Susan's 13.0 kg baby brother Paul sits on a mat. Susan pulls the mat across the floor using a rope that is angled 30° above the floor. The tension is a constant 28.0 N and the coefficient of friction is 0.210. Part A Use work and energy to find Paul's speed after being pulled 2.70 m Express your answer with the appropriate units. μA Value Units ?

Susan's 13.0 kg baby brother Paul sits on a mat. Susan pulls the mat across the floor using a rope that is angled 30° above the floor. The tension is a constant 28.0 N and the coefficient of friction is 0.210. Part A Use work and energy to find Paul's speed after being pulled 2.70 m Express your answer with the appropriate units. μA Value Units ?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter7: Work And Kinetic Energy

Section: Chapter Questions

Problem 71P: (a) What is the average useful power output of a person who does 6.00106J of useful work in 8.00 h?...

See similar textbooks

Similar questions

(a) A child slides down a water slide at an amusement park from an initial height h. The slide can be considered frictionless because of the water flowing down it. Can the equation for conservation of mechanical energy be used on the child? (b) Is the mass of the child a factor in determining his speed at the bottom of the slide? (c) The child drops straight down rather than following the curved ramp of the slide. In which case will he be traveling faster at ground level? (d) If friction is present, how would the conservation-of-energy equation be modified? (e) Find the maximum speed of the child when the slide is frictionless if the initial height of the slide is 12.0 m.
(a) How long would it take a 1.50105kg airplane with engines that produce 100 MW of power to reach a speed of 250 m’s and an altitude of 12.0 km if air resistance were negligible? (b) If it actually takes 900 s, what is the power? (c) Given this power, what is the average force of air resistance if the airplane takes 1200 s? (Hint: You must find the distance the plane travels in 1200 s assuming constant acceleration.)
Estimate the kinetic energy of the following: a. An ant walking across the kitchen floor b. A baseball thrown by a professional pitcher c. A car on the highway d. A large truck on the highway
. In the annual Empire State Building race, contestants run up 1,575 steps to a height of 1,050 ft. In 2003, Australian Paul Crake completed the race in a record time of 9 min and 33 S, Mr., Crake weighed 143 lb (65 kg) , (a) How much work did Mr., Crake do in reaching the top of the building? (b) What was his average power output (in ft-lb/s and in hp)?
The chin-up is one exercise that can be used to strengthen the biceps muscle. This muscle can exert a force of approximately 8.00 102 N as it contracts a distance of 7.5 cm in a 75-kg male.3 (a) How much work can the biceps muscles (one in each arm) perform in a single contraction? (b) Compare this amount of work with the energy required to lift a 75-kg person 40. cm in performing a chin-up. (c) Do you think the biceps muscle is the only muscle involved in performing a chin-up?
A horizontal force of 20 N is required to keep a 5.0 kg box traveling at a constant speed up a frictionless incline for a vertical height change of 3.0 m. (a) What Is the work done by gravity dining this change in height? (b) What Is the work done by the normal force? (c) What is the work done by the horizontal farce?
The chin-up is one exercise that can be used to strengthen the biceps muscle. This muscle can exert a force of approximately 8.00 102 N as it contracts a distance of 7.5 cm in a 75-kg male.3 (a) How much work can the biceps muscles (one in each arm) perform in a single contraction? (b) Compare this amount of work with the energy required to lift a 75-kg person 40. cm in performing a chin-up. (c) Do you think the biceps muscle is the only muscle involved in performing a chin-up?
(a) What is the average useful power output of a person who does 6.00106J of useful work in 8.00 h? (b) Working at this rate, how long will it take this person to lift 2000 kg of bricks 1.50 m to a platform? (Work done to lift his body can be omitted because it is not considered useful output here.)
. An elevator is able to raise 1,000 kg to a height of 40 m in 15 s. (a) How much work does the elevator do? (b) What is the elevator’s power output?
A large cruise ship of mass 6.50 107 kg has a speed of 12.0 m/s at some instant. (a) What is the ships kinetic energy at this time? (b) How much work is required to stop it? (c) What is the magnitude of the constant force required to stop it as it undergoes a displacement of 2.50 km?
(a) How long would it takea 1.50105 -kg airplane with engines that produce 100 MW of power to reach a speed of 250 m,/s and an altitude of 12.0 km if air resistance were negligible? (b) If it actually takes 900 s, what is the power? (c) Given this power, what is the average force of air resistance if the airplane takes 1200 s? (Hint: You must find the distance the plane travels in 1200 s assuming constant acceleration.)
(a) A block with a mass m is pulled along a horizontal surface for a distance x by a constant force F at an angle with respect to the horizontal. The coefficient of kinetic friction between block and table is k the force exerted by friction equal to kmg? If not, what is the force exerted by friction? (b) How much work is done by the friction force and by F? (Dont forget the signs.) (c) Identify all the forces that do no work on the block, (d) Let m = 2.00 kg, x = 4.00 m, = 37.0, F= 15.0 N, and k = 0.400, and find I the answers to parts (a) and (b). Figure P5.39