A 47 kg shop sign hangs at one end of a uniform beam of length 1.9 m and 113 kg that is hinged on a front wall of the shop. The beam is supported by another cable as shown in the figure below that makes an angle 33 0 with the horizontal. Distance of the cable from the hinge on the beam is 1.5 m. Part A: Draw a Free Body Diagram Part B: FInd the tension in the cable. Part C: Find the horizontal and vertical forces exerted by the

A 47 kg shop sign hangs at one end of a uniform beam of length 1.9 m and 113 kg that is hinged on a front wall of the shop. The beam is supported by another cable as shown in the figure below that makes an angle 33 0 with the horizontal. Distance of the cable from the hinge on the beam is 1.5 m. Part A: Draw a Free Body Diagram Part B: FInd the tension in the cable. Part C: Find the horizontal and vertical forces exerted by the

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter4: Newton's Laws Of Motion

Section: Chapter Questions

Problem 91AP: The board sandwiched between two other boards in Figure P4.91 weighs 95.5 N. If the coefficient of...

See similar textbooks

Similar questions

In the figure below, the horizontal boom is uniform and has the same weight as the hanging weight at its end. The boom is supported by the cable with a tension T. The angle between the boom and the cable is 30°. What is the magnitude of horizontal force Fx exerted by the wall on the boom? Fy Fx W
A drawbridge is 7 meters long, and is held in place at an angle of 50° bya horizontal chain as shown in the picture. The drawbridge has a massof 500 kg, and its center of mass is located 5 meters from the hinge. Thechain is attached to the drawbridge 6 meters from the hinge.a. Find the tension in the chain.b. Find the magnitude and direction of the force on the hinge.
A 24 kg rectangular 4.00 m x 3.00 m rectangular sign is suspended from a horizontal 6.00 m long rod with a 5 kg mass as indicated in the figure. The left end of the rod is supported by a hinge, and the right end is supported by a thin cable making a 30.0° angle with the vertical. Draw a free body diagram and calculate the tension T in the cable. The thin cable breaks if it is pulled by more than 200 N. Show than in the present situation the cable can not support the sign without breaking. Show the cable is able to support the load if it is attached higher up such that it makes an angle of 20.0° angle S0.0 CE CREAM SHOP with the vertical.
The figure below shows a bird feeder that weighs 177.7 N. The feeder is supported by a vertical wire, which is in turn tied to two wires, each of which is attached to a horizontal support. The left wire makes a 60° angle with the support, while the right wire makes a 30° angle. What is the tension in each wire (in N)? left wire= ? N right wire= ?N bottom wire= ?N
cable 8. A 20 kg uniform beam 10m long is attached to a wall with a cable. The 40.0° cable is attached to the middle of the beam at 90° to the beam. A box box of mass 50 kg is suspended from the beam as shown. 50 0° a. Draw a free body diagram labelling all the forces acting on the beam (include the forces acting on the floor hinge). Choose and label an appropriate pivot point "P". Label all distances from this point. b. Determine the tension in the cable. с. Determine the force acting on the hinge at the bottom.
A street light hangs from a traffic pole as shown in the figure. The uniform aluminum pole AB is 7.2 m long and has a mass of 12.0 kg. 3.80 m 37 D B The massless cable CD can withstand a maximum tension of 820 N before it breaks. What is the maximum mass of the traffic light that can be attached before the cable breaks?
If you hold your arm outstretched with palm upward, as shown, the force to keep your arm from falling comes from your deltoid muscle. The arm of a typical person has mass 4.0 kg and the distances and angles shown in the figure.a. What force must the deltoid muscle provide to keep the arm in this position?b. By what factor does this force exceed the weight of the arm?
The figure below shows a bird feeder that weighs 101.1 N. The feeder is supported by a vertical wire, which is in turn tied to two wires, each of which is attached to a horizontal support. The left wire makes a 60° angle with the support, while the right wire makes a 30° angle. What is the tension in each wire (in N)? A bird feeder is suspended from a vertical wire. The top of the wire is tied to two other wires. The left and right wires go up and to the left and up and to the right, respectively, from the connection point to a horizontal support. The left wire makes an angle of 60° with the support. The right wire makes an angle of 30° with the support. left wire Nright wire Nbottom wire N
A light cable attaches to a bar hinged to a wall as shown in the figure. The bar is 1.70 m long and has a mass of 6.0 kg. Attached to the end of a bar is a sign with a mass of 15.5 kg. The cable attaches to the bar at a distance of 1.35 m from the wall making an angle of 35 degrees with the bar. a) What is the tension in the cable? b) If the cable breaks, what will be the instantaneous angular acceleration of the bar/sign system about the hinge? Treat the bar as a uniform rod and the sign as a point mass attached at the end of the bar.
A light cable attaches to a bar hinged to a wall as shown in the figure. The bar is 1.70 m long and has a mass of 6.0 kg. Attached to the end of a bar is a sign with a mass of 15.5 kg. The cable attaches to the bar at a distance of 1.35 m from the wall making an angle of 35 degrees with the bar. a) What is the tension in the cable? b) If the cable breaks, what will be the instantaneous angular acceleration of the bar/sign system about the hinge? Treat the bar as a uniform rod and the sign as a point mass attached at the end of the bar. (Can you answer both a and b, thanks)
A uniform plank of length 2.00 m and mass 28.0 kg is supported by three ropes, as indicated by the vectors in the figure below. Find the tension in each rope when a 710-N person is d= 0.500 m from the left end. Solve for magnitude of T1, T2, and T3.
A 200 N sign hangs from the middle of a cable between two buildings. The ends of each cable are attached to each building at the same height. The cable cannot exceed 1500 N without breaking. Find the minimum angle that the cable can make from the horizontal.