plz solve it within 30-40 mins I'll give you multiple upvote hand written An area-variation-based capacitive accelerometer, as shown in Figurebelow, has the following parameters:finger length If= 300 µm, mass lengthIm = 280 µm, numberof fingers n = 100, air gap dr = 1 um, and the relativepermittivity ɛr= 7. If the measured capacitance change AC is 50.34 pF, findthe angel 0 in degrees (o)AnchorBeamBeamAnchorMassF= mãFixedSupportpostsMassfingersfingersGlass substrate

Answered: Image /qna-images/answer/a3865cbd-41be-43a6-a068-79f501edcf3f.jpg

An area-variation-based capacitive accelerometer, as shown in Figure below, has the following parameters: finger length I₁ = 300 μm, mass length Im = 280 μm, number of fingers n = 100, air gap df = 1 µm, and the relative permittivity &r= 7. If the measured capacitance change AC is 50.34 pF, find the angel in degrees (o) Anchor Beam Beam Anchor ♫7. Support posts Mass Mass fingers F=ma Glass substrate Fixed fingers

An area-variation-based capacitive accelerometer, as shown in Figure below, has the following parameters: finger length I₁ = 300 μm, mass length Im = 280 μm, number of fingers n = 100, air gap df = 1 µm, and the relative permittivity &r= 7. If the measured capacitance change AC is 50.34 pF, find the angel in degrees (o) Anchor Beam Beam Anchor ♫7. Support posts Mass Mass fingers F=ma Glass substrate Fixed fingers

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The response of a certain dynamic system is given by: x(t)=0.003 cos(30t) +0.004 sin(30r) m (5Mks) Determino: (i) the amplitude of motion. (2Mks) (ii) the period of motion. (in) the linear frequency in Hz. (4) the angular frequency in rad/s. (2Mks) (2Mks) (2Mks) (2Mks) (v) the frequency in cpm. (vi) the phase angle. (2Mks) (vii) the response of the system in the form of x(t) = X sin(t +$) m.
Consider a second order system given by 10 d²x(t)/df² + 6 dx(t)/dt + 42 x(t) = 4 cost. What is the natural frequency in rad/s? Do not include units. Write your answer in scientific notation using 3 significant figures. (eg. 1.23e1)
Question 3 Find the natural frequency (in rad/sec) of the system in In the figure below: Use: m1= 5 kg, k1 = 53 N/m, k2 65 N/m and k3 18 N/m Write your answer to FOUR significant figures. Don't write the units X1 X2 k1 k2 k3 W ww m1
! Required information Sometimes manometer dimensions have a significant effect. In the given image, the containers (a) and (b) are cylindrical and conditions are such that Pa = Pb, for d= 0.2D. L D (a) Water Numeric Response -d D (b) SAE 30 oil H Take y=9790 N/m³ for water and 8720 N/m³ for SAE 30 oil. Comparing the above two cases, what is the percentage change in the value of Ap?
QUESTION 1 Consider a 2 DOF system shown below. x1 X2 k₁ m2 m1 F F₂ Find the fundamental frequency (in rad/s) for the system shown below. Keep 3 significant digits, use scientific notation, and omit units. Let m1 = 1, m2 = 4, k1 = 5, k2 = 9, and k3 = 1.
Measurements at a certain point of a pipe have been done where the following parameters were recorded: Fluid of density = 887 kg/m3, Fluid velocity = 4 m/s, Pressure= 11.3 KN/m2 If the total energy per unit weight at this point = 32 m, then the potential energy is: O Zero m 10 m 20 m 30 m &
Q2 Figure Q2 shows the schematic diagram of wind turbine which used in power plant. By using the exact solution method, it is found that the fundamental natural frequency for the system is wn = 0.6/kt/J rad/s. Assume that J, =J2 = J, and k; = k;2 = kị. By using Rayleigh's method, predict the fundamental natural frequency in Hertz natural frequency in Hertz unit and its corresponding mode shape for Q2(a) answer if the initial trial vector is (). Use J= 2, and k, = X, and show up 2.9 %3D X=6 Rotor Hub - Low-speed shaft - Gearbox J, - High-speed shaft Nacelle- |02 Tower LGenerator J: Figure Q2 Blade Blade
(c) An electric dipole consists of 0.003 kg spheres charged to ∓3e-09 C at the ends of a 0.16 m long non-conducting rod of mass 0.006 kg The dipole rotates on a frictionless pivot at its center. The dipole is held perpendicular to a uniform electric field with a field strength 1000 V/m, then released. What is the dipole's angular velocity (in rad/s) at the instant it is aligned with the electric field? (HINT: Look up the moment of inertia of the rotating rod about its center and don't forget the rotational kinetic energy term (along with the other terms) when you set up your conservation of energy problem). a)0.0534 b)0.446 c)0.289 d)0.119 e)0.137 f)0.205 (d) Four 1.9e-08 C charges are held in location to form a perfect square with sides of length 0.1 m. Two of the charges from opposing corners are released simultaneously, the other two are held in place. The mass of each charge is 0.003 kg. How fast (in m/s) will the two released charges be moving when they are far, far away from…
r:09 moodle1.du.edu.om An application demands that sinusoidal pressure variation of 250 Hz be measured with no more than 2% dynamic error. In selecting a suitable pressure transducer from vendor catalog, you note that a desirable line of transducer has a fixed natural frequency of 500 Hz but that you have a choice of transducer damping ratio of between 0.5 and 1.5 in increments of 0.05. select a suitable transducer. The value of damping ratio is between the following values Select one: O a. 0.707 and 0.807 O b. 0.631 and 0.692 c. 0.2356 and 0.5625 d. 0.5215 and 0.5625 Previous page Next page 1 Assignmen II
(Vibrations) QI find Keff)A & Keff)B for the 2 d.o.f system. what do you discover? K1=10 K2=20 A 1 m C 1 m В
Consider longitudinal eqns and assume motion ů = = 0. i) úi) 8 = - Zu be here to search H where u (no contral input) x = 0. (Zu: normalized derivative) iii) It X₁₂ = 0, Lanchester formula for the frequency of oscilation (in re) can be obtained from this simplified motion Argue that (DOLL 38°F Clear A CO
The isotropic reducing of the dimensions influences of the frequency as : Decreasing of natural frequency Increasing of natural frequency No change of natural frequency Resonance exiting Antiresonance exiting