A uniform plank of length 2.00 m and mass 29.0 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 705-N person is d = 0.500 m from the left end. magnitude of T, 493.56 378 Your response differs from the correct answer by more than 10%. Double check your calculations. N 671.95 Your response differs from the correct answer by more than 10%. Double check your calculations. N magnitude of T, magnitude of T3 40.0° -2.00 m

A uniform plank of length 2.00 m and mass 29.0 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 705-N person is d = 0.500 m from the left end. magnitude of T, 493.56 378 Your response differs from the correct answer by more than 10%. Double check your calculations. N 671.95 Your response differs from the correct answer by more than 10%. Double check your calculations. N magnitude of T, magnitude of T3 40.0° -2.00 m

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The leg and cast in the figure below weigh 250 N, with the center of mass as indicated by the blue arrow in the diagram. The counterbalance wi weighs 110 N. Determine the weight wa and the angle a needed so that no force is exerted on the hip joint by the leg plus cast. 172.4 Your response differs from the correct answer by more than 10%. Double check your calculations. N 62.19 Your response is within 10% of the correct value. This may be due to roundoff error, or you could have a mistake in your calculation. Carry out all intermediate results to at least four-digit accuracy to minimize roundoff error. 40
The pulley system holding a crate of unknown weight is at equilibrium. Cord BD can support a maximum load of FBD = 1860 N. www D 01 A B a. Determine the maximum weight of the crate, W. b. Determine the angle 0₁. Round your final answers to 3 significant digits/figures. ) N W = 0₁ = 12 5 13 degrees
A uniform plank of length 2.00 m and mass 29.5 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 705-N person is d-0.500 m from the left end. magnitude of T magnitude of T magnitude of N T. 2000 Q
The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces shown, and their effect on the design of the attachment at A must be determined. Replace the two forces and couple by an equivalent couple M and resultant Rat A. The couple is positive if counterclockwise, negative if clockwise. 2.19 KN 0.65 m 1.74 m. 75° A Answers: M = i R=( i y 550 N.m kN.m i+ i 0.16 m 0.16 m 1.17 KN j) kN
A uniform plank of length 2.00 m and mass 35.0 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 705-N person is d = 0.500 m from the left end. magnitude of T, magnitude of T, N magnitude of T, N 40.0° -2.00 m-
A uniform plank of length 2.00 m and mass 28.0 kg is supported by three ropes, as indicated by the vectors in the figure below. Find the tension in each rope when a 710-N person is d= 0.500 m from the left end. Solve for magnitude of T1, T2, and T3.
A uniform plank of length 2.00 m and mass 31.0 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 680-N person is d = 0.500 m from the left end. magnitude ofT magnitude of T, magnitude of T, N N N 40.0° 2.00 m
A 70.0 cmcm, uniform, 40.0 NN shelf is supported horizontally by two vertical wires attached to the sloping ceiling (Figure 1). A very small 15.0 NN tool is placed on the shelf midway between the points where the wires are attached to it. 1. Find the tension in the left-hand wire. 2. Find the tension in the right-hand wire.
A uniform plank of length 2.00 m and mass 32.0 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 690-N person is d = 0.500 m from the left end. magnitude of T. magnitude of T2 N magnitude of T. 40.0° 2.00 m Need Help? Read It
A 159.8-N bird feeder is supported by three cables as shown in the figure below. Find the tension in each cable. left cable N right cable N bottom cable N 60° Bird food 30° ☹
A block resting on a plane inclined at an angle e 32° from the horizontal is being held in place by steel cables a, b, and cas shown in the figure below. The tension in cable bis 80.0 N. Note that cable ais parallel to the surface of the incline and that cable bis 42° C perfectly horizontal. a) Create an FBD around point Dand determine the tension in wire a and wire C. b) Create an FBD around the block and determine the normal force Nand the force due to gravity Fg. c) What is the mass of the block in kilograms?
SAQ 1 1.2 m D C An 80-kn'm couple shown in the plate is caused by a pair of parallel forces of magnitude F (not shown). Determine: 80 kN m a) the smallest possible value of F, and 1.6 m b) the value of F if the forces act at points A and C and are parallel to the dashed line shown at A. A В 60°