Answered: dry bulb temperature of 30° C and 60%…

dry bulb temperature of 30° C and 60% relative humidity, The saturation pressure of water at 30° C is 4.24 kPa. Find the speci

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter34: Indoor Air Quality

Section: Chapter Questions

Problem 17RQ: The recommended relative humidity for a home is between A. 500/0 and 70%. B. and 40%. C. and 50%. D....

See similar textbooks

Related questions

Q: Water flows through the pipe contraction shown in Figure 1. For the given difference in piczometer l...

Q: Use rotation about the fixed frame to calculate the transformation matrix for a rotation of 30° abou...

A: Determine: Transformation matrix for a rotation of 300 about z0 axis and then 450 about x0 axis. Sol...

Q: The equation of motion for a damped vibration is given by 6x + 9x + 27x = 0. The damping %3D

A: Given:The equation of damping vibration,6x¨+9x˙+27x=0,

Q: 21. The inside dimensions of a 3500 Watt oven are shown below. How long would it take to heat the ov...

A: Dear student, it seems like there is some data mistake in the question because 1% efficiency is not ...

Q: Q.13 The following specifications are glven for a rigid coupling. Outside diameter of flanges = 160 ...

Q: The elevation of the platform is controlled by two identical mechanisms, only one of which is shown....

A: Load = 1500 lb Here we need to draw free body diagram and solve the sum So here I am drawing it in...

Q: Figure Q2 shows a beam subjected to distributed loading. Knowing the beam is fixed supported at one ...

Q: chain with RS=102.3mn onent of accel-

Q: A car accelerates from 75 km/h to 115km/h in 5 seconds to overtake a lorry. Calculate the accelerati...

Q: 7. The pressure of the fluid is P = 50 kPa then calculate the value of adiabatic compressibility of ...

A: (7) Calculate the value of adiabatic compressibility of the fluid Given P=50 kPaSince adiabatic com...

Q: Determine the value of Eld at the center of the beam, loaded as indicated in the following figure. 4...

Q: at is the importance of the glass box approach technique?

A: glass box approach is a method of orthographic projection whereby the object under observation is en...

Q: Lated to Reynolds numb Re & Re (C

Q: For a certain engine havI a flywheel approximated as a solid disc, is required for keeping the fluct...

A: we have to determine the mass of the flywheel

Q: 2/75 The weld at O can nupport a maximum of 2500 N of force along each of the n- and 1-directions an...

A: The above given problem is related to the resolution of forces in the parallel and the perpendicular...

Q: Present and validate how Stokes Law is used to analysing fluid behaviour and measure the viscosity o...

A: A fluid's viscosity is a measure of its resistance to deformation at a particular rate. A fluid w...

Q: Find Resultant of the following force system

Q: A boiler uses 20 kg of air per kg of fuel. The fuel consumption is 33 kg/sec and actual draught requ...

A: Given that, ma=20 kg/kg of fuel, mf=33 kg/sechw=18 mm of waterC=0.3829HTa=25°C=25+273=298 KTg=23...

Q: 1. Compute the stress (ksi) in each member of the Warren truss as shown in the figure. Indicate whet...

Q: 3-21 Complete this table for H,O: T, °C P, kPa u, kJ/kg Phase description 400 1450 220 Saturated vap...

A: AS PER GUIDELINES, ONLY ONE QUESTION CAN BE SOLVED AT A TIME. FOR SOLUTION OF OTHER QUESTIONS, KINDL...

Q: What are the principles of sustainable design&sustainable engineering

A: given; What are the principles of sustainable design & sustainable engineering

Q: A veytindrical premere wessel 400 mm wall thichnes of 20 mm puesure of 4.5 MPa. the dongitudnal trus...

A: Given:diameter, d=400 mmthickness, t=20 mminternal pressure, P=4.5 MPa or 4.5 N/mm2

Q: A cam drive is used for a mechanism that packs stuffing into shipping boxes. The cam follower must r...

Q: a steel wall a temperati

Q: te which is at 10 1S °C. Assumin r coefficient w 11

Q: Both portions of the rod ABC are made of an aluminum for which E= 70 GPa. Given: P= 4.5 kN.

Q: An Actual Rankine cycle operates on a boiler and condenser pressure of 2MPa and 20kPa respectively. ...

A: given; at P=2MPaenthaly (h)=3467.6KJ/kgs=7.4317at P=20KPasf=0.8312KJ/kgsfg=7.0784KJ/kghf=251.13KJ/kg...

Q: A 40-lb suitcase slides from the rest 20 ft down the ramp. The suitcase has an initial velocity down...

Q: A tensile testing machine operates using two lead screws. Both lead screws have a square thread prof...

A: Square threads are a popular screw thread form found in high-load applications like leadscrews and j...

Q: 6 Determine the absolute water pressure

A: To calculate absolute water pressure.

Q: . In the casting of steel under certain mould conditions, the mould constant in Chvorinov's rule is ...

A: Given:Mould constant, C=4 min/cm2Dimension of plate=25×8×2.5 cm3n=2

Q: The compression ratio of an ideal Otto cycle is 8. Air is 95 kPa and 27 C at the start of the compre...

Q: 180 b 150 b 220 b 3 ft 100 Ib 240 lb 3 ft E 10 ft 10 ft 10 ft 10 ft 383 (C) O 725 (C) O 286 (C) O 30...

A: Option a is correct

Q: Graphical Displacement Diagrams 9-1. A cam is required for an automated transfer mech- anism. The ca...

Q: why is velocity 0 at centre of sphere

A: For flow past over sphere, when it strikes on sphere at that point kinetic energy of fluid converted...

Q: Sprayer has 3 m used to spray 30 ha, speed 0.97 m/s, field efficiency 75%, The sprayer uses 75% of i...

A: Sprayer b= 3 mSpray area A=30 haV=.97 m/secηfield=.75Sprayer uses 75% of its width

Q: 1. An open hemispherical vessel with a radius of 1.2m is full of oil (0.85) a. How fast in rpm shoul...

A: Given: The radius of vessel, r = 1.2 m The specific gravity of oil, SG = 0.85

Q: Two disks are tightly attached to a uniform diameter shaft at the position shown in Figure Q5. The i...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for yo...

Q: perature are 200 kPa and 300 K, respectively, determine the following: (a) A for flow from inlet to ...

Q: 1. In the given figure, gear 1 has 24 teeth and gear 2 has 70 teeth of PD=4. Gear 3 has 20 teeth and...

Q: QUESTION 1 Calculate the spindle speed in RPM of a lathe turning a 96 milimeter diameter material th...

A: Given:d=96 mmV=148 SMPM

Q: Why does fracture toughness increase with yttria content. Use the phase diagram to explain

A: The crack strength improvement of yttria-balanced out tetragonal zirconia polycrystalline ceramics t...

Q: Steam at a pressure of 0.58 MPa has an internal energy of 2725.2 kJ/kg. What is the temperature spec...

A: given:Pressure, P=0.58 MPainternal energy, u=2725.2 kJ/kg

Q: L1=4 in , L2=3 in, L3=1.5 in , h1=5 in , h2=6 in , f=7 lb , p= 45 lb. determine the proper angle in ...

Q: A fire truck supplies 190 gal/min of water to the third story of a building at B (Eigute 1) Part A I...

A: this is the multiple type question . according to company policy i have answered very first question...

Q: 3.45 planes O shown in the following unit cell: +z A >+y +x Note: Both of these planes are displayed...

A: Dear student, please find the attached solution.

Q: The position of the neutral axis; The maximum tensile and compressive stresses; and The shear stress...

A: moment of inertia of channel section = 3.37500 x107 about neutral axis

Q: For the following truss structure (with members AB, BC, AD, DE, BE, CH and FG all of 60 cm length ea...

Q: What is the pressure at 61, 500 ft in SI.

Q: 1. A vapor trapped in a cylinder behind a piston has an initial stored energy of 85 kJ. When 15 kJ o...

Question

Ambient air is at a pressure of 100 kPa, dry bulb temperature of 30° C and 60% relative humidity, The saturation pressure of water at 30° C is 4.24 kPa. Find the specific humidity of air (in g/kg of dry air) .

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The pressure, dry bulb temperature and relative humidity of air in a room are 1 bar, 30 degree celcius and 70% respectiveley.If the saturated steam pressure at 30 degree celcius is 4.25 kPa, Find specific humidity of the room air in kg of water vapour/kg dry air ?
Air (mass of dry air: 3 kg) with a relative humidity of 50% at 25 °C is supplied isobaric 30 kJ. What is the relative humidity after that?
In a 4m x 5m x 3m room, there is air at 30°C temperature, 100kPa pressure and 60% relative humidity. Find the specific humidity, dry bulb temperature, enthalpy values of the air.
The dry bulb temperature of the air in a room is 25 oC and the wet bulbtemperature is 20 oC. Find the relative humidity of the air.
In a 4m x 5m x 3m room, 30°C temperature, 100kPa pressure and 60% air at relative humidity. The specific humidity of the air, the dry bulb temperature, find the enthalpy values. Note: the values you get are on the psychrometric chart show me
At a climate station, air pressure is measured as 100 kPa, air temperature as 24°C, and the wet-bulb or dew point temperature as 19°C. Calculate the corresponding relative humidity in percent.
Upon exiting a dwelling maintained at 22°C to the outdoors, where the temperature is 35°C, a person's eyeglasses become fogged. What are the minimum humidity ratio and relative humidity outdoors? No need to look up the table, using appropriate symbolic expressions are good enough.
Use the tables of moist-air properties to find the enthalpy and specific volume for air at 125°F (51°C) if the humidity ratio is 0.040. (1) yois-
In air with a dry bulb temperature of 10 C and relative humidity of 90%; Find the dew point temperature, enthalpy, wet bulb temperature and specific humidity.
If the relative humidity at a sea-level site is 50% for a dry-bulb temperature of 80°F (26.5°C), calcu- late the moist-air enthalpy. () find the
A moist air (10.1 kg) with humidity 0.01 mixed with super heated water vapour, if 0.1 kg uniformly. Then final humidity of mixture (in kg/kg) is %3D
Example 1: Moist air at 32C db, 24C wb. Determine: - Relative humidity RH, Dew temperature, Specific humidity .