cylinder is initially empty and contains a plugged orifice of diameter 20 mm in the bottom. The orifice has a discharge coefficient approximately equal to unity. If the plug is removed, how long will it take the cylinder to fill to the level of the surrounding liquid?

Q: This is an open-top cylindrical tank* height of tank = 4 meters diameter of tank = 2 meters The…

A:

Q: A vertical cylindrical tank is 9 m high and 5 m in diameter. It is two thirds full of water and is…

A: Solution 1) Solution Given Data Cylindrical tank height= 9 m Diameter= 5 m Rotational speed= 48 rpm

Q: A nozzle is so shaped that the velocity of flow along the centre line changes linearly trom 1.5 m/s…

A:

Q: In Figure 6 is shown a siphon discharging water from reservoir A into the air at B. Distance 'a' is…

A:

Q: An air-filled, hemispherical shell is attached to the ocean floor at a depth of 9.1 m as shown in…

A:

Q: A nozzle of inner radius 1.06 mm is connected to a hose of inner radius 9.05 mm. The nozzle shoots…

A:

Q: Three pipes of different lengths and diameters connected in series, discharges 160 liters per…

A:

Q: 4. The siphon shown is 76 mm in diameter. It draws oil from a large tank. The loss of head up to the…

A:

Q: Calculate the volume and surface area of a solid cylinder 1.5 m diameter and 2.5 m tall.

A: Given- Solid cylinder-Diameter d=1.5 mHeight h=2.5 m

Q: Steady-state flow exists in a pipe that undergoes gradual expansion from a diameter of 15 cm in to a…

A: "SInce, you have asked multiple question, we will solve the first question for you. if you want any…

Q: 11. A liquid flowss through two similar pipes 1 and 2. If the ratio of their flow velocities v1 : v2…

A: Head loss is directly proportional to the square of velocity.

Q: Freshwater and seawater flowing in parallel horizontal pipelines are connected to each other by a…

A:

Q: An open tank has a vertical partition and on one side contains gasoline with a density p = 700 kg/m³…

A: Gate will start to open when the force from water side will be greater than gasoline side When Force…

Q: Problem- The circular base of a cylindrical tank is of 1 m diameter and has an orifice of 10 cm…

A: Given- dia d=1 morifice dia=10 cm=0.10 mCd=0.6discharge Q=0.025 m3/s

Q: 2. An open U-tube having a diameter of 12mm contains mercury at a depth of 130mm. If 0.014 liters of…

A:

Q: An oil of density 892 kg/m³ is flowing in a pipe having an internal diameter 5cm. This pipe is…

A:

Q: A sharp-edged circular nozzle with a cross-sectional area of 10 cm2. Water flows from it under the…

A: Actual velocity calculation:…

Q: A sealed vertical cylinder 1.2m in diameter and 3m high is filled with gasoline whose density is 740…

A: Given data:

Q: The depth of water in a cylindrical tank 4 m in diameter is increasing at the rate of 0.7m/min. Find…

A: Diameter,d=4m Depth,h=0.7m Volume of the tank,V=πd2h/4=π × (4)2 ×0.7/4=8.796m3

Q: A series of three parallel pipes connect the bottom of two reservoirs. All pipes are made of the…

A:

Q: A capillary tube of internal diameter 0.21 mm is dipped into a liquid whose density is 0.79 g cm.…

A:

Q: The figure shows two reservoirs connected by a pipe. The discharge rate in the pipe is known to be…

A: Bernoulli's Equation: Bernoulli’s equation formula is a relation between Kinetic energy, pressure,…

Q: Calculate the theoretical discharge through a vertical orifice 0.3 m square in the side of a tank if…

A: Given:- The side of the vertical orifice = 0.3 m  The free surface of the liquid in the tank  above…

Q: A circular pipe of diameter 0.5 m carries the discharge of 50 liters/s. The head loss due to…

A:

Q: HYDRO EXPERIMENT NO.3 3. Calculate the theoretical discharge through a vertical orifice 0.3 m square…

A:

Q: Two reservoirs are filled with kerosene, each having a cross-sectional area of 300 mm2. The…

A: Given Data  Pa - Pb = 40 Pa Density of mercury = 13550 kg/m3 Density of kerosene = 814 kg/m3

Q: A nozzle is so shaped that the velocity of flow along the centre line changes= linearly from 1.5 m/s…

A: Acceleration determined due to the variation of velocity with respect to time in the nozzle…

Q: A pipe 2000 m in length with a flow rate of 2 m /s. At the end of the 600 mm pipe, a valve is…

A: To determine the pressure due to closure of valve.   Given, Length of the pipe (L) = 2000 m Flow…

Q: Three new cast-iron pipes connected in series have diameters of 30 cm, 25 cm, and 20 cm, each being…

A: Given data  Diameter  Discharge  Minor loss To find Total head loss EGL & HGL

Q: A 2.5-meter square vertical tank 4 m high contains 3.5 m of oil (s.g. = 0.82) [reckoned from the…

A:

Q: Edible oil (specific gravity = 0.83) flows through a venturi meter with a range of flow rates from…

A:

Q: Two pipes 1 and 2 having the same length and diameter are in parallel. If the flow in pipe 1 is 750…

A:

Q: Situation #3: Upstream in a conduit where the diameter is 250 mm, the density of a gas flowing at…

A:

Q: A 10 cm diameter sharp edged orifice (C=0.60) is located at the vertical side of a tank having a…

A:

Q: 3. Calculate the theoretical discharge through a vertical orifice 0.3 m square in the side of a tank…

A: We will solve this question in step no. 2

Q: A nozzle of inner radius 1.06 mm is connected to a hose of inner radius 9.05 mm. The nozzle shoots…

A:

Q: The flow of water in a pipe of about 3 meters in diameter can be measured by a. venturimeter b.…

A: Venturimeter:- Venturimetre is a device used for measuring the rate of flow of fluid flowing through…

Q: A sharp-edged orifice having a diameter of 0.0285 m is installed in a 0.25-m pipe through which a…

A:

Q: 10 cm diameter sharp edged orifice (C=0.60) is located at the vertical side of a tank having a…

A:

Q: Two reservoirs are connected by two parallel pipes of equal length and of diameters 20 cm and 10 cm,…

A: To Determine the ratio of discharge in the larger diameter pipe to the discharge in the smaller…

Q: 4. The siphon shown is 76 mm in diameter. It draws oil from a large tank. The loss of head up to the…

A:

Q: An air-filled, hemispherical shell is attached to the ocean floor at a depth of 9.4 m as shown in…

A:

Q: A cylinder glass tubing 2.8 cm. inside diameter and 90 cm long with one end closed is immersed…

A:

Q: A circular water tank of 2 m diameter has a circular orifice of diameter 0.1 m at the bottom. Water…

A:

Q: An air-filled, hemispherical shell is attached to the ocean floor at a depth of 9.4 m as shown in…

A:

Q: 4. The siphon shown is 76 mm in diameter. It draws oil from a large tank. The loss of head up to the…

A:

Q: Three pipes of different lengths and diameters connected in series as shown discharges 160 liters…

A:

Q: In a pump that works with cold water, the discharge pressure gauge located 7.5 m above the axis of…

A: Head of the pump: The maximum height that a pump achieves the pumping against the gravity is known…

Q: A liquid rises to a height of 9 cm in a glass capillary tube of diameter 0.04 cm. What will be the…

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?