Q: Water is flowing through a soil as shown in the figure. Pressure head at C (i.e. uc) is 8m. Determine the value of "x" and total head at D (i.e. hp). F E X 2 m 3 m 1m 4m Datum B CF D DI Soil

Q: For the loaded cantilever beam shown in figure (1). the bending moment distribution along the beam…

A:

Q: 15% reduce in diameter. Q2: In extrusion of round bar, the semi-die angle a = 10° to achieve…

A: Semi-die angle = 10° Percentage reduction in diameter = 15% Coefficient C1 = 1.2 Coefficient C2 =…

Q: A bench Mark has been established at the soffit of an ornamental arch at the known elevation of…

A: A bench mark established at the soffit-Bench mark elevation BM=100.00 m above sea level,Back sight…

Q: Specific Gravity and Absorption of Coarse Aggregates What are the possible discussion of…

A: There are two types of  aggregates, they are fine aggregate and coarse aggregate. Coarse aggregate…

Q: The frame is subjected to distributed load of 500 kN/m as shown in the figure. Analyse the response…

A: E = 2.05e8  # Young's modulus in kN/m2I = 5.54e-4  # Moment of inertia in m4A = 0.012  #…

Q: For the determinate beams shown, draw the influence lines for: i) bending moment over support Ⓡ ii)…

A: Given:Required :Influence line diagram for :Bending moment at support BShear force immediately left…

Q: Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1500 m…

A: The height into the atmosphere = 1500 mThe total pressure = 100 kPaThe air temperature = 28°CThe dew…

Q: A simply supported beam with spans of LAB = 8 ft and LBc = 24 ft supports loads of w = 4.5 kips/ft…

A: Maximum shear stress and Maximum bending stress in the beam.

Q: me: 16' 5. What is the perimeter in feet of exposed wall for the entire house provided? NOTE 1: The…

A: To find:The perimeter in feet of exposed wall for the entire house.The perimeter of the wall:The…

Q: For the beam shown in Figure, using the moment area theorems determine the slope at point B.

A:

Q: Example ✓ Determine if the operation will be safe or not ✓ If not what control would you recommend?…

A: Speed of vehicle A, Speed of vehicle B, Speed of vehicle C, Reaction time, Level grade, To find: To…

Q: For the state of stresses (in MPa) shown in the figure below, the maximum shear stress (in MPa) is…

A: A state of stress is given as shown in the figure-To Find-The value of the maximum shear stress.

Q: (c) Determine the maximum base width of the elementary profile gravity dam with the following data:…

A:

Q: b) Looking into the future with mean temperature levels exceeding 2.50C above pre-industrial levels…

A: This question is the continuation of previous question. From the data we have from previous…

Q: Rigid beam AB is supported by three bolts at A and a pin at B. The bolts at A are in double shear…

A:

Q: Problem 2 Determine the support reactions of the beam loaded as shown below then draw the shear and…

A:

Q: A 500 N 2m 120⁰ 3 m 200 N

A:

Q: Calculate the moment of inertia of the shaded area about the x-axis. Assume a = 45 mm, r = 30 mm.

A:

Q: Calculate: 1. moment resistance 2. Minimum area of reinforcement 3. Maximum area of reinforcement…

A: Given;b = 150 mmD = 250 mmCover = 25 mmd = 250-25 = 225 mmNo. of Bar = 2dia. of Bar  = 16 mmFck = 25…

Q: 02 Draw the Bending moment only for the beam shown 642-5=191 400N 600N 2m 2m D 2-5 2m B C A Be C.M

A:

Q: Without doing any calculations, illustrate how you would determine the shear force and bending…

A: Given :Required :To explain how shear force and bending moment at any point is calculated using…

Q: When a pressure of 2x10^4 kN/m² is applied to 50 litres of a liquid, its volume is decreased by 0.5…

A: Given Applied pressure = dp = 2×10⁴kN/m² = 2×10⁷N/m²Volume = V = 50ltr= 0.05m³dV = 0.5ltr = 0.5×10–³…

Q: (i) A multistory building with a basement is to be constructed. Top 4 m consists of loose silt,…

A:

Q: Using the ASD method, pick the least-weight beam.   Fb = 24ksi Fv = 14.5ksi Defl limit = L/360 A…

A:

Q: A steel wire is bent into an arc of a circle of radius 5m. Find the maximum bending tensile stress…

A: A steel wire bent into an arc of a circle-To Find-The maximum bending tensile stress induced in the…

Q: Through the Walla Walla Road to the entrance of the E-1 parking lot at the University of Washington,…

A: The duration between the time 7:40 am to 8:20 am is 40 minutes and the vehicle rate is 480 vph.after…

Q: One vehicle is following another on a two lanes, two way highway at night, according to the rule of…

A: One car length of clearance Perception reaction time Coefficient of braking friction Length of…

Q: Draw the shear and moment diagrams for the beam shown in figure. (3. m 2KN B 4KN 1m C 2m

A:

Q: 3.6 m -5m CO 2 5m Fc = 1 kN 50 -5m FF = 4 KN A = 965 mm² E = 200 GPa

A: A=965mm2E=200GPa

Q: Find the maximum moment of the given load train at point n on the beam given in the figure?

A: We have to find out the maximum bending moment at section n.

Q: 60 kN A 30% 2000 mm 3000 mm 30 kN 50 KN 3000 mm 50 kNm

A:

Q: For a saturated sand deposit, the void ratio and the specific gravity of solids are 0.70 and 2.67,…

A: A saturated sand deposit-void ratio e = 0.70,specific gravity of the solids G = 2.67,To Find-The…

Q: Draw the shear and moment diagram of this beam. 4 kN/m 8 m- B 80 kN-m -4 m 30 kN C

A:

Q: pport B is tled by 5mm and support C tled by 2mm, by using the ment distribution method, d the…

A:

Q: A trapezoidal channel is 6.0m wide and has side slope of 0.5 H:I V. If the bed slope of the channel…

A: The channel is having trapezoidal sectionWidth of section, B = 6 mSide slope = 0.5 H: 1 V, m =…

Q: Determine the cracking moment in kip-ft for the section shown if: f'c = 4000psi and f₁=7.5√f'c. 3…

A: The compressive strength of the concrete = 4000 psiThe steel reinforcement provided = 3-#10 barsThe…

Q: It was estimated that the number of trips between north Davis and the campus during the 8-9 AM peak…

A: Values of βm are: Auto: 4.50 U nitrans: 3.0 Bicycle: 2.50 Cost:auto trip: 8 minutes = $5.50…

Q: A group of students have noted that the sidewalks on Temple Street have more cracks than those…

A: Hypothesis: The observation that the sidewalks on Temple Street have more cracks than those located…

Q: Question- Transport While aligning a hill road with a ruling gradient of 1 in 20, a horizontal curve…

A: A hill road-Ruling gradient = 1 in 20,Radius of horizontal curve R=80 m,To Find-The value of the…

Q: A rectangular channel 4.0 m wide is laid a bed slope of 0.0008. A discharge of 15.0 m₽/ flows in the…

A:

Q: for vehicle.computes speed for This the The space Mean data.

A:

Q: The reduced bearing of 20 m long line is S30° E the latitude of the line is A 17.32 m north B 10 m…

A: Given;Length = 20 mAngle () = S30E

Q: Part A Use the fact that ABC is a three-force member to determine the magnitude of the reactions at…

A:

Q: By assuming a linear speed-density relationship, the mean free speed on a highway facility lane…

A: The speed-density Relationship is;

Q: The normal duration and normal cost of an activity are 18 days and Rs. 36,000 Respectively. The…

A: Normal duration=18 days,Normal cost=Rs 36,000Activity crash duration=15 days,Indirect cost=Rs 800…

Q: Q: The following figure shows the flow net for seepage of water around a single row of shee piles…

A:

Q: A tapered circular rod of diameter varying from 20 mm to 10 mm is connected to another uniform…

A: Given data in question Load 30 kNDiameters 10 and 20 mmLength 1.5 and 2 mElasticity modulus 2×105…

Q: Can you adjust the answers I think the external loads don't take one equation out of consideration…

A: The solutions of a,b,c provided by expert is wrong.I am providing the good solution for you.See my…

Q: 3 4 kN/m 10 kN 1m+

A:

Q: Question 5: The slab system shown below is required to support a uniformly distributed service live…

A: Dead Load = 2.5 kN/m2Live Load = 3.2 kN/m2f'c = 27.6 N/mm2fy=414 N/mm2thickness of slab = 180…

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.