Answered: Type of interference that occurs at any…

Type of interference that occurs at any location along the medium where the two interfering waves have a displacement in the same direction. Free-End Constructive Destructive Loose-End

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter37: Wave Optics

Section: Chapter Questions

Problem 37.7CQ: What is the necessary condition on the path length difference between two waves that interfere (a)...

See similar textbooks

Related questions

Q: Determine the equivalent resistance between terminals a and b. R1 ww 10 Ohms R3 5 Ohms R4 www 13…

Q: Suppose a wave whose expression is given as y(t) = Asin(27Ft), where y is the vertical displacement…

A: Required amplitude(A) of wave

Q: A 4.7 g marble is fired vertically upward using a spring gun. The spring must be compressed 5.0 cm…

Q: The circuit below has a voltmeter that reads 6-V connected, in parallel, to resistor with unknown…

A: Given DataI=3mARE=3kΩVs=6V

Q: Determine the equivalent resistance between terminals a and b 6.3498 Q O 6.3333 Q O 6.27140 O 6.2987…

Q: Transverse waves on a string have wave speed of 8.00 m/s, amplitude of 0.0700 m, and wavelength of…

A: Z= A cos(kx - wt) Z= displacement of wave A= amplitude. = 0.07m K= propagation constant =…

Q: What is the tension force present on the string attached to the ceiling making an angle of 34° if a…

Q: Determine the equivalent resistance between terminals b and d. mw www 5 ohms 10 ohms 8.1688 ohms;…

Q: In the given circuit, R₁= 6 ohms, R2 = 3 ohms and R3 = 5 ohms. The battery has negligible internal…

Q: What is the work done by a 256W electric grinder in three minutes? 36 080 J 56 230 J 26 550 J O46…

Q: Determine the equivalent resistance between terminals a and b. 10 ohms a O ww 15 ohms 20 ohms 24…

A: given - circuit to find - equivalent resistance between a and b

Q: The current through a 10-ohm lamp energized by two series-opposing ideal batteries is measured to…

Q: A heart defibrillator is used to enable the heart to start beating if it has stopped. This is done…

A: Given data: Current (I) = 12 A Voltage (V) = 25 V Time (t) = 3 ms = 0.003 s Required: The Energy…

Q: 9. For the following circuit the resistances are: R₁ - 2202, R₂ - 360, R₂-5400. Calculate the total…

A: Given that R1=220ohm R2=360 ohm R3=540 ohm To determined that- calculate the total resistance of the…

Q: Given two batteries: one with voltage V and internal resistance r1; another with also voltage V and…

A: Here two batteries each having voltage V and internal resistance r1 and r2 are connected with…

Q: What Richter scale rating would be 5 times more intense than a Richter scale rating of 6?

A: The Richter scale defines the magnitude of an earthquake to be R=logII0…

Q: Given two batteries: one with voltage V and internal resistance r₁; another with also voltage V and…

A: Here two batteries are each with voltage V and their internal resistance are r1 and r2 .

Q: A sinusoidal wave traveling in the positive x direction has an amplitude of 30.0 cm, a wavelength of…

A: Given data: Frequency (f) = 16.0 Hz

Q: Suppose a wave whose expression is given as y(t) = A sin (27Ft), where y is the vertical…

A: Given, Expression of wave is y(t)= A sin(2πFt) Wave complete one cycle in 20milliseconds ( time…

Q: Moira and Jason are in a space craft. Jason confesses to Moira of infidelity and moves to the…

Q: Transverse waves on a string have wave speed of 8.00 m/s, amplitude of 0.0700 m, and wavelength of…

A: The wave function describing the motion of transverse wave is given by the following equation y =…

Q: Initially, a circuit is composed of a DC source and two resistors, R₁ and R₂, connected in series…

Q: One end of a horizontal rope is attached to a prong of an electrically driven tuning fork that…

A: Write the expression for the velocity of the transverse wave. Here, T represents the tension, m…

Q: n arrow is shot from height of 1.5 m toward to a cliff of height H. It is shot with a velocity of 25…

Q: Steady-state flow exists in a pipe that undergoes a gradual expansion from a diameter of 6 in. to a…

Q: Consider n parallel-connected resistors each having resistance of R. Which of the following is true…

A: Given Resistance of each resistors is R. Number of resistors is n. All the resistors are connected…

Q: Determine the equivalent resistance between terminals a and b. M 10 ohms 10 ohms 10 ohms O b 10 ohms…

Q: One end of a horizontal rope is attached to a prong of an electrically driven tuning fork that…

A: Speed of wave in rope V= √(T/u) T= tension force = mg m= mass of pulley = 1.5kg T= 1.5×9.8 = 14.7…

Q: The circuit below has a voltmeter that reads b-V connected, in parallel, to resistor with unknown…

A: Given Reading in the voltmeter is V=6 V Reading the ammeter is i=3 mA=3×10-3 A We have to find the…

Q: A fisherman notices that his boat is moving up and down in a periodic way because of waves on the…

Q: Consider n parallel-connected resistors each having resistance of R. Which of the following is true…

Q: In order to perform an experiment on electric circuits, a student has to use a 6-ohm resistor, but…

A: First option is correct.

Q: Given two batteries: one with voltage V and internal resistance r₁; another with also voltage V and…

A: Equivalent emf of two cells when are in series E = E1 + E2 And, equivalent internal resistance in…

Q: . Another of the 82 moons of Saturn is named Rhea, which accelerates slower than the planet. 3.…

Q: 1. To determine the magnetic force on a moving charge, the following are needed except a. velocity…

A: The first three MCQ questions are answered below as per the guidelines by Bartleby.com.

Q: Type of interference that occurs at any location along the medium where the two interfering waves…

Q: 1) The total magnetic field to any current carrying conductor can be solved by a integration b…

A: In physics and chemistry, the law of conservation of energy states that the total energy of an…

Q: .. 10.17 A 12.0-kg box resting on a horizontal, frictionless surface is attached to a 5.00-kg weight…

Q: Which of the following is true about resistors that are connected in series? O The reciprocal of the…

A: Two resistances are said to be connected in series when they are connected end to end.

Q: A cord that has a mass of 0.79 kg is stretched between two supports specifically 45 m apart. If the…

A: From the given information we will calculate the speed of the wave and then the time requires to…

Q: What is the kinetic energy of a 900 kg car whose velocity is 16.67 m/s? O 15.0 kJ 125 kJ 12.5 kJ O…

A: Given Mass of car = m = 900 kg Velocity = v = 16.67 m/s We have to calculate the kinetic energy of…

Q: Determine the equivalent resistance between terminals a and b. R1 1 Ohm O 6.2714 Q 6.2987 Q 6.3333 Q…

Q: the two batteries if the magnitude of the current through the same lamp becomes 2 amperes when the…

Q: etemine the equiva Ο 6.8750 Ω O 5.8750 Q O 5.2589 Q O 6.2589 Q a R1 5 Ohms R4 3 Ohms R2 3 Ohms R5 6…

Q: A wave is made by swinging one end of a string, while the other end is held stationary. Pulling the…

A: Given, Tensionfinal=4Tensioninitial Tf= 4Ti

Q: The force of magnitude F-93 lb acts along the edge of the triangular plate. Determine the moment of…

Q: Four light bulbs, rated at 100 W, 75 W, 50 W and 25 W each, are in parallel. What is the total power…

A: Given Data, Power of the four bulbs are = 100 W, 75 W, 50 W, 25 W

Q: A gas in a sealed container has a pressure of 125.0kPa at 30.0 °C. Determine thetemperature in the…

A: We know thatPV=nRTHereP=pressureV=Volumen=number of moleR=Gas constantT=temperature

Q: it estimated that eight medium pizzas are about right to serve a physics club meeting of 32…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 20. Consider the voltage phasor diagram of an AC circuit shown below. What is the value of the…

A: Given that Io= 5A ωt=60 To determine that what is value of voltage at that instant?

Concept explainers

Interference of Light

The word "constructive" signifies addition in interference. Constructive interference occurs when the path of the waves that start from the slit differs by 1 entire wavelength or in the intervals of the same. Hence, the waves that are presented on the screen are in phase (crest to crest/trough to trough). The waves interfering constructively forms bright fringes on the screen.

Question

Type of interference that occurs at any location along the medium where the two interfering waves have a displacement in the same direction.
O Free-End
Constructive
Destructive
Loose-End

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An intensity minimum is found for 450 nm light transmitted through a transparent film (n=1.20) in air. (a) What is minimum thickness of the film? (b) If this wavelength is the longest for which the intensity minimum occurs, what are the next three lower values of ? for which this happens?
What is the necessary condition on the path length difference between two waves that interfere (a) constructively and (b) destructively?
An aircraft maintenance technician walks past a tall hangar door that acts like a single slit for sound entering the hangar. Outside the door, on a line perpendicular to the opening in the door, a jet engine makes a 600-Hz sound. At what angle with the door will the technician observe the first minimum in sound intensity if the vertical opening is 0.800 m wide and the speed of sound is 340 m/s?
Red light of wavelength of 700 nm falls on a double slit separated by 400 nm. (a) At what angle is the first-order maximum in the diffraction pattern? (b) What is unreasonable about this result? (c) Which assumptions are unreasonable or inconsistent?
A pulse is traveling towards the boundary, from a more dense medium to a less dense medium. iun2 Less Dane The wave will O a. only reflect to medium 1 O b. only transmit to medium 2 reflect as well as transmit from the boundary of two media O d. produce interference
Iftwo beams from two identical sources overlap, the fringing will result on the screen. If you know that the phase difference Between the two beams it will generate an intensity of k when the path difference is equal to A. Whatis the magnitude of the intensity at a point on the screen Then the path difference is equal to 2/A.
Noticeable diffraction will not occur when a the slit of an opening is double the magnitude of the wavelength of a wave incoming. a. True b. False
A pulse is traveling towards the boundary, from a more dense medium to a less dense medium. Mdim 1 Mdim2 Mue De Less Dse The wave will O a. reflect as well as transmit from the boundary of two media O b. produce interference Oc. only reflect to medium 1 O d. only transmit to medium 2
A phase change occurs whenever light reflects off of a medium with a lower refractive index than the medium that the light is currently in. O True O False Constructive interference only occurs for a thin film with an even number of phase changes. True False
A pulse is traveling towards the boundary, from a less dense medium to a more dense medium. Medium 1 Hedium 2 Less Dense Hore Dense The wave will O a. reflect as well as transmit from the boundary of two media O b. produce interference O c. only transmit to medium 2 O d. only reflect to medium 1
For the given boundary, what is the angle between the incident and reflected wave ? ee Boundary incident wave O a. O radian O b. TT radian Ос. TT radian O d. 2T radian
MY NOTES In the figure below (not to scale), let L-1.20 m and d 0.150 mm and assume the sit system is illuminated with monechromatic 430-em ight. PRACTICE ANOTHI Viewing screen (a) Calculate the phase difference between the two wave fronts arriving at Pwhen 0.500 rad (b) Calculate the phase difference between the two wave fronts arriving at Pwhen y 5.00 mm. rad (c) What is the value of e for which the phase dfference is 0.333 rad? (d) What is the value of e for which the path difference is A/ 47