K = 1.4*10-4 A medium sand aquifer 30m thick has two monitoring wells spaced800m thick along the direction of flow. The groundwater level in thefirst well is 260.0 m above sea level, and 254.0 m in the second well.Estimate the rate of flow per meter of width (distance perpendicular tothe flow). What is the average linear velocity of the water, given thatporosity is 0.5? Hint: use the value of K from example.

Given:To find:(a) Rate of flow per meter of width.(b) Average linear velocity of water.

Answered: A medium sand aquifer 30m thick has two…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

9- It flows (10 cm³) of olive oil during a capillary tube (2 cm in length and (0.04 mm in diameter) If the height of the olive oil in the capillary tube (2.5 cm), calculate the time of the olive oil flow into the capillary tube, if you know that the viscosity of the oil ( n oil = 0.18 N .sec/m? ) density of oil (0.918 )? cm VX II >
The laminar flow of a fluid with a constant viscosity, 4, inside a channel is governed by the following boundary value problem (strong form): d'u dp for y E (0, h) "dy dr u = 0 at y = 0 and y = h vhere u is the fluid velocity and is the pressure drop in the direction of the flow. a) Derive the weak form of the boundary value problem described above.
1) Consider the wave of small wave elevation in water of infinite depth. By linearization the water fluid flow can be described by velocity potential o which satisfy linear equations. i. For the wave described by: o ekz sin(kx – wt) and 3 = acos(kx – wt) show that: a. The potential energy in a wave length is Apga?/4. b. The kinetic energy in the wave length is Apga?/4 as well.
1) The velocity profile of a viscus fluid over a plate is parabolie with vertex 25 em from the plate ,where the velocity 125 cm/s. calculate the velocity gradient and shear stress at distance of (0, 5, 15 and 25 cm) from the plate given the viscosity of the fluid =7 poise ? Also draw the figure explain the relationship between the velocity gradient and shear stress. Take velocity profile for parabolic equation, (v = ay + by + c)
At a point in a pipe that lay flat ノ water in the pipe flows at a speed of 9.0 mls and has 6-40x 104 Pa a gaoge pressure is Find the gauge pressure at point 2 of pipe that lower than the first point 8.0 m and the cvoss - se ctional| area of the pipe is double of first point . Answer [1.52x105 Pa]
On a single plot, plot three curves that show the relationship between the pressure generated by thepump as a function of flow rate of water at 20 °C through the three branches of the piping systemshown below. Delta P on y axis and flow rate on the x axis. The pressure range is 0 to 1 MPa. (Branches 1 and 3 are in the same plane; branch 2 is located 5 m above the other two branches. Pipe inner diameter: 0.0254 mPipe material: copperTypical mass flow rate of interest: 0.5 kg/sIgnore minor losses of tee's at points A and B and any features of branch 3Consider minor losses of two 90° elbows in branch 2
The velocity distribution in a 0.02 m diameter horizontal pipe conveying carbon tetrachloride (specific gravity = 1.59, absolute viscosity = 9.6 x 10-6 Pa sec) is given by the parabolic equation: v(r)=0.01(0.12- r?), where v(r) is the velocity in (m/s) at a distance r in (m) from the pipe center. What is discharge? O a. 3.13 x-8 m3/s O b. None of the mentioned O c. 1.047 x 108 m3/sec O d. 4.97 x 109 m3/sec
4. Water is flowing in a pipe with radius of 25.4 cm at velocity of 5 m/s. The viscosity of water is 1.131 Pa-s and its density is equal to 997.9 What is its Reynolds m³° number and type of fluid flow?
Simulation of laminar gas flow in the pipe with Ansys Fluent Task: 1. Calculate velocity distribution in y axis at inlet and outlet of the pipe. Submit it as a chart. 2. Calculate velocity distribution over the pipe length. Submit it as a chart. Figure. pipe geometry L, m = 16 R, m= 0.15 Inlet velocity, m/s= 0.08 Gas= Oxygen Need proper solution like pdf file, don't need steps by steps. If you can can do it through ansys fluent. Write proper solution on word file or pdf.
Solving fluid dynamic problem, flow through a cylinder, a uniform gradient only applied in z direction, If r is the radial polar co-ordinate, derive the velocity v_z(r) for steady flow at low Reynolds number. The result is about pressure gradient divide by 4 times viscosity and multiply by the difference of square of two distances. Do I need to convert distance into to radial polar co-ordinate in the result? How to consider this result in cylindrical coordinate?
Reynold's number of 11090 is obtained for a certain value opening in a shut off valve experimentjexercise 1), when water flows through a pipe of diameter 23 mm. The viscosity of water is 1.14 x10-Nm Find the velocity of flow for this valve opening in m/s=
two points; (D) gauge 10. A Terran T-280 SCV (space construction vehicle) examines a typical vespene geyser field, which normally contains 20 circular openings, each of which has a radius of 0.10 m. The geyser mouths (according to a sonar probe) are connected to a main geyser “pipe" 0.80 m in radius. If the speed of the vespene gas is 3.0 m/s through the main pipe, what is its velocity as it exits through one of the geyser mouths? spaads The

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS