Using a graduated cylinder, you measure out 250 mL ethanol, which has a density of 0.789 g/mL You transfer this to a previously tared beaker and measure the mass. Repeating this process three times, you obtain the following measurements: • 195.31 8 • 194.78 8 • 194.62 g Report a calculation that indicates the accuracy of the data shown above. (Blank #1) Report a calculation that indicates the precision of the data shown above. (Blank #2) Based on your calculations for accuracy and for precision, do you think any errors occurred in obtaining the measurements? Explain your answer in 1-2 sentences. (Blank #3) Answer for blank # 1: Answer for blank # 2: Answer for blank # 3:

Q: Use significant figures to express the inherent uncertainty in measured quantities and in…

A: The uncertainty in a measurement is an estimate of the amount by which the measurement result may…

Q: If I have a measurement of a diameter using a ruler with increments in mm: 1.70cm diameter then…

A: For multiplication and division: The least of significant figures in any number of the question…

Q: The concentration of mercury in a polluted lake is 0.33 micrograms per liter of water. What is the…

A: Given,Volume of the lake = 1.5 x 1012cm30.33 micrograms per liter of water

Q: From 1967 until 1999, Canadian 10¢ and 25¢ coins were made of pure nickel which has a density of…

A: The solution of the given question is

Q: Mass of Empty Beaker: 44.653 g Mass of Beaker and Metal sample: 124.411 g Initial volume of water…

A:

Q: A sample of metal pellets weighs 13.54 g. When this sample was placed in a 100-mL graduated…

A: Calculate the volume of metalVolume of metal = 27.0 mL – 25.5 mL = 1.5 mL = 1.5 cm3Calculate the…

Q: A brick of metal has these dimensions:  7.07 in  x 9.20 in x 7.15 in.  It has mass 8.1 kg.  What is…

A:

Q: Which one of the following is the longest length? (1 ft = 12 in, 1 in = 2.54 cm) 3.2 m, 145 in,…

A: The given values are in different units. First all the values have to be converted into one single…

Q: The diameter of a copper (Cu) atom is roughly 1.3 x 10-10 m. How many times can you divide evenly a…

A: Given :- Length of copper wire = 10 cm Diameter of wire = 1.3 × 10-10 m

Q: What is the speed of light in miles per second? Express your answer in scientific notation. The…

A: Given: The speed of light in m/s is 299,792,458 m/ s.

Q: A student performs an experiment to determine the density of a sugar solution. She obtains the…

A: Accurate measurement :- A measurement is said to be accurate if it is very close to the actual…

Q: 2. The volume of a block-shaped object can be calculated using the formula: volume = length X width…

A:

Q: Two students measure and record the volume of the same sample of water in the graduated cylinder…

A: The reading of the volume of the graduated cylinder depends on the distance between the two nearest…

Q: A student measured the length and mass measurements of a cube using the same equipment as in the…

A: Density=MassVolume

Q: The unit of weight used for precious stones is the carat (1 carat=200 mg ,exactly).If a particular…

A: Conversion of carat into mg: 1 carat=200 mg1.25 carat=1.25×200=250 mg Conversion of mg into g: 1…

Q: Measurement of the density of water. Weigh a small beaker (degree of precision?). Place about 25 mL…

A:

Q: A student sets up the following equation to convert a measurement.

A: Unit converstions :  1. mole unit conversion:    1 mol = 103 mmol        where mmol stands for…

Q: A thin sheet of nickel measured 5.00 cm by 7.00 cm was found to weigh 0.350 g. If the density of…

A: Given : Mass of Nickel sheet = 0.350 g Length of sheet = 5.00 cm  Width of sheet = 7.00 cm

Q: A.Measurement of the density of water.Weigh a small beaker (degree of precision?). Place about 25 mL…

A: Here we need to calculate the density of the water. We know that, density is defined as the mass per…

Q: A student working in the lab is trying to identify an unknown substance to see if it matches a…

A: Given Data - mass of the object, m         = 88.73 g  density of the substance, d = 5.76 g/mL…

Q: When converting from kilometers to centimeters how many places does the decimal move to the right?…

A: Since you have posted multiple questions, the answer for first question is given below. Kindly…

Q: You are supplied with another cylinder made of the same material. If the cylinder length is 1.83…

A: Volume of the cylinder can be determined from its length and radius. Mass of the cylinder can be…

Q: The beakers shown below have different precisions. a. Label the amount of water in each of the three…

A: Three different beakers are shown in the picture with different precision.

Q: The density of manganese is 7.21 g/mL, that of calcium chloride is 2.15 g/mL, and that of sodium…

A: Given: The density of manganese = 7.21 g/mL The density of calcium chloride = 2.15 g/mL The density…

Q: A student performs an experiment to determine the density of a sugar solution. She obtains the…

A: In measurement of a set, accuracy is closeness of the measurements to a specific value, while…

Q: 1. In mL what is the volume of liquid in the burette pictured on the right (to the correct number of…

A: Three questions based on quantitative analysis, which are to be accomplished.

Q: "A metal with a mass of 107.1g was placed into a graduated cylinder and completely submerged. The…

A: It is known that the density is the mass per unit of volume. Density = MassVolume d = mV

Q: The weight of a metal sphere was measured to be 9.81 g. Unfortunately, the caliper that was supposed…

A: Given : weight of a metal sphere = 9.81 g  Density = 7.26 g/cm3 To find : Radius of metal surface…

Q: Keeping track of units during conversions can get confusing. Therefore, a good strategy is to use…

A: We will use conversion factor to convert each term in question.

Q: The prescribed dose of an injected drug is 1.5 mL. If the syringe is graduated in cubic centimeters…

A:

Q: After taking measurements of a rectangular solid with a mass of 3.84g, you determined the length to…

A:

Q: 5) A student correctly determines that 17.1 grams of sucrose are needed to make 50 ml of a 1M…

A: ANSWER 5 .  We know that the concentration term i.e.,  Molarity (M) =  Moles of solute / Volume of…

Q: 1. The student obtains 15 g of an unknown substance. 2. The student notes that at room temperature…

A: Extensive properties are the properties that depends upon the amount of matter in a sample

Q: The density of aluminum is 2.70 g/cm3. if 10.00 g of aluminum pellets is added to a graduated…

A: Density is a measure of mass per unit volume. The average density of an object equals its total mass…

Q: In the lab, a student determines the density of a metal object by measuring its mass on a balance…

A: Calculate the volume of the object:

Q: Three blocks of the same mass are placed in front of you. Block A has a volume of 3.0 cm2, block B…

A: We know that density is mass by volume. Density=massvolume That means density is directly…

Q: Q1: Fill the below situations in the table Chemical change Physical change • Melting of wax…

A: (1) There are different type of changes in nature, some of them are physical changes, where no any…

Q: my results are the first pic

A: Hi there, as there are multiple questions posted. We are answering the first question. If you need…

Q: Enter your answer in the provided box. Carry out the following calculation, paying special attention…

A: Given that : We have to perform the following calculation keeping in mind the significant figure :

Q: A student determined in a set of four experiments that the density of magnesium metal was 1.66…

A: The data is given as follows: 1.66 g/mL, 1.65 g/mL, 1.67 g/mL, and 1.67 g/mL Accepted value for…

Q: 1. Why are the calibration marks on laboratory beakers taken only to be an approximate guide to…

A: Calibration marks on the laboratory beakers and the volumetric flasks are present to accurately…

Q: (1.7) A student performs an experiment to determine the density of a sugar solution. She obtains the…

A: Accuracy- It is closeness of obtained experimental value to the actual value. Precision- It is…

Q: Perform the following conversions. You must use dimensional analysis and put your answer in…

A: Here by using unit and dimensional analysis we have to solve the following conversions. For this we…

Q: Azelastine hydrochloride is an antihistamine nasal spray. A standard-size container holds one fluid…

A:

Q: Because of the high heat and low humidity in the summer in Death Valley, California, a visitor…

A: Given that, 1 quart = 0.946 L 1 mi = 1.61 km 1 g water = 1 mL water

Q: In an experiment regarding measurements and significant figures, one student weighed an object using…

A: The student used a triple-beam balance for the measurement.

Q: What is the total weight of the prepared paper tabs? * Your answer What is the weight needed to…

A: Solution: A pharmacist was tasked to prepare 10 paper tabs from a 20 mg tablet. A discrepancy of…

Q: A scientist performs an experiment to determine the density of a sugar solution.  He obtains the…

A: Accuracy refers to how closely a measured value relates to the true value. Precision refers to how…

Q: The density of titanium is 4.54 g/mL. What is the mass, in grams, of 17.3 mL of titanium? Check your…

A: Given: density of titanium = 4.54 g/mL Volume of titanium = 17.3 mL

States of Matter

The substance that constitutes everything in the universe is known as matter. Matter comprises atoms which in turn are composed of electrons, protons, and neutrons. Different atoms combine together to give rise to molecules that act as a foundation for all kinds of substances. There are five states of matter based on their energies of attraction, namely solid, liquid, gases, plasma, and BEC (Bose-Einstein condensates). 

Chemical Reactions and Equations

When a chemical species is transformed into another chemical species it is said to have undergone a chemical reaction. It consists of breaking existing bonds and forming new bonds by changing the position of electrons. These reactions are best explained using a chemical equation.