Fifty identical photovoltaic cells are connected in series. Every solar cell has a light generated current of 5.0 Amperes at 25 degrees Celsius. With a dark saturation current of 9 x 10-10 Amperes, a parallel resistance of 8.0 Ohms and a series resistance of 0.008 Ohms. Calculate for the current, voltage, and power delivered when the pn voltage of each cell is rate at 0.6 Volts.

Fifty identical photovoltaic cells are connected in series. Every solar cell has a light generated current of 5.0 Amperes at 25 degrees Celsius. With a dark saturation current of 9 x 10-10 Amperes, a parallel resistance of 8.0 Ohms and a series resistance of 0.008 Ohms. Calculate for the current, voltage, and power delivered when the pn voltage of each cell is rate at 0.6 Volts.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

8. Liquids with solid impurities a) Have higher dielectric strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average de voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform will havephase shift * 180 deg O deg 45 deg O 90 deg 8. Why do we say the "voltage across" or "the voltage with respect to?" Why can't we just say voltage? * Voltage is a measure of electric potential difference between two electrical points. O It's an electrical cliche. The other point could be negative or positive. None of the above.
17/ The charge across each capacitance when connected in a parallel connected capacitive circuit is ___________________. a. Same charges are observed across each capacitance b. Either same or different charges are observed across each capacitance c. None of the given option d. Different charges are observed across each capacitance
A capacitor of 1µF is charged to 100 volts and then disconnected from the power supply. A second but uncharged capacitor of 3µF is then connected across the first capacitor. What is the voltage across the parallel combination? O a. 110 volts O b. 45 volts O c. 66 volts O d. 25 volts
A current of - 8 + 62-V (sin (wt + 30°)) A is passed through three meters. The respective readings (in ampere) will be?
Answer (c). What are Ac voltage at each point indicated (A,B,C,D,E) in the circuit with Vs = 100mVp-p
For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
the non-inductive resistance of kelvin double bridge are set at 100ON each, the standard resistance is set at 0.10020 and the low resistance 0.0000122 was very low. determine the unknown resistance
Please solve this question in photovoltaic energy systems
Choose the correct statement for pure inductor connected across single phase AC supply. a. Current leads the supply voltage by 90° b. Current lags the supply voltage by 90° c. Current and Voltage are in phase d. None of these