An inductance of L Henries and a resistance of 15 ohms are connected in series with EMF of 135 volts. If the current is initially zero, and is equal to 7 amperes after 3 seconds. Determine L and the current after 5 s.

An inductance of L Henries and a resistance of 15 ohms are connected in series with EMF of 135 volts. If the current is initially zero, and is equal to 7 amperes after 3 seconds. Determine L and the current after 5 s.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Related questions

Q: COURSE: Electrical Engineering SUBJECT: Electrical Apparatus INSTRUCTIONS: • Write the GIVEN with…

Q: 2. Draw, in the spaces provided, rough sketches shov ing the following: a) A current which lags the…

Q: In a 33 kV overhead line, there are three units in the string of Example 1. insulators. If the…

Q: Q1. Explain about the following electric wiring circuits and compare their advantages and…

A: According to question, we need to explain, Ring Circuit Radial Circuit Lighting Circuit.

Q: A relay has a resistance of 350 ohms and an inductance of 0.8 henry. V volts is suddenly impressed…

Q: 7. A purely resistive lamp is rated at 200V (rms), 120 W (i.e., it dissipates 120 W power when…

Q: Si Ge A +12 V 2kOhm

A: The cut in voltages of silicon and germanium are 0.7V and 0.3V. The equivalent circuit as shown in…

Q: 1. A current of 5 Amp flows through a non - inductive resistance in series with a choking coil when…

Q: Q4. List different formulae for power in a dc circuit using Ohm's law.

A: In this question we will find power in DC circuit using ohms law...

Q: Answer the following. Use a detailed explanation. In clamping circuit, what is the value of the sum…

A: The upper or lower extremity of a waveform is clamped to a set DC voltage level by a clamping…

Q: ACTIVITY 4 ELECTRIC CIR CU ITS Direction: solve and analyze each of the following problem in neat…

A: This question belongs to circuit theory . It is based on the concept of transient analysis. It is…

Q: Q.1. a) Define 'Overvoltage' and briefly describe types of overvoltages in electrical system

A: Overvoltages protection devices Lighting arrangement Overhead earth wire Earthing screen....etc

Q: Find the currents passing through the points A, B, C and D in the electric circuit in the figure.…

Q: What is the maximum electric and magnetic fields you would expect to tind under a 165KV transmission…

Q: Alternating Current System A series connection of a 30-ohm resistor and a 100-mH inductor is…

Q: A constant inductance of 1 henry and a variable resistance R are connected in series with a constant…

A: we need to find out value of E.

Q: For the electric circuit shown in Figure (Q.4) use Kirchhoff's laws to find the value of unknown…

A: we need to find a unknown current in the given circuit.

Q: An inductance of 2 Henries and a resistance of 20 ohms is connected in series with an emf of E…

Q: 18. An iron-cored electromagnet has a d.c. resistance of 7.5 2 and when connected to a 400-V 50-Hz…

A: Note : as per our honor code, we are authorized to answer up to 3 sub-parts, we’ll answer the first…

Q: The effective resistance of a 500 V, 50 KVA alternator is 0.2 Q. A disturbing electric current of 10…

A: Given a 500 V, 50 KVA alternator having, Effective resistance, Ra=0.2 Ω Distributing current, I=10 A…

Q: 9. Ohm's Law and DC Circuit: Suppose, your team was assigned to check the status of the wiring in a…

Q: An inductance of 0.106 Henry is connected to a 120-volt 60-cycle source. Calculate (d) the maximum…

Q: . A constant inductance of 1 henry and a variable resistance R are connected in series with a…

Q: B D E charged, rank the potential at points A–E, fror +

A: This question is from the basic network as well as field theory. Under which we are going to study…

Q: ii) An emf, 2.5kV induced in a coil when a current of 2.75A collapses uniformly to 1.75A in 4ms.…

Q: 2. A burst controlled triac is feeding a 200 ohm resistive load. The AC supply providing 240 V rms…

Q: Q.1 (a) What are the various sources of energy for power generation and discuss their merits and…

A: Any natural resource that can be replaced rapidly and reliably qualifies as a renewable energy…

Q: Write your conclusion in this module on how the hydro-electric power affects the needs of the…

A: Different energy sources are required in day to day life. These energy sources can be renewable or…

Q: An iron cored choke coil has an equivalent resistance of 5 ohm. It draws 10 A when the applied…

Q: The capacitance is defined as O The flux linkages per ampere O The charge per unit of potential…

A: A capacitor is an electric device that stores charge in the form of electric potential energy. A…

Q: An automotive alternator is rated 500 VA and20 V. It delivers its rated voltamperes at a powerfactor…

A: Given Power P=500 VA Supply voltage VL=20 V Power factor cosϕ=0.85 Resistance per phase R=0.05 Ω…

Q: Two electric circuits, represented by boxes A and B, are connected as shown. The reference direction…

A: To understand the logic behind the power flow consider the following equation and diagram In the…

Q: Switch ww 10 15 V L 1H

Q: A resistance 10 Ω and inductance 100mH in series, is connected to a 200V, 50 Hz supply. Calculate…

Q: In the figure below, find currents ı, lz and I. If the current should point in the opposite…

A: To find the current i1. i2, and i3 we can apply mesh analysis. There are two meshes, the respective…

Q: A potential difference of 240 V is applied to a field winding at 15 °C and the current is 4.8 A.…

A: Given data, Potential difference V = 240 V. Current at temperature 150C is 4.8 A. Current at mean…

Q: In the magnetically connected circuit in the figure, find the current i1(t) and the input…

A: We will apply KVL in two loops to get I1. First we will apply KVL in outer loop to get I2 in terms…

Q: Q1. The boost-converter operates Of frequency 0.5 Khz from 100 Volt DC source supplying 10 Ohm pure…

A: For boost converter vo=Vs*(1/1-D) Where D is the duty cycle = Ton / T.

Q: Inductive reactance, resistance, and impedance are all measured in ohms. What is the common…

A: When an electric current flows through a resistive circuit, the current faces an opposition. In…

Q: 1. In order to decrease magnetic flux of the air gap for the same current of the coil, one should:…

A: To decrease the magnetic flux in the air gap for the same current of the coil, Consider the relation…

Q: a) Find the mathematical expression for current İ2(t)

A: Find the mathematical expression for current İ2(t) as per our guidelines we are supposed to…

Q: What will happen to the value of the impedance if the resistance will be increased or decreased?…

Q: Bar type CT has the following parameters: CT ratio = 2000/5 A Maximum primary current = 40 kA…

A: We have given the following problem Bar type CT has the following parameters:CT ratio = 2000/5…

Q: tate the principle of Ac generator.

A: AC generator - An alternating current generator (AC generator) is a system that transforms…

Q: Two coils A and B known to have the same resistance are connected across a 110-volts, 60 cycle line.…

A: Given data, Two coils are connected in series. Resistance of both coils are same. Supply 110 V, 60…

Q: An inductance of L Henries and a resistance of 15 ohms are connected in series with EMF of 135…

A: Apply KVL in loop to find diffrential equation defining inductor current. Using diffrential…

Q: Oc test is performed at nominal flux and SC test at Nominal Current nt Can't Say False True cetTTux

A: we need to explain given statement.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Based on Figures la,1b and 1c and RLC elements, write a discussion on voltage-current relations and power factor. Im A Im A Im A V Re Re Re Figure la. Figure 1b. Figure 1c.
Determine the loop currents Ia, I,, and Ic. 100 Ic 100 100 100 100 Ib 55V 100 V la
Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,677 ohms R2 = 1,966 ohms L1 = 3 Henry L2 = 1 Henry Vs = 5 Volts Frequency = 55 Hz What is the Total Impedance (Amplitude) in ohms?
If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship between the applied circuit voltage and the circuit current? The applied voltage lags the circuit current. The phase shift between the circuit voltage and current changes with time. The applied voltage is in phase with the circuit current. The applied voltage leads the circuit cur Previous Page Next Page Page 2 of 10
When a voltage of 100V at 50Hz is applied to a choking a coil A, the current taken is 8A and the power is 120W, when applied to a coil B, the current is 10A and the power is 120W. what power will be is 10A and the power is 120W. what power will be taken when 100V is applied to the two coils connected in series?
20. The resistance R and a 2 μF capacitor are connected in series across 200-V dc supply. Across the capacitor is a neon lamp that strikes at 120 volts. Calculate the value of R to make the lamp strikes 5 seconds after the switch has been closed. A. 4.89 kΩ B. 4.89 MΩ C. 2.73 MΩ D. 2.94 MΩ
A direct current of 12.5 A flows in a 25-ohm resistance. Determine the maximum value of an alternating current that will produce heat at the same rate in this resistance. Expresss answer to the nearest hundredths.
Determine the DC currents (IB, Ic and lĘ) and dc junction voltages (VBE, VCE and VCB) Ig=Blank 1 mA, Ic=Blank 2 mA, IĘ=Blank 3 mA, VBE= Blank 4 V, VCE = Blank 5 V and VCB = Blank 6 V Use 2 decimal places. Use the following values: VBB = 2V RB = 7 kQ Rc = 248 Q Vcc = 19 V BDc = 56 Blank 1 Add your answer Blank 2 Add your answer Blank 3 Add your answer Blank 4 Add your answer Blank 5 Add your answer Blank 6 Add your answer
Here are the choices: Lorentz law charge Faraday's law Ohm's law Capacitance Resistivity of materials Resistance vs Strain
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
what us the resistance of teb 240- resistors connected in series? in parallel?
Given the zener voltage at 9V and the zener power at 1W, what is the range of allowable values of Iz (operating values). Choices: 0.11A 22mA to 89mA 9A 0.11A to 9A Plss show complete solution