Homework 9- Electromagnetic Inductionxercise 29.33< 12 of 14A0.286 m-ong bar moves on parallel rails that areconnected through a 6.39 S2 resistor, as shown in thefollowing figure (Figure 1), so the apparatus makes acomplete circuit. You can ignore the resistance of the bar andrails. The circuit is in a uniform magnetic field 1.53 T that isdirected into the plane of the figure.Review ConstaPart AAt an instant when the induced current in the circuit is counterclockwise and equal to 1.51 A, what is the magnitude of the velocity of the bar?Express your answer with the appropriate units.Figure< 1 of 1 >Valuem/sSubmitRequest AnswerPart BWhat is the direction of the velocity of the bar?O rightwardO leftwardSubmitRequest Answer4:23 PM3/17/2021P Type here to searchhomeprt scdelete

The length of the rod is L=0.286 m. The resistance is R=6.39 Ω. The magnetic field is B=1.53 T. The…

Review Cons A0.286 m -long bar moves on parallel rails that are connected through a 6.39 S resistor, as shown in the following figure (Figure 1), so the apparatus makes a complete circuit. You can ignore the resistance of the bar and rails. The circuit is in a uniform magnetic field 1.53 T that is directed into the plane of the figure. Part A At an instant when the induced current in the circuit is counterclockwise and equal to 1.51 A, what is the magnitude of the velocity of the bar? Express your answer with the appropriate units. Value m/s Figure < 1 of 1> Submit Request Answer Part B of the bar?

Review Cons A0.286 m -long bar moves on parallel rails that are connected through a 6.39 S resistor, as shown in the following figure (Figure 1), so the apparatus makes a complete circuit. You can ignore the resistance of the bar and rails. The circuit is in a uniform magnetic field 1.53 T that is directed into the plane of the figure. Part A At an instant when the induced current in the circuit is counterclockwise and equal to 1.51 A, what is the magnitude of the velocity of the bar? Express your answer with the appropriate units. Value m/s Figure < 1 of 1> Submit Request Answer Part B of the bar?

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter20: Induced Voltages And Inductance

Section: Chapter Questions

Problem 56AP

See similar textbooks

Similar questions

In the August 1992 space shuttle flight, only 250 m of the conducting tether considered in Example 23.2 could be let out. A 40.0 V motional emf was generated in me Earth’s 5.00105T field, while moving at 7.80103m/s. What was the angle between the shuttle’s velocity and the Earth’s field, assuming the conductor was perpendicular to the field?
A 0.50-kg copper sheet drops through a uniform horizontal magnetic field of 1.5 T, and it reaches a terminal velocity of 2.0 m's. (a) What is the net map,-, eh: force on the sheet after it reaches terminal velocity? (b) Describe the mechanism responsible for this force, (c) How much power is dissipated as Joule heating while the sheet moves at terminal velocity?
The current through a circular wire loop of radius 10 cm is 5.0 A. (a) Calculate themagnetic dipole moment of the loop. (b) What is the torque on the loop if it is in a uniform 0.20-T magnetic field such that p and B are directed at 300 to each other? (C) For this position, what is the potential energy of the dipole?
(a) What is the speed of a supersonic aircraft with a 17.0-m wingspan, if it experiences a 1.60V Hall voltage between its wing lips when in level flight over the north magnetic pole, where the Earth's field strength is 8.00105T ? (b) Explain why very little current flows as a result of this Hall voltage.
What is the value of the magnetic flux through the coil in Figure 23.56 (b) due to the wire?
Explain why the magnetic field would not be unique (that is, not have a single value) at a point in space where magnetic field lines might cross. (Consider the direction of the field at such a point.)
Unreasonable results To construct a non-mechanical water meter, a 0.500-T magnetic field is placed across the supply water pipe to a home and the Hall voltage is recorded, (a) Find the flow rate through a 3.00-cm-diameter pipe if the Hall voltage is 60.0 mV. (b) What would the Hail voltage be for the same flow rate through a 10,0-cm- diameter pipe with tire same field applied?
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
(a) A nonferrous screwdriver is being used in a 2.00 T magnetic field. What maximum emf can be induced along its 12.0 cm length when it moves at 6.00 m/s? (b) Is it likely that this emf will have any consequences or even be noticed?
Is the direction of the magnetic field shown in Figure 24.6 (a) consistent with the right—hand rule for current (RHR-2) in the direction shown in the figure?
A charge of 4.0C .s distributed uniformly around a thin ring of insulating material. The ring has a radius of 0.20 m and rotates at 2.0104 rev/min around die axis that passes through its center and is perpendicular to the plane of the ring. What is the magnetic field at the center of the ring?
A solenoid is wound with 2000 turns pet meter. When the cuiient is 5.2 A, what is the magnetic field within the solenoid?