AV tot R₂ This parallel circuit depicts two resistors connected to a voltage source. The voltage source (AVtot) is a 12-V source and the resistor values are 5.4 (R₁) and 3.90 (R₂). a. Determine the equivalent resistance of the circuit. [Select] b. Which resistor will have the most current flowing through it? [Select] c. Determine the approximate total current in the circuit. [Select]

AV tot R₂ This parallel circuit depicts two resistors connected to a voltage source. The voltage source (AVtot) is a 12-V source and the resistor values are 5.4 (R₁) and 3.90 (R₂). a. Determine the equivalent resistance of the circuit. [Select] b. Which resistor will have the most current flowing through it? [Select] c. Determine the approximate total current in the circuit. [Select]

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter21: Circuits And Dc Instruments

Section: Chapter Questions

Problem 53PE: A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit...

See similar textbooks

Similar questions

Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0 resistor, (b) Find the current in the 3.00-12 resistor.
A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
Eight resistances [identical] are connected in series across a 220-V line a. Identify the voltage drop across each resistance. b. Assuming that the current is 1 A, what is the R of each device? c. What is the power dissipated in each? What is the correct answer?
Express your final answer in proper ENG notation and unit. Observe 2-5 decimal places. A battery has an EMF of 24.0 V and an internal resistance of 7. Its terminals are connected to a 1. load resistance of 5.25 N. a. Find r and current in the circuit if the terminal voltage of the battery is 22.5V. b. Calculate the power delivered to the load resistor, the power delivered to the internal resistance, and the power delivered by the battery.
The parallel circuit at the right depicts two resistors connected to a voltage source. The voltage source (AVtot) is a 12-V source and the resistor values are 7.4 Q (R,) and 3.9 Q (R2). a. Determine the equivalent resistance of the circuit. [ Select ] b. Determine the current in each branch resistor: Current in R, = [Select] Current in R, = [Select ] %3D C. Determine the total current in the circuit. Select ]
Compute for the total energy of the entire circuit. Select one: a. 128.42 micro Joules b. 352.12 micro Joules c. 273.56 micro Joules d. 478.08 micro Joules
Three resistors are connected in parallel. The resistances are each worth R1 = 2 ohms, R2 = 1 ohm and R3 = 2 ohms. If the resistance circuit is connected to a voltage of 12 volts, calculate the total current and the current flowing in the 1 ohm resistance. a. The magnitude of the total current = 14 A; current strength at R2 = 12 Ab. The magnitude of the total current = 24 A; current strength at R2 = 12 Ac. The magnitude of the total current = 18 A; current strength at R2 = 14 Ad. The magnitude of the total current = 20 A; current strength at R2 = 14 A
a. The equivalent resistance, Rab , between points a and b in the circuit shown in Fig.3 is ___________ohms. b. What voltage must be applied across terminals a and b of the circuit shown in Fig.3 so that the voltage, Vcb, across the 12Ω resistor would be equal to 6v?
a. Find the current I₁ and 1₂ in the following b. Find the voltage difference across the 2 c. Find the voltage difference across the 3 d. Find the voltage difference across the 10 circuit. resistor. resistor. resistor. Sweetlo (6) 17 V ΖΩ m 4Ω 10 Ω. 502 M 302
4a. Find the current in the circuit (magnitude and direction). 4b. Find the potential difference of V_ab of point a with respect to point b. 4c. Find the potential difference of V_bc of point b with respect to point c. 4d. What is the totatl rate at which electrical energy is dissipate in R1, R2, and R3 resistors. 4e. What is the power output of the 26.0V battery? 4f. At what rate is the electrical energy being converted to other forms in the 10.0V battery? 4g. Show that power output of the 26.0V battery equals the overall rate of dissipation of electrical energt in the rest of the circuit?
An AA battery (E→=1.50[V]) with in internal resistance of r=0.200Ω is connected to a circuit shown below. What is the rate of energy dissipation through the circuit? A. 4.75[W] B. 1.53[W] C. 1.15[W] D. 0.867[W]
M 1 Ω 11 V 3 W Ω 16 V a. Write Kirchhoff's junction rule for all junctions in the circuit. b. Write Kirchhoff's loop rule for all the loops in the circuit. c. Solve the circuit by finding the values of all the currents. 2 Ω mi M In this assignment you will be following the problem solving strategy for Kirchhoff Rules. 1. Reproduce, as neatly as possible, on paper, the circuit shown above. Do not make the circuit too small as you will have to add things to it later. 2. Label all relevant points in this circuit. For your benefit these points are marked with dots in the Figure above and they include: circuits junctions (i.e. places where 3/more wires connect), wire "corners" (i.e. places where a single wire is bent), and locations between two components on a single straight wire. These will help identify loops as well as making it easier to keep track of potential differences. Use lower case letters (a, b, c, ...) for this task. 3. For each junction draw and label the currents coming in…