hello, can you help me with this problem please ? Thank you! A force given by F = 42 23 + 3k is acting on an object at apoint of interaction that is given by ☞ = 17 + 23 – 3k. Thepivotpoint is located at 7 = 2î + 2ĵ – 2k. What is the torque dueto force around the given pivot point?482i+7j-2k2i+2j-12k9j - 10 k4None of the above.C& O

Given: F→=4i^-2j^+3k^ The point of interaction: r1→=1i^+2j^-3k^ The pivot point: r2→=2i^+2j^-2k^

A force given by F = 42 - 23+3k is acting on an object at a point of interaction that is given by 7 = 12 +23 - 3k. The pivot point is located at 7 = 2î + 2ĵ – 2k. What is the torque due to force around the given pivot point? 21+ 7j-2k 2i+2j-12k 9j-10 k کے None of the above.

A force given by F = 42 - 23+3k is acting on an object at a point of interaction that is given by 7 = 12 +23 - 3k. The pivot point is located at 7 = 2î + 2ĵ – 2k. What is the torque due to force around the given pivot point? 21+ 7j-2k 2i+2j-12k 9j-10 k کے None of the above.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter10: Fixed-axis Rotation

Section: Chapter Questions

Problem 19CQ: What three factors affect the torque created by a force relative to a specific pivot point?

See similar textbooks

Related questions

Q: In a single-slit diffraction experiment, the width of the slit through which light passes is…

A: From the diffraction due to single slit, we know that the width of the principal maxima is given by…

Q: The surface charge density on an infinite charged plane is -2.00 x 10-6 C/m². A proton is shot…

Q: A car traveling due north brakes to a stop. In what direction was the momentum change of the car?…

A: The given data we have: A car is moving in north direction. It brakes to stop. We need to find in…

Q: A copper block with a mass of 600 grams is cooled to 77 K by being immersed in liquid nitrogen. The…

Q: d. The resolving power is reduced to 1/4 of its original value. The resolving power does not change…

A: Given value--- refractive index of diamond = 2.41 . incidence angle = 75 degree. We have to…

Q: c. You lift the child by using your elbow joint (pivot point). If the child's mass is B kg and…

Q: Part 1: Based on what you see in the graph below, what it the object doing? (Be sure to include: if…

A: Given Graph between velocity and time is mentioned as shown in the figure. We have to find all the…

Q: An object is thrown at an initial speed of 15.8 m/s at an angle of 19.98 degrees to the horizontal.…

A: Given data: The initial speed of the object is u=15.8 m/s The projection angle of the object is…

Q: On one occasion during the current mission, James Bond throws a stone from the top of a building…

Q: d) How would your answer change for parts b and c if the survivors were stuck in a freshwater lake?

A: The only difference that happens in the calculations when the survivors are stuck in a freshwater…

Q: A cylinder containing ideal gas is sealed by a piston that is above the gas. The piston is a…

Q: For the items Unpolarized and LPz, consider two ideal polarizers, P1 and P2, that are oriented…

Q: For a spherical mirror situation, you have determined that s = 33 cm and s' = 79 cm. What is the…

Q: If the distance between the Earth and the Moon were 5 times farther apart, the gravitational force…

A: Consider the initial distance between the Earth and the Moon is r.

Q: Which of the followings is true for process 0→3? Select all apply. (0→4 and 0→8 are adiabatic…

A: 0 ---> 3 is an isothermal process. Lets check each option one by one 1. ∆Eth is positive Since…

Q: A particle moves in a straight line according to the v-t curve shown. What is the acceleration, in…

A: Given data: Velocity vs time graph for a particle moving in a straight line Required: The…

Q: You have made a physical pendulum by swinging a rod of mass M-1.08 kg and length L - 1.45 meters…

Q: An object is thrown at an initial speed of 33.3 m/s at an angle of 28.7 degrees to the horizontal.…

A: Given: The initial velocity of the object is 33.3 m/s. The angle of the projection is 28.7o. The…

Q: If you drop a textbook off a building that is 100 m tall, how much time will pass before the…

Q: Review Conceptual Example 2 as an aid in solving this problem. An object is attached to the lower…

Q: Part I - Matching - match each option with the type(s) of active energy it has 1. A moving car 2. A…

A: 1. A moving car has - Kinetic energy 2. A stretched rubber band -possess potential energy get…

Q: A star is observed to move away from us at a speed of 2.9km/s. How far is the star ? Express your…

A: Given data The velocity of the star observed is given as v = 2.9 km/s. The distance of the star…

Q: A transparent oil with index of refraction 1.22 spills on the surface of water (index of refraction…

Q: A diffraction grating has 300 lines per mm. If light of frequency 4.76 × 1014 Hz is sent through…

Q: A violin string has a fundamental frequency of 450 Hz. Which of the following frequencies can set…

Q: A spring (k = 970 N/m) is hanging from the ceiling of an elevator, and a 7.2-kg object is attached…

Q: A railroad car of mass 3.00 ✕ 104 kg moving at 3.30 m/s collides and couples with two coupled…

A: Given: The mass of each railroad car is 3x104 kg. The initial velocity of the first rail board card…

Q: How much does a helium-filled balloon weigh, if the empty balloon skin weighs 0.125 Newtons, the…

Q: Speed lang. A certain material has a dielectric permittivity and magnetic permeability 7μo. 3 2 An…

Q: 5. You are designing a diving bell to withstand the pressure of seawater at a depth of 250 m. a.…

Q: An adult is riding on a carousel and finds that he is feeling a bit nauseated. He then decides to…

A: initial linear speed = v final linear speed = v2.2angular velocity = 1 radsecradius = 4.6 m final…

Q: and 30kg blocks are attached as shown in the figure below. The length of the rope is constant with…

Q: A 1.00-cm-high object is placed 3.40 cm to the left of a converging lens of focal length 7.10 cm. A…

Q: Assume a point source emits 0.5 watts of radio waves that has frequency of 1.8 GHz. (a) Find the…

A: Given,The power of the emitted radio waves, P= 0.5 WattsFrequency of the radio waves, f= 1.8 GHz(a)…

Q: (Hint: You might want to use the trigonometric identity sin (20) = 2 sin(0) cos(0).)

A: Given value--- refractive index of polystyrene = 1.49. We have to find--- Find the angle of…

Q: Photons with a wavelength of 549 nm in air enter a plate of flint glass with index of refraction n =…

A: Given Wavelength of the photons in air is given as λ=549 nm=549×10-9 m Index of refraction of flint…

Q: PHYSICS: M1=7KG M2= 11KG Angle1= 15deg Angle 2 65deg Find acceleration and tension in the sring…

Q: The 40kg and 30kg blocks are attached as shown in the figure below. The length of the rope is…

Q: A horizontal 810-N merry-go-round of radius 1.20 m is started from rest by a constant horizontal…

A: here we will use the concept of torque A horizontal force apply a torque and due to this ,,merry go…

Q: y, a small piece of putty of mass m₁ is In fired with velocity v₁¡ at a stationary wooden block of…

Q: What is the photon frequency (Terahertz) needed to move an electron in a hydrogen atom from a lower…

A: We know by the Rydberg equation, 1/λ = R . [ (1/nf²) - (1/ni²) ] Here λ is the wavelength of the…

Q: the answer should be 26 according to the professor

A: If a stone is thrown with initial vi→ velocity, then after time t, the velocity of the stone com be…

Q: 10) What is the resistance of a copper bus-bar as used in the power distribution panel of a…

Q: A series RLC circuit consists of a 60 2 resistor, a 2.2 mH inductor, and a 720 nF capacitor. It is…

Q: Suppose that you are watching a train go by (as in, move away from you). The train horn’s natural…

A: Given Natural frequency of the train's horn is f0=175 Hz Speed of the train is Vs=35 m/s Speed of…

Q: The database says that the answer is incorrect. Is there a different way of solving it?

A: If a star is moving away from us at a velocity v, then its distance from us (according to the Hubble…

Q: For an approaching sound source (relative to a stationary observer), the frequency of the sound wave…

A: Required : Fill in the gaps

Q: In black-and-white photography if one uses red light of wavelength 627.7 nm in darkroom, the photons…

A: Given data: Wavelength (λ) = 627.7 nm Required: The photons energy in eV

Q: . Look at the circuit to the right. The EMF=25V, L=150mH, R₁=1000, and R₂=500. a. What is the…

Q: If f (t) has units of kg while K (t) has units of are the units on f f (t) K (t) dt kg for some…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

hello, can you help me with this problem please ? Thank you!

A force given by F = 42 23 + 3k is acting on an object at a
point of interaction that is given by ☞ = 17 + 23 – 3k. The
pivot
point is located at 7 = 2î + 2ĵ – 2k. What is the torque due
to force around the given pivot point?
48
2i+7j-2k
2i+2j-12k
9j - 10 k
4
None of the above.
C
& O

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

If a rigid body has a constant angular acceleration, what is the functional form of the angular position?
A top has moment of inertia 3.2104kgm2 and radius 4.0 cm from the center of mass to the pivot point. If it spins at 20.0 rev/s and is precessing, how many revolutions does it precess in 10.0 s?
A proton is accelerated in a cyclotron to 5.0106m/s in 0.01 s. The proton follows a circular path. If the radius of the cyclotron is 0.5 km, (a) What is the angular momentum of the proton about the center at its maximum speed? (b) What is the torque on the proton about the center as it accelerates to maximum speed?
What is the angular velocity of a 75.0-cm-diameter tire on an automobile traveling at 90.0 km/h?
A particle has mass 0.5 kg and is traveling along the line x=5.0m at 2.0 m/s In the positive y-direction. What is the particle’s angular momentum about the origin?
The axis of Earth makes a 23.5 angle with a direction perpendicular to the plane of Earth’s orbit. As shown below, this axis precesses, making one complete rotation in 25,780 y. (a) Calculate the change in angular momentum in half this time. (b) What is the average torque producing this change in angular momentum? (c) If this torque were created by a pair of forces acting at the most effective point on the equator, what would the magnitude of each force be?
What three factors affect the torque created by a force relative to a specific pivot point?
What is the torque abot the origin of the force if it is applied at the point whose position is:
Suppose the particles in the preceding problem have masses m1=0.10kg , m2=0.20kg , m3=0.30kg , m4=0.40kg . The velocities of the particles are . (a) Calculate the angular momentum of each particle about the origin. (b) What is the total angular momentum of the tour-particle system about the origin?
At a particular instant, a 1.0-kg particle’s position is , its velocity is , and the force on it is . (a) What is the angular momentum of the particle about the origin? (b) What is the torque on the particle about the origin? (c) What is the time rate of change of the particle’s angular momentum at this instant?
A diver off the high board imparts an initial rotation with his body fully extended before going into a tuck and executing three back somersaults before hitting the water. If his moment of inertia before the tuck is 16.9kgm2 and after the tuck during the somersaults is 4.2kgm2 , what rotation rate must he impart to his body directly off the board and before the tuck if he takes 1.4 s to execute the somersaults before hitting the water?
A cylinder with rotational inertia I1=2.0kgm2 rotates clockwise about a vertical axis through its center with angular speed 1=5.0rad/s . A second cylinder with rotational inertia I2=1.0kgm2 rotates counterclockwise about the same axis with angular speed 2=8.0rad/s . If the cylinders couple so they have the same rotational axis what is the angular speed of the combination? What percentage of the original kinetic energy is lost to friction?