Answered: 7.77 For the circuit shown in Figure…

7.77 For the circuit shown in Figure P7.77, find the currents IĄ, Ig, Iç and In, and the real power dissipated by the load. 22020° V 4 20 2 40 2 j10 2 Ig 1102120° V 20 2 1102-120° V- I, wll

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Related questions

Q: dc steady-state, which, if any, of the following quantities are 0? Select all that apply; pls no…

A: In this we will find which quantities are zero in dc steady state..

Q: The circuit is at steady state when the switch closes at time t = 0. Determine v1(0−), v1(0+),…

Q: 7.19 If the circuits shown in Figure P7.19 are to be at unity power factor, find Cp and Cs. Cs Rz RL…

A: First, consider the parallel circuit, The admittance of the series combination of R and L is given…

Q: A load is supplied the complex power S = 60 + j80 VA by a voltage source of 50 cos 377t V. Find the…

Q: 2. Reduce the following open loop system into single block and find transient and steady state…

A: a) From the given figure, G1s=s9s+17G2s=9s+32s2+9s+27 Solving given control system,…

Q: Consider the circuit in the figure. Calculate the voltage v( t) across the capacitor in steady state…

A: To solve the given question, the behavior of the inductor and capacitor in DC circuit should be…

Q: 7.57 The wire that connects an antenna on your roof to the TV set in your den is a 300-2 wire, as…

A: Here, consider the cable impedance as the source impedance and the impedance of the antenna…

Q: 5. For the system shown in figure. State the given system type also find steady state position error…

A: A system is carrying a feedback when the output from it's own circuit is passed to the input of the…

Q: 6 Find the real and reactive power supplied by the source in the circuit shown in Figure P7.26.…

A: Given circuit is – Total impedance is –

Q: R Vs( the C

Q: 7.34 Suppose that the electricity in your home has g out on a hot, humid summer day and the power…

A: The air conditioner consumed power is found below; Average power,PA=V×I×p.fV=120 V,I=9.6…

Q: (a) Maximum values of v(t) and i(t); (b) The Root-Mean-Square (rms) values of v(t) and i(t); (c) The…

Q: Two sinusoidal voltages of the same frequency have rms values of 8 V and 3 V. What is the smallest…

A: As the phase angles are unknown, the maximum RMS value can be,

Q: The sinusoidal voltage source in the circuitis operating at a frequency of 200 krad/s.…

A: Given: A mutually coupled circuit in which

Q: Reduce the following open loop system into single block and find transient and steady state…

A: When two blocks with different gains are in cascade (one after the other), the resultant gain of the…

Q: The circuit shown is operating in the sinusoidal steadystate. Find the value of ω ifio=100…

A: The current signal in cosine wave is: So, the current and voltage in polar form are respectively:…

Q: Find the steady-state is (a) w = 400rad/s, 100 cos (wt) mA 375 mH 12 cos (400 t) V 100 S2 ww vo(t) +…

Q: 1. What is the phase sequence of each of the following sets of voltages? Va=20 cos (wt+40)v Vb=20…

A: As per our guidelines we are supposed to answer only one question. Kindly repost other questions as…

Q: 3. Comment on the influence of changing (K) upon steady state error.

Q: 9 Determine the time-averaged total power, the real power dissipated, and the reactive power stored…

A: Consider the impedance Z1. The current through this impedance is,

Q: Given the waveform of a voltage source shown inFigure P7.8, find:a. The steady DC voltage that would…

A: Part (a) The period of the given wave is 2 s. The heating effect of the wave is decided by the RMS…

Q: a) Briefly explain the terms below and state their unit. i. Period ii. Frequency b) Given that v(t)…

Q: Assume the 8-Ω resistor is the load in the circuitshown in Figure P7.48. Assume vg = 110 V rms and…

A: (a) Let I1 be the current in loop 1, and I2 be the current flowing in loop 2, let V1 be the voltage…

Q: Q2) Assuming a sinusoidal source and a uniform load current, analyze the circuit because and draw…

A: We will get VinN/N2 = A sin(ω.t) (2) Iout = VoutR

Q: a) Find the steady-state current if Vin homogeneous solution to the ODE. 100 sin(2t) Volts. You do…

A: In the circuit, resistance inductance and capacitance are consist. Find the current in the circuit?…

Q: 5 For the circuit of Figure P7.13, determine whether the load is capacitive or Inductive for the…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: Find the steady-state expression for io(t) in thecircuit if vs=100 sin 50t mV.

A: Given data: vst=100cos50t-90° mVVs=100∠-90°ω=50 rad/s The expression for the inductor reactance is…

Q: For the circuit shown in Figure P7.43, assume thatvg = 120 V rms. Finda. The total resistance seen…

A: The given circuit is: Where, Vg = 120 V (RMS)

Q: Solve for the steady-state values of the labeled currents at 2 A Va t=0 2 (a) t = 0 iz

Q: 2. A sinusoidal e.m.f. 110 sin 400t volts is connected in series in a circuit with an inductance of…

Q: From Figure Q2(c), calculate the time domain steady state expression for v, i,, and iz when i, = 10…

Q: If we knew that the transformer shown in FigureP7.49 were to deliver 50 A at 110 V rms with a…

A: Write the given values on the secondary side of the transformer. Find the output power of the load.

Q: What is the mathematical expression of the voltage Vg(t) in the steady (continuous) state?

Q: Find the apparent power and the real powerdelivered to the load in the Y-Δ circuit shown in…

A: In the figure shown above in the circuit is the balanced 3-phase circuit. The voltage source…

Q: A current source, IS =11.9cos(2800t) A, a resistor R=289Ω, and an inductor, L=0.44 H are all in…

A: The circuit of the parallel-connected resistor and inductor with current source is shown below, IS…

Q: 2. Reduce the following open loop system into single block and find transient and steady state…

A: For A. Let, G1s=s9s+17G2s=9s+32s2+9s+27 Lets reduce the system into one block…

Q: Answer the following points in detail and rigorously. Instead of resorting to formulas, develop from…

Q: 5 For the circuit of Figure P7.23, determine whether the load is capacitive or inductive for the…

A: The circuit diagram is shown below: In the capacitor, the current leads the voltage, hence it will…

Q: 7.18 A single-phase motor draws 220 W at a power factor of 80 percent (lagging) when connected…

A: The circuit diagram of the motor is shown below: First, we will calculate the equivalent impedance…

Q: as i (t ) = 125cos (5000π t −135) mA Determine the period, T, and the time, t1, at which the first

Q: Q.23: For the circuit shown, find the steady-state current "i" and the total power supplied to the…

Q: 6 The circuit in Figure P7.56 shows the use of ideal transformers for impedance matching. You have a…

A: Given values are = Available turns ratio are =

Q: Given the waveform of a voltage source shown in figure P7.8 find: a. The steady DC voltage that…

A: RMS value is defined wrt heating effect of the waveform, So calculate vrms of the waveform:…

Q: Refer to attached image

A: If we give supply to an uncharged capacitor then at time (t=0) it behaves like short circuit and at…

Q: 7.73 To correct the power factor problems of the motor in Problem 7.72, the company has decided to…

A: The circuit diagram is, From the circuit,

Q: 3 The load Z, in the circuit of Figure P7.28 consists of a 25-2 resistor in series with a 0.1-mF…

A: As per our guidelines we can only answer a maximum of three sub-parts at a time. Please resubmit the…

Q: The netwerk Shown is Operating in Steady State with SinuSoidal Voltoge Sources. If v, = 2cos2t and…

Q: and 2. Reduce the following open loop system into single block and find transient a steady state…

A: A. A open-loop control system: Both the blocks are in cascade, so the overall system will be…

Question

7.77 For the circuit shown in Figure P7.77, find the
currents IĄ, Ig, Iç and In, and the real power dissipated
by the load.
22020° V 4
20 2
40 2
j10 2
Ig
1102120° V
20 2
1102-120° V-
I,
wll

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 8 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Figure 2 shows three "LC" circuits, two of them with capacitance capacitors "C" and the three with inductance coils "L", the three circuits are coupled by means of two capacitance capacitors "Cc". The currents that circulate through each mesh are those indicated in the figure: "I1", "I2" and "I3". Using Kirchhoff's law for voltages and taking into account the definition of current I = −dQ / dt, find the system of coupled equations of the system and then find the normal angular frequencies of the system.
The waveforms below represent one full cycle of the applied voltage vs and the supply current is. based on the waveforms below, which of the following statements is true. options: is leads vs is lags vs is is in phase with vs
aloulated m O1 the value you Up = A cos wt +1o Calaulate maarli)-min(i) =? Use constant voltage drop mad. Don7 to write units. . - 3.7V forget
B.. What is the load current for the circuit shown in the figure? Please choose one: a. 6.0 mA b. 3.0 mA C. 9.0 mA D. 7.5 mA
7.19 If the circuits shown in Figure P7.19 are to be at unity power factor, find Cp and Cs. Cs Rz RL Vs or Load Source ! Load Source R = 52, X, = 50, vs(t) = 100 sin(377f) V нЕ
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the source voltage and the current through the circuit? a. Insufficient information is given. b. The source voltage will lag the current. c. The source voltage will lead the current. d. The source voltage will be in-phase with the current.
For the network shown in figure (3), if the switch is closed for 2usec and then opened for Susec, find mathematical expressions for vi and in of both periods of time and then plot the waveforms of vL and i as a function of time.
Given the waveform of a voltage source shown in figure P7.8 find: a. The steady DC voltage that would cause the same heating effect across a resistance. b. The average current supplied to a 10-ohm resistor connected across the voltage source. c. The average power supplied to a 1-ohm resistor connected across the voltage source.
Which of the following is true about all series ac circuits?(a) The voltage across any circuit element is a maximumwhen the current is a maximum in that circuit element.(b) The current at any point in the circuit is always thesame as the current at any other point in the circuit.(c) The current in the circuit is a maximum when thesource ac voltage is a maximum.(d) Resistors, capacitors, and inductors can all change thephase of the current.
7.18 A single-phase motor draws 220 W at a power factor of 80 percent (lagging) when connected across a 200-V, 60-Hz source. A capacitor is connected in parallel with the load to give a unity power factor, as shown in Figure P7.18. Find the required capacitance. ell ww
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.