SCH 08 HW PSS 8.1: Static equilibrium problems To practice Problem Solving Strategy 8.1 Static equilibrium problems. When you at an object by moving only your forearm, the main lining muscle in your arm is the biceps. Suppose the mass of a forearm is 1.20 kg. If the biceps is connected to the forearm a distance d-3.50 cm from the elbow, how much force F exert to hold a 750 g ball at the end of the forearm at distance dua 30.0 ctn from the elbow, with the torearm parallel to the floor? How much force F must the elbow exert? (Boute 1) must the biceps Figure d Biceps Youll 1 of 1 Evaluate whether the answer you obtained for the force exerted by the biceps is reasonable. Part J M39.8 Although it is uncommon, orthopedic surgeons have seen patients who have tom their biceps tendon when forces of greater than 390 N have been exerted on the tendon with the arm bent at the elbow so that the forearm is parallel to the ground. What is the minimum mass of a ball Af such a patient might have held to cause the biceps tendon to fear? Express your answer in kilograms. A2+ Submit PA Revesteer X Incorrect: Try Again: 5 attempts remaining Review Constants Periodic Table ? 3 of 29 > ke

SCH 08 HW PSS 8.1: Static equilibrium problems To practice Problem Solving Strategy 8.1 Static equilibrium problems. When you at an object by moving only your forearm, the main lining muscle in your arm is the biceps. Suppose the mass of a forearm is 1.20 kg. If the biceps is connected to the forearm a distance d-3.50 cm from the elbow, how much force F exert to hold a 750 g ball at the end of the forearm at distance dua 30.0 ctn from the elbow, with the torearm parallel to the floor? How much force F must the elbow exert? (Boute 1) must the biceps Figure d Biceps Youll 1 of 1 Evaluate whether the answer you obtained for the force exerted by the biceps is reasonable. Part J M39.8 Although it is uncommon, orthopedic surgeons have seen patients who have tom their biceps tendon when forces of greater than 390 N have been exerted on the tendon with the arm bent at the elbow so that the forearm is parallel to the ground. What is the minimum mass of a ball Af such a patient might have held to cause the biceps tendon to fear? Express your answer in kilograms. A2+ Submit PA Revesteer X Incorrect: Try Again: 5 attempts remaining Review Constants Periodic Table ? 3 of 29 > ke

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

5 non-concurrent forces are acting on two rings connected by a line that resulted in equilibrium. can you help me solve this equilibrium of forces question using the polygon method? the pieces of string are tied to a massless rings. the forces acting on the ring are in gram-force. thank you.
igure 2. Assume that the rod is massless, perfectly rigid, and pivoted at point P. When the rod is perfectly horizontal, the angle 0 = 0, the displacement y 0, and the springs are in neither tension nor compression. Gravity acts on the system (e.g. on mass M). We assume that y is a small displacement. A mass M is attached at the end of the rod. DE only 225 Your tasks: X k 0 3k a F a M y A Derive an equation of motion for the system in terms of the angular displacement 0, and its derivatives (you should not have y or its derivatives in this equation.) B Derive an equation of motion for the system in terms of the displacement y, and its derivatives (you should not have or its derivatives in this equation. C Assuming there is no external actuator force F acting on the system, write down the total energy H of the system in terms of 0,0 and element constants. Derive an expression for the time derivative H of the total energy. D Transform the equation from part B, which is in y, to another…
5. The mass of the elevator cage is m, It moves downward with constant velocity vo by wire rope. The stiffness coefficient of wire rope is k. The mass is negligible. If the elevator stops abruptly during operation, what is the maximum tension of the wire rope? k m ko m Vo
Problem A person is doing leg exercises where a 100N weight linked via a pulley is attached to their heel. Based on a simplified system in which the quadricep muscles are the only active muscle group and can be modeled as a single muscle tension, what is the muscle tension and joint reaction force at the knee necessary to maintain this position. You can assume the quadriceps is attached to the tibia 5 cm below the knee, making a 15° angle with the horizontal. The weight of the leg is 120 N and the center of gravity is 0.35 m from the knee joint, and the length of the leg is 0.8 m. Make sure to draw a FBD of the lower leg. 100N Fm
Find the friction force C Fs), the force perpendicular to the contact sur face ( Normal Force , N. ), and the minimum force P that cau se objec } to move ( Fax) an of a crate of mass Sto kg. as shown in pietore a = 0.4 m b = 0.8 m C = 0.2 m m: 540 d = 3 e = 4 Hs = 0.5 Fs Nc
Muscle 2 E Muscle 1 0₁29 1 dM1 dM₂ dw Ow W dDB Ow Hand Dumbbell The figure provides a free body diagram of several forces acting about the elbow joint (E) for an isometric elbow flexion exercise. In this case, the subject is holding a 279 N dumbbell (located dpB = 48 cm from the elbow) in a stationary position. W is the combined weight of the forearm and hand (28 N) and acts through the CG of this system (located dw = 19 cm from the elbow). The forearm is elevated from the horizontal, resulting in a 0w = 74 deg angle between the forearm and line of action of each weight. The force produced by Muscle1 is 964 N (with an angle of pull of 0M1 = 53 deg and an insertion length of dm1 = 5 cm from the elbow). Muscle2 has an angle of pull of 0m2 = 24 deg and an insertion length of dm2 = 8 cm from the elbow. What is the force magnitude of Muscle2 required to keep the elbow in a stationary position? You are allowed a 5% margin of error for rounding.
ue 9:E0 • ZAIN IQ lI. ۱۳ شباط تحرير QI: Find the result of F4 Force acting on a body as shown below: 400 N 300 N 60 30 F;= 150 N F,- 260 N
Three springs are connected to a mass and to fixed supports. When the coordinate y is equal to zero, there is no spring force. Your tasks: Tw m k3 Fload Ő nly A Draw the free body diagram for the mass m including all 3 spring forces and the load force Fload). ( Figure 1: System schematic for Problem 1. B Draw the free body diagram for the mass m, but combine the springs into one equivalent spring with spring constant keq. Write the equivalent stiffness of the spring keq in terms of the other spring constants. (3 C Given that k₁ = 300 N/m, k₂ = 100 N/mnd k3 = 200 N/mand Fload = 300 N, calculate the loaded deflection Yloaded D Compute the amount of potential energy stored in each spring. E Compute the forces, in Newtons, in each spring and denote them as F₁, F2, and F3 when the load from Part D is applied. Wh
Physics 121 Spring 2021 - Document #11: Homework #04 & Reading Assignment page 4 of 8 Problem 1: Gnome Ride - This from a Previous Exam I. A Gnome of given mass M goes on the Gnome Ride as follows: He stands on a horizontal platform that is connected to a large piston so that the platform is driven vertically with a position as a function of time according to the following equation: y(t) = C cos(wt) Here w is a constant given angular frequency, C is a given constant (with appropriate physical units) and y represents the vertical position, positive upward as indicated. Part (a) - What is the velocity of the Gnome at time t = 0? Explain your work. Present your answer in terms of the given parameters Part (b) – What is the net force on the Gnome at time t = 0? Explain your work. Present your answer in terms of the given parameters Part (c) – What is the Normal Force on the Gnome at time t = 0? Explain your work. Present your answer in terms of the given parameters Some Possibly Useful…
3 www 2 1 CC BY UBC Engineering 7 A modern art sculpture consists of a collar, a spring, and a circular track. The collar has a mass of m = kg and the radius of the track is r = 0.5 m. If the spring is attached to a point P which is a vertical distance d : point P), determine the change in potential energy between state 1 and state 2, and between state 1 and 0.3 m away from the perimeter of the circular track (d is measured between point 1 and N 80 state 3. The unstretched length of the spring is 0.15 m and the spring constant is k m
1Gmail Copy of mom it for. Maps Old Telephone Ima. Preview attachmen.. Cami Uploads Sylvanus Gator - Mechanical Advantage Practice Sheet.pdf 5. *** A force of 75N is applied to a nutcracker to crack open a walnut. If the MA of the nutcracker is 5, what is the force the nutcracker applies to the walnut? Force =
Q2: A particle is thrown at an angle of 30° with velocity of 36 kmph calculate its time of flight and horizontal range. Q3: A wire 10m long of cross section area 1.22 cm? elongates by 1.5 cm when 4.5 kg is suspended from it find: 1. Stress 2. Strain 3. Youngs modulus of the wire