51 Go In the rectangle of Fig. 24- 55, the sides have lengths 5.0 cm and 15 cm, q₁ = : +2.0 -5.0 μC, and 92 μC. With V = 0 at infinity, what is the electric potential at (a) corner A and (b) corner B? (c) How much work is required to move a charge q3 = +3.0 μC from B to A along a diagonal of the rectangle? (d) Does this work in- crease or decrease the electric po- tential energy of the three-charge

51 Go In the rectangle of Fig. 24- 55, the sides have lengths 5.0 cm and 15 cm, q₁ = : +2.0 -5.0 μC, and 92 μC. With V = 0 at infinity, what is the electric potential at (a) corner A and (b) corner B? (c) How much work is required to move a charge q3 = +3.0 μC from B to A along a diagonal of the rectangle? (d) Does this work in- crease or decrease the electric po- tential energy of the three-charge

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter7: Electric Potential

Section: Chapter Questions

Problem 12CQ: Can a particle move in a direction of increasing electric potential, yet have its electric potential...

See similar textbooks

Similar questions

(a) Use the exact result from Example 24.4 to find the electric potential created by the dipole described in the example at the point (3a, 0). (b) Explain how this answer compares with the result of the approximate expression that is valid when x is much greater than a.
A parallel-plate capacitor with capacitance C0 stores charge of magnitude Q0 on plates of area A0 separated by distance d0. The potential difference across the plates is V0. If the capacitor is attached to a battery and the charge is doubled to 2Q0, what are the ratios (a) Cnew/C0 and (b) Vnew/V0? A second capacitor is identical to the first capacitor except the plate area is doubled to 2A0. If given a charge of Q0, what are the ratios (c) Cnew/C0 and (d) Vnew/V0? A third capacitor is identical to the first capacitor, except the distance between the plates is doubled to 2d0. If the third capacitor is then given a charge of Q0, what are the ratios (e) Cnew/C0 and (f) Vnew/V0?
You charge a parallel-plate capacitor, remove it from the battery, and prevent the wires connected to the plates from touching each other. When you increase the plate separation, do the following quantities (a) increase, (b) decrease, or (c) stay the same? (i) C (ii) Q (iii) E between the plates (iv) V
Figure CQ16.3 shows equipotential contours in the region of space surrounding two charged conductors. Find (a) the work WAB in electron volts done by the electric force on a proton that moves from point A to point B. Similarly, find (b) WAC, (c) WAD, and (d) WAE. Figure CQ16.3
A parallel-plate capacitor has capacitance 3.00 F. (a) How much energy is stored in the capacitor if it is connected to a 6.00-V battery? (b) If the battery is disconnected and the distance between the charged plates doubled, what is the energy stored? (c) The battery is subsequently reattached to the capacitor, but the plate separation remains as in part (b). How much energy is stored? (Answer each part in microjoules.)
(a) Plot the potential of a uniformly charged 1-m rod with 1 C/m charge as a function of the perpendicular distance from the center. Draw your graph from s = 0,1 in to s = 1.0m. (b) On the same graph, plot the potential of a point charge with a 1-C charge at the origin, (c) Which potential is stronger near the rod? (d) What happens to the difference as the distance increases? Interpret your result.
The naturally occurring charge on the ground on a fine day out in the open country is -1.00nC/m2. (a) What is the electric field relative to ground at a height of 3.00 m? (b) Calculate the electric potential at this height. (C) Sketch electric field and equipotential lines for this scenario.
At a certain distance from a charged particle, the magnitude of the electric field is 500 V/m and the electric potential is 3.00 kV. (a) What is the distance to the particle? (b) What is the magnitude of the charge?
(a) What is the potential between two points situated 10 cm and 20 cm from a 3.0 C point charge? (b) To what location should the point at 20 cm be moved to increase this potential difference by a factor of two?
Unreasonable Results (a) A certain parallel plate capacitor has plates of area 4.00 m2 separated by 0.0100 mm of nylon, and stores 0.170 C of charge. What is the applied voltage? (b) What is unreasonable about this result? (c) Which assumptions are responsible or inconsistent?
(a) How much charge can be placed on a capacitor with air between the plates before it breaks down if the area of each plate is 5.00 cm2? (b) Find the maximum charge if polystyrene is used between the plates instead of air. Assume the dielectric strength of air is 3.00 106 V/m and that of polystyrene is 24.0 106 V/m.
A long thin wire is used in laser printers to charge the photoreceptor before exposure to light. This is done by applying a large potential difference between the wire and the photoreceptor. a. Use Equation 26.23, V(r)=20lnRr to determine a relationship between the electric potential V and the magnitude of the electric field E at a distance r from the center of the wire of radius R (r R). b. Determine the electric potential at a distance of 2.0 mm from the surface of a wire of radius R = 0.80 mm that will produce an electric field of 1.8 106 V/m at that point.