Answered: A unitorm 400 N beam of length L = 4 m…

A unitorm 400 N beam of length L = 4 m is supporting a 2000 N box as shown. Find the tension in the tie rope and the force F exerted by the hinge at point P. T=? 44 150 F=? P.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section8.3: Equilibrium

Problem 40PP

See similar textbooks

Related questions

Q: Determine the image position. Express your answer with the appropriate units. Enter positive value i...

Q: If a 2.4 kg object is initially at rest on a frictionless, horizontal surface and subjected to a 11...

A: The equation of motion we use to solve this is v2-u2 = 2as, where v = the final velocity u = the ini...

Q: *12-24. The acceleration of a particle traveling along a straight line is. a= s/2 m/s, where s is in...

Q: 13. How much voltage would be necessary to generate 20 amps of current in a circuit that has 5.5 ohm...

Q: MA = 10 kg and MB = 20 kg are connected by a rigid bar of negligible mass. Find the acceleration of ...

A: We have two masses MA=10 kg and MB=20 kg which are connected by a massless rod and are going down an...

Q: Does something so small matter? What is the difference in the force experienced by the dancer (50 kg...

Q: at an amusement park, a swimmer uses a water slide to enter the main pool.the swimmer slides without...

Q: Look at the figure below. The horizontal beam weighs 200N, Find the tension in the cable if the obje...

Q: A series RL circuit includes a 8.05 V8.05 V battery, a resistance of ?=0.655 Ω, and an inductance of...

Q: Two bowling balls are at rest on top of a uniform wooden plank with their centers of mass located as...

Q: Sound with froquency 1270 Hz loaves a room through a doorway with a width of 1.15 m. At what minimum...

Q: A woman stands on a weighing scale while riding in an elevator. When the elevator is at rest, the sc...

Q: Consider a rectangular soap film placed vertically with thickness increasing linearly from top to bo...

A: (a) Interference in reflected light in a soap film The figure contains a vertices film. For convenie...

Q: In the figure, four long straight wires are perpendicular to the page, and their cross sections form...

A: Given, Current=4A Length=18cm

Q: A 1.5 kg object slides across a horizontal surface with an initial speed of 6.84 m/s. If the object ...

Q: if john uses a window fan 200 watts 4 hours a day for 120 per year how muc does it cost him to run h...

A: Given: The fan is of 200 W Uses is 4 hours a day Total days 120 days per year To find: How much do...

Q: A solid metal sphere of radius 2.10 m carries a total charge of -4.20 nC. What is the magnitude of t...

Q: If the magnitude of the maximum velocity of a mass attached to a spring in SHM is 4.85 m/s. Also the...

Q: A 6kg hoop 3m in diameter rolls down from rest on a plane inclined 40 degrees. The height of the inc...

Q: NA football player of mass 95 kg is running at a speed of 5.0 m/s down the field as shown in Figure ...

A: A football player of mass, m1 = 95 kg is running at a speed of v1 = 5.0 m/s down the field as shown ...

Q: A 1.0-kg ball travelling at 4.0 m/s strikes a wall and bounces straight back at 2.0m/s. a. What is ...

A: mass of ball, m= 1 kg speed of the ball before striking the wall, V1 = 4 m/s speed of the ball after...

Q: The acceleration of a particle is defined by the relation a = kt² . Knowing that v = -8 m/s when t =...

Q: 1. In the figure, the lines represent equipotential lines. A charged object is moved from point P to...

Q: A 1kg-basebal coming from the east is approaching Miyuki 10m/s. He hits the caseball back where it c...

Q: Which of the following statements is TRUE? a. The magnetic flux is zero for any closed three-dimensi...

A: Answer :Correct Answer is option (d) Magnetic field lines indicates the direction of magnetic field ...

Q: An RLC circuit has L = 250 mH, C = 0.200µF, and R = 2.00 kn. What is the angular frequency of its da...

Q: A ball is projected upward with an initial speed of approximately 30 m/s. The diagram at the right r...

A: Given Data: The initial speed of the ball is: u=30 m/s The required speed of the ball is: v=-20 m/s

Q: Some charged ions are palced between two long, parallel bars seperated by .20 m. A potential differ...

A: Given that:Separation bewteen the bars: d=0.20 mPotential difference: ∆V=100 VPotential of the top b...

Q: 5. A negative point charge moves through the region with uniform electric and magnetic fields shown ...

Q: When s tant star is focused by the lens onto the retina (Eigure 1). With r of 3.0 mm, the intensity ...

A: Light from a distant star is focused by the lens onto the retina With a pupil diameter of 3.0 mm th...

Q: what is the magnitude of the total momentum of these carts?

A: The momentum of a body is given by p = mv, where m = the mass of the body v = velocity of the body

Q: f the lateral magnification of an object is 1.4 and the focal length of the converging lens is 12.1 ...

Q: 2. Two point charges, +q and -q, are placed as shown. Rank the five points labeled A, B, C, D, and E...

A: Electric field concept is use here.

Q: Find the current in a long straight wire that would produce a magnetic field twice the strength of t...

Q: FR-4 A block of mass m-4.75kg can be kept from sliding down the rough vertical side of a cart if the...

Q: A large grinding wheel in the shape of a solid cylinder of radius 0.330 m is free to rotate on a fri...

Q: A uniform 400 N beam of length L = 4 m is supporting a 2000 N box as shown. Find the tension in the ...

Q: In the figure, four long straight wires are perpendicular to the page, and their cross sections form...

Q: A student has a calorimeter with 211.7 grams of 29.1∘C water contained within it. The student then ...

A: Given that:m1=211.7 gT1=29.1°Cm2=116.5 gT2=89.7°CLet the final equilibrium temperature is T °C

Q: A ball is thrown so that it just clears a 25ft wall 100ft away. If it left the hand 5ft above the gr...

Q: Draw the phasor for the emf E (170 V) cos ((2T × 60 Hz)t) at t = 60 ms.

Q: A 6kg hoop 3m in diameter rolls down from rest on a plane inclined 40 degrees. The height of the inc...

Q: A musical instrument that has a tube closed at one end has a length of 27.3 cm long. On a particular...

A: Frequency for one end closed tube Frequency = speed of sound in air ×(2n-1) /4L Where n= 1,2,3.......

Q: A proton is released from rest from the surface of a +5000. V electrode. It crosses the gap between ...

Q: 1. A car accelerates from rest for 6 seconds with a constant acceleration of 1.5 m/s?. Find the fina...

A: Given data : Time=t Acceleration=a Initial velocity=U Required : Final velocity

Q: A 5.0-kg block moves in a straight line on a horizontal frictionless surface under the influence of ...

A: Given: The mass of the block m = 5 kg The initial speed of the particle u = 4 m/s The Force (F) and ...

Q: A proton is released from rest from the surface of a +5000. V electrode. It crosses the gap between ...

A: Given, Magnetic field=8.60T

Q: An object on the left has a charge of +50 μC and the charge on the right has a charge of -20μC and a...

Q: Calixta whose mass is 60 kg stands 1.5 m away from one end of a uniform 6.0-m-long plank of mass 80....

Q: Calculate the total resistance of the circuit shown below. 24 0 48 0 A 16 Q B 24 2 72 2 48 2

A: Given data: Two resistors are connected in parallel R1 = 24 Ω and R2 = 48 Ω Required: The total res...

Concept explainers

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics.

Equilibrium of Forces

The tension created on one body during push or pull is known as force.

Question

A unitorm 400 N beam of length L = 4 m is supporting
a 2000 N box as shown. Find the tension in the tie rope
and the force F exerted by the hinge at point P.
T=? L44
A50
F=?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Problems 33 and 34 are paired. One end of a uniform beam that weighs 2.80 102 N is attached to a wall with a hinge pin. The other end is supported by a cable making the angles shown in Figure P14.33. Find the tension in the cable. FIGURE P14.33 Problems 33 and 34.
A wooden door 2.1 m high and 0.90 m wide is hung by two hinges 1.8 m apart. The lower hinge is 15 cm above the bottom of the door. The center of mass of the door is at its geometric center, and the weight of the door is 260 N, which is supported equally by both hinges. Find the horizontal force exerted by each hinge on the door.
(a) What minimum coefficient of friction is needed between the legs and the ground to keep the sign in Figure 9.35 in the position shown if the chain breaks? (b) What force is exerted by each side on the hinge?
In order to get his car out of the mud, a man ties one end of a rope to the front bumper and the other end to a tee 15 m away as shown below. He then pulls on the center of the rope with a force of 400 N, which causes its center to be displaced 0.30 m, as shown. What is the force of the rope on the car?
A stepladder of negligible weight is constructed as shown in Figure P12.40, with AC = BC = = 4.00 m. A painter of mass m = 70.0 kg stands on the ladder d = 3.00 m from the bottom. Assuming the floor is frictionless, find (a) the tension in the horizontal bar DE connecting the two halves of the ladder, (b) the normal forces at A and B, and (c) the components of the reaction force at the single hinge C that the left half of the ladder exerts on the right half. Suggestion: Treat the ladder as a single object, but also treat each half of the ladder separately. Figure P12.40 Problems 40 and 41.
Ruby, with mass 55.0 kg, is trying to reach a box on a high shelf by standing on her tiptoes. In this position, half her weight is supported by the normal force exerted by the floor on the toes of each foot as shown in Figure P14.75A. This situation can be modeled mechanically by representing the force on Rubys Achilles tendon with FA and the force on her tibia as FT as shown in Figure P14.75B. What is the value of the angle and the magnitudes of the forces FA and FT? FIGURE P14.75
When the structure shown below is supported at point P, it is in equilibrium. Find the magnitude .of force F and the force applied at P. the weight of the structure is negligible.
In Example 14.3, we found that one of the steel cables supporting an airplane at the Udvar-Hazy Center was under a tension of 9.30 103 N. Assume the cable has a diameter of 2.30 era and an initial length of 8.00 m before the plane is suspended on the cable. How much longer is the cable when the plane is suspended on it?
A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the wall and the other end of the strut is attached to a sign that weighs 200.0 N The strut is also supported by a cable attached between the end of the strut and the wall. Assuming that the entire weight of the sign is attached at the very end of the s find the tension in the cable and the force at the hinge of the strut.
In the What If? section of Example 12.2, let d represent the distance in meters between the person and the hinge at the left end of the beam. (a) Show that the cable tension is given by T = 93.9d + 125, with T in newtons. (b) Show that the direction angle of the hinge force is described by tan=(323d+41)tan53.0 (c) Show that the magnitude of the hinge force is given by R=8.82103d29.65104d+4.96105 (d) Describe how the changes in T, , and R as d increases differ from one another.
The light boom AB is attached to a vertical wall by a ball and socket joint at A and supported by two cables at B. A force P is applied at B where P = 19i - 10j kN.Note that the reaction force at A acts along the boom because it is a two-force member. Magnitude of the reaction force at A in kN = 34.8 Calculate the magnitude of the tension in cable BD in kN
A uniform beam 3.7 mm long and weighing 3000 NN carries a 3000 NN weight 1.50 mm from the far end, as shown in (Figure 1). It is supported horizontally by a hinge at the wall and a metal wire at the far end. a)How strong does the wire have to be? That is, what is the minimum tension it must be able to support without breaking? b)What are the horizontal component of the force that the hinge exerts on the beam? c)What are the vertical component of the force that the hinge exerts on the beam?