LSSS ANSWER WITHIN 10MINS An electric field of 165 x10-6 V/m is induced within the loop of long solenoid with cross sectional area of 3.27 cm2. The radius of the loop is 2.90 cm. Calculate the number of turns if the current in the winding is increasing at a rate of 83 A/s. Final answer should be expressed in two (2) decimal places. Round up or down accordingly. For the final answer, please write/include the unit, express you answer in "Turns"

LSSS ANSWER WITHIN 10MINS An electric field of 165 x10-6 V/m is induced within the loop of long solenoid with cross sectional area of 3.27 cm2. The radius of the loop is 2.90 cm. Calculate the number of turns if the current in the winding is increasing at a rate of 83 A/s. Final answer should be expressed in two (2) decimal places. Round up or down accordingly. For the final answer, please write/include the unit, express you answer in "Turns"

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 74AP: The armature and field coils of a series-wound motor have a total resistance of 3.0 . When connected...

See similar textbooks

Similar questions

In the following transformer circuit VSource=12.0volts, RSource=4, the number of turn on the left-handside is 100 and on the right-handside is 800. RLis 700. a.Find the voltage across RL
J: Refer to figure la 2.0m conductor is shown, that rotates at 1200 rev/min in the radial field B = 0.10 sinpa, T. Solve the current in the closed loop with a resistance 100 N. Discuss the polarity and current direction. r= 0,20 m 2.0 m 100 N
A circuit is made with a resistor of resistance 25 ohms and a movable bar with length 15 cm moving to the left with speed 8 m/s. The whole circuit is in a magnetic field B = 1.5 T (into page). Use this set up to answer the following questions. What is the current through the resistor in amps? Answer to 3 decimal places.
A current 7 A is passing through a straight wire. What will be the magnetic field _________________in Tesla induced at a point 11 cm from the wire. Round your answer to 1 decimal place.
If a 0.6T bar magnet is pushed through a 50 turn coli with an area of 0.003m2 in 1.9sec. The induced voltage is _________v.
A magnetic circuit has a coil with 1000 turns. Its reluctance is expressed as=[8.5+40 x] 103 MKS units (meter-kilogram-second measuring system)Where x is gap length in mm. For a coil current of 2A constant, calculate the change in the fieldenergy stored if the length of the air-gap changes from 0.2 to 0.15. Calculate the mechanicalforce experienced by the system
A square loop of aluminum wire is 17.0 cm on a side. It is to carry 12.2 Aand rotate in a uniform 1.24 Tmagnetic field as shown in the figure.(Figure 1) a.Determine the minimum diameter of the wire so that it will not fracture from tension or shear. Assume a safety factor of 10. b.What is the resistance of a single loop of this wire?
A ferromagnetic core with a relative permeability of 2200 is shown in Figure. The dimensions are as shown in the diagram, and the depth of the core is 7 cm. The air gaps on the left and right sides of the core are 0.050 and 0.070 cm, respectively. If there are 300 turns in the coil wrapped around the center leg of the core and if the current in the coil is 1.0 A, what is the flux in each of the left, center, and right legs of the core? What is the flux density in each air gap? Check my solution.
a. Consider the current configuration shown below. What is the magnitude of the cur- rent in the wire marked with a question mark? Is the current entering or leaving the node? 2.20 A 1.40 A 1.50 A- Current configurations for #1d b. Consider the single loop circuit shown below. Calculate the current which flows in the circuit. Is the current in the clockwise or the counterclockwise direction? 120 2 90 Ω 5.5 V 180 Ω Single loop circuit configurations for #1b
Calculate the voltage (Volts) induced in a coil which has 200 turns where the total flux changes from 2.5mWb to OmWb in 0.5 seconds.
A copper wire (µ = 1.256x10^-6 T-m/A) was used in a solenoid wire of 1000 turns in 20cm of solenoid length in order to generate 2 Tesla of B-field, How much current is required? choices: a. 3.14 mA b. 318.47 A c. 3,184.7 A d. 314 mA
If 42.7 cm of copper wire (diameter = 1.28 mm, resistivity = 1.69 × 10-8Q.m) is formed into a circular loop and placed perpendicular to a uniform magnetic field that is increasing at the constant rate of 7.93 m/s, at what rate is thermal energy generated in the loop? Number Units