A uniform rod has mass m and length L. One end of the rod is attached to a fixed point O by a hinge and an additional force F is applied to the other end of the rod in the horizontal direction shown. 30° mg F Given that the rod is in mechanical equilibrium, what is the magnitude of the applied force F, expressed as a numerical multiple of mg, where g is the magnitude of the

A uniform rod has mass m and length L. One end of the rod is attached to a fixed point O by a hinge and an additional force F is applied to the other end of the rod in the horizontal direction shown. 30° mg F Given that the rod is in mechanical equilibrium, what is the magnitude of the applied force F, expressed as a numerical multiple of mg, where g is the magnitude of the

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 38P: A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the...

See similar textbooks

Similar questions

A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the wall and the other end of the strut is attached to a sign that weighs 200.0 N The strut is also supported by a cable attached between the end of the strut and the wall. Assuming that the entire weight of the sign is attached at the very end of the s find the tension in the cable and the force at the hinge of the strut.
In order to get his car out of the mud, a man ties one end of a rope to the front bumper and the other end to a tee 15 m away as shown below. He then pulls on the center of the rope with a force of 400 N, which causes its center to be displaced 0.30 m, as shown. What is the force of the rope on the car?
A wooden door 2.1 m high and 0.90 m wide is hung by two hinges 1.8 m apart. The lower hinge is 15 cm above the bottom of the door. The center of mass of the door is at its geometric center, and the weight of the door is 260 N, which is supported equally by both hinges. Find the horizontal force exerted by each hinge on the door.
When tightening a bolt, you push perpendicularly on a wrench with a force of 165N at a distance of 0.140m from the center of the bolt. How much torque are you exerting relative to the center of the bolt?
Problems 33 and 34 are paired. One end of a uniform beam that weighs 2.80 102 N is attached to a wall with a hinge pin. The other end is supported by a cable making the angles shown in Figure P14.33. Find the tension in the cable. FIGURE P14.33 Problems 33 and 34.
A safe mass M = 430kg hangs by a rope from a boom has a mass m = 85kg. Find the tension T, in the cable and the magnitude of the net force exerted on the beam by the hinge. Cable Rope (a) Hinge Beam com
A 1260 N uniform beam is attached to a vertical wall at one end and supported by a cable on th other end. A 1960 N crate hangs from the far end of the beam. Using the info on the diagram find the following: a) Magnitude of the tensiossnj on the cable b) the horizontal components of the varce that the wallexerts on the beam c) the vertical components of the force that the wall exerts on th eleft end of the bean
Suppose the length L of the uniform bar is 3.0 m and its weight is 210 N. The block's weight is 340 N and is located at distance x = 0.75 m from the wall, and the angle = 25°. What are the (a) horizontal and (b) vertical components of the force on the bar from the hinge at A? com 4.
A uniform rod has mass m and length L. One end of the rod is attached to a fixed point O by a hinge and an additional force F is applied to the other end of the rod in the direction shown, perpendicular to the rod. Given that the rod is in mechanical equilibrium, what is the magnitude of the applied force F, expressed as a numerical multiple of mg, where g is the magnitude of the acceleration due to gravity? Express your answer as a decimal number, specified to 3 significant figures
A horizontal plank 4.00 m long and having mass 20.0 kg rests on two pivots, one at the left end and a second 1.00 m from the right end. Find the magnitude of the force exerted on the plank by the second pivot.
A 3.0kg uniform pole 1.8m long is held horizontal by a hinge to a wall and supported by a cable attached to its center which forms a 45° angle with the pole. A large bird house with a mass of 6.6kg is at the end of tge pole. Find the force that the hinge exerts on the pole.
A uniform beam (weight 80 N, length 6 meters) is being supported by cable and a hinge on a wall. The cable is attached to the beam for meters from the hinge. A 100 Newton sign hangs off the end of the beam. Determine the tension and the cable buy some in the talks about the hinge.