solve in peaper 1For the control system shown in figure 1, Assign the appropriate statevariables, then:a) Write the system dynamic equation,b) Find the state transition matrix (t),c) Assuming unit step input and zero initial values, find an expression for thestate transition equation x(t).B[3R(S)Y(S)3Figure 1: Simulink Block Diagram

Answered: Image /qna-images/answer/4a75bb59-bd09-4e53-bc50-6e7694c4c185.jpg

Answered: 1 For the control system shown in…

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.22P

See similar textbooks

Similar questions

What are static error coefficients? how will you calculate the steady state error using static error coefficients? (Write equations also, about kp, Kv, Ka) subject: control system
What is the input to the system with specification given, Kp = 10, 500? A. Step function B. Ramp Function C. Parabolic Function
What will be the controller output for a Proportional Derivative controller (i) Initially and (ii) after T= 2 seconds (iii) after T= 3 seconds after the error begins to change from zero at the rate of 2%/s. The controller has Kp=2.5,KD=1.4 seconds. 9. S. 7- 3. 1 Time % of Error 61
An asynchronous circuit has two SR latches (not edge-triggered FF) denoted SR1 and SR2, and two external inputs x1 and x2. It also has a single output z. The excitation expressions for the inputs and output equations are (see image). Using the characteristic equation for an SR latch, draw the excitation table. Then draw the state table, flow table, and flow diagram.
This is under dynamic system and control ,please solve this
odinary differential equation
A closed-loop control system is created using a proportional controller. Show that such a system has a steady state error of 1/(1+Kp) and therefore the steady state error condition can be achieved with a proportional gain of 9 or more.
Analyze and draw the block diagram representation of the Direct Forms I and II for thefollowing IIR system function:
Can someone explain to me this solution, HOW and WHY? every stepsComplex Numbers - Simplification of Complex Expression
zero order hold
Derivative controller is acting on O a. Both of Transient and steady state O b. Transient and it's frequency independant OC. Steady state O d. Transient and it's frequency dependant
Write a Note on use of ODE in solving series RL circuit. Using Kirchhoff's voltage law find ordinary differential equation (ODE) representing system of series RL circuit. Solve that ODE and find out function for current i. Do detailed Curve Sketching analysis (Domain, Intercepts, Symmetry, Asymptotes, Intervals of Increase or Decrease, Local maximum and minimum, Concavity and points of Inflection, Sketch the function/ Plot the graph) of it (function for current 'i'). a. Following is the description of an RL circuit: constant voltage V = 5 V, R = 50 Q, L = 1 H, initial current i = 0 Amp. Calculate i' at any time t in RL circuit. Show equation for transient current. Calculate steady state current.

SEE MORE QUESTIONS

Recommended textbooks for you

Power System Analysis and Design (MindTap Course …

Electrical Engineering

ISBN:

9781305632134

Author:

J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:

Cengage Learning