9. A umiform 400 N boom is supported as slown in the figure bebow. Find the tension in the tie rope and theforce exerted on the boon by the pin at P.L/43L/42000 N50d.

Answered: 9. A uniform 400 N boom is supported as…

9. A uniform 400 N boom is supported as shown in the figure below. Fixl the tension in the tie rope and the förce exerted on the boon by the pin at P. L4 3L4. 2000 N 50 .......

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 24P: When tightening a bolt, you push perpendicularly on a wrench with a force of 165N at a distance of...

See similar textbooks

Related questions

Q: Batman and Robin are lifting a 196 N uniform board with a length of 2.50 m. Batman exerts 55.0 N at…

Q: A meterstick is balanced on a fulcrum at its center. Then a 310 N weight is placed 20 cm to the…

A: Given data: Weight (W1) = 310 N Placed at (r1 ) = 20 cm, to the left of centre Weight (W2) = 150 N…

Q: Three forces F, = 20 N, F2 = 10 N and F, = 5.0 N act on the structure shown in figure below. A…

Q: 12) In the figure, a 10.0-m long bar is attached by a frictionless hinge to a wall and held…

A: Length of the bar is L = 10 m Angle of the rope with the bar is 53 degrees Weight of the bar is W =…

Q: 5. If the maximum tension that the string can withstand is 4200N, what is the maximum mass that can…

Q: A 7.64-m uniform beam is hinged to a vertical wall and held horizontally by a 5.00-m cable attached…

Q: A uniform steel girder AB is 6.0 mlong and has a mass equivalent to 4.0 kNacting at its centre. The…

A: When a set of forces are applied to a body of length l, the forces tend to bend the body or rotate…

Q: One end of a unform 340-m-long rod of weight F is supported by a cable at an angle ofe37 with the…

A: Given weight of the rod Fg=mg Length of the rod, L=3.40m Point A is held due to frictional force Fr…

Q: A young work crew is trying to quickly nhish some touch-up painting to comp area, they decide to try…

A: Given:- The mass of the can m = 3.56 kg The length of the plank L = 8.49 m Weight of the plank W=…

Q: 12.Based on the figure, assume the somewhat artificial condition that the strut is weightless and…

A: Given, Weight, W = 10 N Tension, T Normal force, N Angle made by T with the horizontal is, 37° the…

Q: 4. A uniform 312 kg boom is 10.0 m long is held up by cable attached 6.00 m from the wall at an…

Q: A uniform 312 kg boom is 10.0 m long is held up by cable attached 6.00 m from the wall at an angle…

A: Given: The mass of the boom is m=312 kg, The distance of cable from wall is PQ=6 m, The length of…

Q: Answer must be according the correct signifcant numbers.

A: Given that: Length of the strut is 5 m.

Q: A 350 N uniform boom is supported by a perpendicular cable attached at 0.7 its length from the…

A: Weight of rod = 350 Nength of rod =0.7 θ =60° Mass of boom=1050N

Q: we analyzed a cable used to support an actor as he swings onto the stage. Now suppose the tension in…

Q: QIThe steel axle of a large winch on an ocean liner is subjected to a torque of 1.7 kN-m (see fig…

A: The torque on the steel axle is, τ'=1.70 kN.m The allowable sheat stress, G'=50 MPa The…

Q: The uniform boom shown below weighs 3000 N. It is supported by the horizontal guy wire and by the…

Q: A light plank rests on two scales that read Fe=440 N and F,= 320 N. The scales are separated by a…

Q: Scientists have studied how snakes grip and climb ropes. In one study, they found that an important…

A: Let us look at the upper node. The tension everywhere in the rope supporting mass M be T3=mg. This…

Q: 2. A 2.5 m long steel rod has a cross-sectional area of 0.35 cm. The rod is hung from one end of a…

Q: A store's sign has a mass of 20kg and is 3.0m long. It is uniform, so it's center of gravity is at…

A: → moment about point 'B' will be zero .T sin 25°x 3=mg x 1.5T=20x10x1.53xsin 25°=236.6 N

Q: Draw the shear and moment diagrams for the simply-supported beam. 2wo Wo B A L/2- -L/2

A: In this question we have to draw the shear and moment diagrams for the simply-supported beam.

Q: The simple truss is loaded by a system of forces as shown in the figure. The truss is supported by a…

A: Given: P=800 lb. Note: Use the section method to analyze the problem.

Q: Please type it in 5 sentences. In your own words, what is the purpose of finding out the maximum…

Q: 3. A uniform plank ABC of weight 30 N and 2 m long is supported at one end A and at a point B 1.4 m…

A: Given that the weight of the plank is F = 30 N 30(1.4-1) = W(0.6)(30)(0.4) = 0.6WW = 120.6W = 20 N

Q: A Chandelier of mass 60 kg is hanging as shown below. Calculate the tensile force acting in…

A: Given: mass of the chandelier (m) = 60 kg Tension in the string BD = T1 Tension in the string CD =…

Q: A hungry bear weighing 730 N walks out on a beam in an attempt to retrieve a basket of goodies…

Q: What hanging mass will stretch a 2.0-m-long, 0.50-mmdiameter steel wire by 1.0 mm?

A: Given: The length of steel wire is l=2 m. The diameter of steel wire is d=0.50 mm. The stretched…

Q: The 3m long uniform plank is supported by a fulcrum at the midpoint. Where a 45kg student should…

A: Mass of person1 : m1 = 30 kg Mass of person2 : m2 = 40 kg Mass of person3 : m3 = 45 kg Position of…

Q: 3) A 560 Ibs uniform pipe is being functioned as a lever as shown in the figure below. A fulcrum…

Q: A 12m long post is bolted to the wall on its left end. It's right end is held horizontal by a wire…

A: Draw the schematic diagram of the arrangement.

Q: o is when a force causes compression and the object shrinks * O Inertia compressive stress, O…

A: Answer:- tensile stress Sigma is when a force causes compression and the object shrinks - tensile…

Q: To penetrate armor, a projectile’s point concentrates force in a small area, creating a stress large…

Q: A uniform plank of length L=2.7m and weight W =735N is supported by three ropes as indicated in the…

Q: An 80 kg construction worker sits down 2.0 m from the end of a 1450 kg steel beam to eat his lunch,…

Q: The boom in the figure below (Figure 1) weighs 2600 N and is attached to a frictionless pivot at its…

Q: y T T F = 100N An object is subjected to three forces as shown in the figure. Assume 0 = 25.2 °,…

Q: B 15. 25 KN 30

Q: A rigid lean-to shelter of weight 87.5 N is supported by a horizontal rope, as shown in the figure…

Q: Steel nails are rigid and unbending. Steel wool is soft and squishy. How would you account for this…

A: In case of steel nail, the composition of the material is rigid and uniform, because the density of…

Q: |Three forces F, = 20 N, F, = 10 N and F, = 5.0 N act on the structure shown in figure below. A…

A: Option c) is correct.

Q: A uniform 400 N boom is supported as shown in the figure. Find he tension in the tie rope and the…

Q: A B 1000 Ibs

A: For rotational equilibrium ,net torque acting on a system must be zero .

Q: Revew Constas gre shown a lightweight plank supported at s ght end by a0mn diater rope with a…

A: Given: Diameter of the rope, d = 7 mm = 7×10-3 m Tensile strength of the rope, σ = 6.0×107 N/m2 Mass…

Q: The two wedges are stacked as shown, and a load is applied. What is dhe mininum force P required to…

Q: A ladder leans against a smooth wall as shown in the figure below. (By a "smooth," we mean that the…

A: Your solution is option (c) 67N

Q: A uniform steel bar of length 10 m is supported at point A and B using two cables as shown in the…

Concept explainers

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).

Question

9. A umiform 400 N boom is supported as slown in the figure bebow. Find the tension in the tie rope and the
force exerted on the boon by the pin at P.
L/4
3L/4
2000 N
50
d.

Expert Solution

Step 1

Given :

Boom weight $W = 400 N$

Trending now

This is a popular solution!

Step by step

Solved in 6 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

When tightening a bolt, you push perpendicularly on a wrench with a force of 165N at a distance of 0.140m from the center of the bolt. How much torque are you exerting relative to the center of the bolt?
Find the magnitude of the tension in each supporting cable shown below. In each case, the weight of the suspended body is 100.0 N and the masses of the cables are negligible.
. A tightly stretched horizontal “high wire” is 36 m long. Itsags vertically 2.1 m when a 60.0-kg tightrope walker standsat its center. What is the tension in the wire? Is it possibleto increase the tension in the wire so that there is no sag?
A 80-kg block is suspended as shown. The beam is weightless and is hinged to the wall at A. The tension force of the cable T has magnitude: (Use g = 9.8 m/s2) %3D T. 3m A 4m block O a 980 N Ob. 817 N Oc. 1143 N Od. 620N O e. 1307 N
A cable weighing 4 kg/m is supported at the ends by two towers of the same height 100m apart. a. Flnd the sag at the center if the cable is 128.16m long. b. Find the tension at the lowest point of the cable. c. Find the tension at the highest point of the cable. A) a. 45.54m ; b. 610kg; c. 203kg B a. 35.54m ; b. 302.16kg ; c. 160kg c) a. 45.54m ; b. 160kg ; c. 203kg a. 44.45m ; b. 610kg ; c. 602.36kg E a. 53.54m ; b. 302.16kg ; c. 160kg
2. A 3.0-m-long ladder leans against a wall at an angle of 60° with respect to the floor. What is the minimum value of us, the coefficient of static friction with the ground, that will prevent the ladder from slipping? Assume that friction between the ladder and the wall is negligible. Center of gravity 19 TULO L 60⁰ Weight acts at the center of gravity. Known L-30 m Find Me Contro <= 0 about this point. Static friction prevents slipping.
42. A 12.0-m boom, AB, of a crane lifting a 3000-kg load is shown below. The center of mass of the boom is at its geometric center, and the mass of the boom is 1000 kg. For the position shown, calculate tension Tin the cable and the force at the axle A. B T 10° 3000 kg 30°
B. Derive the shear force equation,bending moment equation for the beam shown. Neglect the weight of the beam. 2.1 kN/m C B 5 m- Determine the following: 26. Reaction support at point A. -2m-
A 12.0 m boom (along points A to B) of a crane lifting a 3000 kg load, as shown below. The center of mass of the boom is at its geometric center, and the mass of the boom is 1000 kg. a) What is the tension T in the cable? Give your answer in kN = 10-³ N. 171 171 A 188 T b) What is the magnitude of the force at axle A? Give your answer in kN = 10-³ N. 10° 30° B TON Image courtesy of Clker-Free-Vector-Images for the crane. 3000 kg
A. determine the downward pulll WL from the left end that is necessary to hold the bar in equilibrium? B. Determine the magnitude of the force exerted by the rope?
A uniform horizontal beam with a length of 8 m and a weight of 200 N is attached to a wall by a pin connection. Its far end is supported by a cable that makes an angle of 53° with the beam. If a 600-N person stands 2 m from the wall. What is the tension in the cable? 53.0% 8.00 m O A. 502 N O B. 410 N O C. 196 N D. None O E. 313 N
3. A 50N body is supported by two ropes, one making 30* with the vertical and the other making 45* with the horizontal. What is the tension in the ropes?