A 3-phase transmission line has its conductors at the corners of an equilateral triangle with side 3m. The diameter of each conductor is 1.63 cm. The inductance of the line per phase per km is (a1.232 mH (b) 1.182 mH (c) 1.093 mH (d) 1.043 mH

A 3-phase transmission line has its conductors at the corners of an equilateral triangle with side 3m. The diameter of each conductor is 1.63 cm. The inductance of the line per phase per km is (a1.232 mH (b) 1.182 mH (c) 1.093 mH (d) 1.043 mH

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.6MCQ: Conductor spacings, types, and sizes do have an impact on the series impedance and shunt admittance....

See similar textbooks

Related questions

Q: 29. Determine v, and the required PIV rating of each diode for the configuration of Fig. 173. In…

Q: Skill-Assessment Exercise 2.8 PROBLEM: Find the transfer function, G(s) = X2(s)/F(s), for the…

A: In this question, We need to determine the transfer function X2/F(s) using the s domain.

Q: Solve: Answers should be expressed using 2 decimal places a. k (transfer constant) = MAN2 b. Ip = mA…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: four pole 2-Hp, 220-volts, 60-Hz, 3-Phase motorhas a delta connected stator and a Wye connected…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Using the drain characteristic of Fig. a. What is the value of ra for VGs = -1y? b. What is the…

A: Given data, (a) VGS = -1V rd = slope of ID vs VDS

Q: QI (a) Table Q1(a) shows a list of electrical appliances for a typical 3 bedroom house. As an M&E…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Find the value of RL for maximum power transfer in the network and the maximum power that can be…

Q: The switch in the circuit shown in Figure Q1(c) has been in position a for a long time. At t-0, the…

Q: Solve the output FIND CURRENT FLOWING THROUGH Z1 FIND CURRENT FLOWING THROUGH Z2

A: The given circuit is as shown below with mesh currents and assumed current directions in each…

Q: A four pole 2-Hp, 220-volts, 60-Hz, 3-Phase motorhas a delta connected stator and a Wye connected…

A: Delta connection is used to a distribution network . it is used for a shorter distance and the star…

Q: . Determine the output voltage

Q: Find the Inverse Laplace Transform of the following. Answers must be in a simplified form and…

Q: Find the Laplace Transform of the following. Answers must be in a simplified form and solutions must…

Q: oise ratio (SNR) to pass the information signal with

Q: Solve: Answers should be expressed using 2 decimal places a. k (transfer constant) = mA/v2 b. Ip =…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: 2. Consider the voltage divider circuit for biasing an n-channel E-MOSFET. Given the following…

A: We need to find out current and voltage for given circuit

Q: three-phase induction motor having a synchronous speed of 1000 revolution per minute draws 50 kW…

Q: Hiw 2 fint the RAB in fig. 2 kn A. 9kn 9kn 3kn 사

Q: "he initial values of ij and iz in the circuit shown in Figure Q1(b) are +3A and -5A cspectively.…

Q: Q4) infinite filament of current along z axis carries a current of 10A in az dirention. Find the…

Q: 2.) A sinusoidal voltage source is represented by the vector pointing to 6 + j4 on the complex…

Q: Find the value of RL for maximum power transfer in the network and the maximum power that can be…

A: In this question, We need to determine the resistance RL and maximum power transfer to the load?…

Q: A balanced delta – connected load, with impedance 10Z-36.9° N, and a balanced - connected load are…

A: In this question, We need to determine the impedance of the star connected load? If star and…

Q: Vm o:707 Vm O.5 Vm

A: The solution is given below

Q: 1. A multijunction solar cell will be created using the following three semiconductors. Place each…

A: Multi Junction Solar Cell: Solar cells having several p–n junctions constructed of various…

Q: The frequency of the rotor circuit increase as the rotor speed decreases True O False O

A: We need to tell about whether the given statement is true or false

Q: What is the magnitude of the line-to-line voltage across the two loads? (The two loads have the same…

A: Let Z is the each impedence In delta connection, then after converting into star connection the new…

Q: Compose the mesh equations. 10 Q j10 O j10 Q ... ll ell ä) 10 V [1] sine :-j10 2 [12] sine @mesh 1:…

A: In this question, We need to determine the value of impedance Z parameters ?

Q: Find the time-domain function for the indicated output, either vo(t) or io(t). Your function should…

Q: Find the laplace transcom of the following. 1 A- 3t t.1

Q: elve for the mesh currents in the previous problem.

Q: Find the voltage V j32 42 j8 2 ww ele j22 100/0 V j62 5 2

Q: Calculate the power dissipation for the resistor R2. Where E = 15 V, %3D R1 = 8.2 K2, and R2 = 6.8…

Q: +Vpp Rp C3 Vot R RL Given: • VDD = 26 V • R1 =17 kohms • R2 = 5 kohms • RD = 750 ohms • Rs - 0 kohms…

A: Brief description: For the given MOSFET we need to calculate the value of DC as well as AC…

Q: 1. What is the necessity of the transformer in the recitifer circuit? 2. What are the applications…

A: As per bartleby guideline for more than one question asked only first is to be please upload the…

Q: 1.2.3 3. Use nodal analysis. please do complete kvl kcl solution solving thankyou

Q: Assume you have an LTI system. When the input x(t) = 2e"u(t-1) is send into the system, the output…

A: According to the question, we need to determine the impulse and step response of the system. Also,…

Q: Q. Use Table below to explain why the circuit of Figure below will not work as it is. How can the…

A: Integrated circuit are known as microelectronic circuit . This integrated circuit are used in…

Q: The switch in the circuit shown in Figure Q1(c) has been in position a for a long time. At t-0, the…

A: In this question we need to find a voltage VC(t) , Vo(t) and io(t)

Q: The switch in the circuit shown in Figure Q1(c) has been in position a for a long time. At t-0, the…

Q: The required rated voltage applied to a six leads out motor are a. 760-volts and 440-volts c.…

A: Given: 6 wire motor rated voltage

Q: Consider the circuit in Fig. 1. Determine the coupling coeffiCr'ent. Calculate the energy stored in…

Q: 25. For the network of Fig. 170, sketch v, and determine Vde- 2 k V, = 120 V (rms) Ideal V, (Vac)…

Q: Feedback and Control Systems Using mesh and nodal analysis, find the transfer function G(s) = Vo(s)…

Q: Q1) Define briefly: 1. Optoelectronics. 2. Electroluminescence. 3. Internal quantum efficiency. 4.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 39 ' Si 10 V 10Ω Si Figure 4 Determine the current I using the approximate/practical equivalent…

Q: A positive-sequence, balanced A-connected source supplies a balanced A-connected load. If the…

Q: IN KL1 L2 1 OUT V1 L1 L2 R2 1µ 9µ 1 SINE(0 1 1Meg) Rser=.1 .tran 3u

A: Given the circuit, as shown below: We need to explain what will happen with the voltage on the left…

Q: An excessive voltage drop in a circuit may cause undesired drawbacks. Within your own home, state…

A: (a) Voltage drop: Voltage is the estimation of the electrical force between two focuses that drives…

Q: EXAMPLE 1 Determine the magnitude of gm for a JFET with Ipss = 8 mA and Vp = -4 Vat the following de…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

2.5 A 3-phase single circuit bundled conductor line with two sub-conductors per phase has horizontal spacing with 6.1 m between the centre lines of adjacent phases. The distance between the sub- conductors of each phase is 30.5 cm and each sub-conductor has a diameter of 2.54 cm. Find the inductance per phase per km. [0.988 mH]
Conductor spacings, types, and sizes do have an impact on the series impedance and shunt admittance. True False
The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
The affect of the earth plane is to slightly increase the capacitance, and as the line height increases, the effect of earth becomes negligible. True False
Calculate the inductance per phase per meter for a three- phase double-circuit line whose phase conductors have a radius of 4.1 cm with the horizontal conductor arrangement as shown in Figure below A B A' C' B' 6m -6m 7 m 6m- 6m
A 3-phase transmission line has its conductors at the corners of an equilateral triangle with side 3 m. The diameter of each conductor is 1.63 cm. The inductance of the line per phase per km is (a) 1.232 mH (c) 1.093 mH (b) 1.182 mH (d) 1.043 mH
One circuit of a single-phase transmission line is composed of three solid 0.12" radius wires. The return circuit is composed of two 0.15" radius wires. Find the inductance of the complete line in mH/mi. The distance between wires are 40" horizontally and 25" vertically. A. 2.54 mH/mi B. 2.478 mH/mi C. 2.488 mH/mi D. 2.567 mH/mi Provide Clear Explaination
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
Determine the inductance per km per phase of a single circuit 460 KV line using two bundle conductors per phase as shown in the figure. The diameter of each conductor is 5 cm. 40cm 6.5m 6.5m 13m
A three-phase 50 Hz double circuit as shown below, assumed that the line is completely trasposed. The diameter of each conductor is 2.76 cm. Find the capacitance to neutral in uF/km b O O O O - -- 6m 6m 6m bm bm
Paragraph Styles The power factor must be close to in the transmission lines will be reduced To insure that losses D(Ctrl) -
A three-phase 50 Hz double circuit as shown below, assumed that the line is completely trasposed. The diameter of each conductor is 2.76 cm. Find the capacitance to neutral in juF /km a b a b' --- 6m 6m 6m 6m 6m