following fundamental SI units are based on a physical artefact instead of a natural phenomenon? (A) Kilogram (B) Second (C) Mole (D) None of the above   True or false? In dimensional analysis, the units in equations are treated just like any other algebraic quantity.    True or false? If an equation is dimensionally consistent, then it implies that is physically

Q: The radius of a circle is measured to be 0.545 ± .005 m. Calculate the area of the circle with its…

A: Write the expression for the area of the circle and substitute the required values.

Q: The maximum running speed (S) in km/hr and the corresponding body mass (m) in kg were determined for…

A: Unit of speed is km/hr Unit of mass is kg The relation between speed and mass is  S=5.7m2Unit of…

Q: The period of a pendulum is the time it takes the pendulum to swing back and forth once. If the only…

A:

Q: Which of the following statements is correct? If an eguation is dimensionally correct it must be…

A: To choose the correct option regarding the dimensionally correct and dimensionally incorrect…

Q: A rather ordinary middle-aged man is in the hospital for a routine check-up. The nurse writes the…

A: Dear student For a middle aged man, the mass could be around 70kg, and age would be around 45 years.

Q: Assuming biological substances are 100% water, estimate the mass of a human kidney. Take a kidney to…

A: Mass of a Human kidney

Q: One mole of atoms consists of 6.02 × 1023 individual atoms. If one mole of unicorn atoms were spread…

A: Determine the surface area.

Q: fine grains of beach sand are assumed to be spheres of radius a. 45.7 μm. These grains are made of…

A: Given data: The diameter of each grain is, The density of the silicon dioxide grain is, Formula…

Q: Question No. 1 A physical quantity is measured and its value is found to be equal to nu, where n is…

A:

Q: Procedure 1. The following are the measurements of the waistline of a family member taken by 3…

A: Given:

Q: USING LENGTH MEASUREMENTS MADE WITH A CENTIMETER RULER U.S. MINT MEASURED USING…

A: The dimensions of Dime, Penny and Quarter are given as follows  : Dime : mass = 2.268 grams diameter…

Q: One student uses a meterstick to measure the thickness of a textbook and obtains 4.3 cm + 0.1 cm.…

A:

Q: Match the following 1. Precision a. the rightmost digit in a recorded data 2. Significant figure b.…

A: Precision :       Degree to which exactness is applied i e. If we take measurements number of times…

Q: Consider the physical quantities m, s, v, a, and t with dimensions [m] = M, [s] = L, [v] = LT–1, [a]…

A: Using dimension analysis,   Dimension of L.H.S = Dimension of R.H.S

Q: Dimension Y is the sum of three parts sequentially numbered 1 through 3. Their dimensions are X1,…

A:

Q: Calculate the probable error in the volume of the container, in m3

A: Volume of rectangular prism = L W H

Q: What is the reported value of the length of the book with uncertainty? If the length (l) of a book…

A: data,l1 = 8.21cml2 = 8.24cml3 = 8.22cml4 = 8.23cml5 = 8.24cml6 = 8.22cml7 = 8.23cmmean value would…

Q: The Colburn equation for heat transfer is: where Cp is heat capacity, Btu Ib °F; u is viscosity, Ib…

A: Given colburn equation,  hcpGcpμk23=0.023DGμ0.2 where,cp is heat capacity whose units are Btu lb-1…

Q: You are a team leader at a pharmaceutical company. Several technicians are mass/volume) preparing…

A: We will calculate densities in S.I. Unit , which is kg/m3.

Q: One mole of atoms consists of 6.02 × 1023 individual atoms.  If one mole of unicorn atoms were…

A:

Q: Which of the following is NOT one of the fundamental units in the SI system? a) newton b) meter c)…

A:

Q: The Apothecary system of units was used in Britain and the US until 1858. Given the density of water…

A: 1 grain = 0.065 g Therefore, 20 grains=20×0.065=1.3 g That implies 1 scruple = 1.3 g Therefore,  3…

Q: 1.38 What is the answer? Use a given-required-solution format. Provide a step by step solution.…

A:

Q: EACH Consider the physical quantities m, s, v, a, and t with dimensions [m] = M, [s] = L, [v] = LT…

A: Given  Dimensions of physical quantities   [m] = M  [s] =L  [v]= LT-1  [a] = LT-2  [ t] = T  Also…

Q: The area of a circle is given by ar? where r is the radius. This can be written as area = (ar) x r.…

A:

Q: * The volume of liquid flowing per second is called the volume flow rate Q and has the dimensions of…

A: The length of needle is L and its dimension is [L]. The radius of the needle is R its dimension is…

Q: During a month-long advertising campaign, the total sales S of a magazine is modeled by the function…

A: The sales function is, Sx=2x2+48x+11000 (a) The average rate of change of sales from 10 to 20 can be…

Q: Density of water is 1000kg/m³. What is its density in units of g/cm³? 3 A cylinder has length of…

A:

Q: Objectives: 1. Analyze sets of data and decide whether the measurements are precise and/or accurate.…

A: Note : According to our guidelines , we are only allowed to answer 3 subparts per question . If you…

Q: You also measure the length of a side of the cube using a ruler and get the value 3.15+0.05 cm.…

A: We need to calculate volume with proper error uncertainty value.

Q: Copper can be drawn into thin wires. How many meters of 34- gauge wire (diameter=6.30x10-3 in) can…

A:

Q: Now you will use the ruler to measure the dimensions of a block of pure aluminum metal. Make sure…

A:

Q: You measure the dimensions of a rectangular block of aluminum to determine its volume. It has the…

A: Given:  l = 10.52 cm; w = 4.12 cm; h = 1.13 cm error = 0.01 cm

Q: typical male’s body surface area S in square meters is often modeled by the formula S = 1 6/0 √wh,…

A:

Q: The volume of the rectangular block in the figure is calculated from the following measurements of…

A: Given: da = 0.10 cm a = 10 cm db = 0.06 cm b = 5 cm dc = 0.04 cm c = 4 cm   We have the volume of…

Q: If the distance dd (in meters) traveled by an object in time tt (in seconds) is given by the formula…

A: Given data:  Distance d in meters d = A + Bt2  Time (t) in seconds  Required: The SI units of A and…

Q: the volume of the rectangular block in the figure is calculated from the following measurements of…

A:

Q: Using dimensional analysis, check which of the following equations is or are correct. 1. a=v/t 2.…

A: Given  1. a=v/t 2. density = mass/volume 3. speed = d/t^2  4. a=∆v/∆t

Q: Referring to the following equation: y=-3log(2.5x-0.5T) If the quantity y is measured in cm2/min, x…

A: y = -3 log (2.5 x - 0.5 T)    x = g/ cm3   y= cm2 / min      T= C log (2.5 x - 0.5 T)   = UNITLESS…

Q: Estimating Errors for Multiple MeaSurements of a Physical Quantity Using variance Distance (M)…

A: Actual value of a physical quantity x = x1 + x2 + •••••+xn /n

Q: Since 0.254 m = 25.4 cm = 254 mm, we could conclude that unit conversions within the metric units of…

A: Given : 0.254 m = 25.4 cm = 254 mm

Q: A student solving for the acceleration of an object has applied appropriate physics principles and…

A: Given a1 = 3.00 m/s2 F = 12.0 N m = 7.00 kg

Q: Using a measuring tape with a least count of 0.1 cm, you measure a package you wish to ship and…

A: The least count of the tap LC=0.1 cm  The length l=11.2 cm The width w=7.5 cm The height h=5.4 cm…

Q: How many ping pong balls would fit into a room 3 m wide by 4 m long by 4 m tall (without being…

A: Length of room ,l = 4 m width of room,   b = 3 m height of room,  h =4 m Diameter of ping pong,d =…