unity.combi-1djustbeakough200TheI annum,11.85 A regular household system of a single-phase three-wire circuit allows the operation of both 120-V and240-V, 60-Hz appliances. The household circuit ismodeled as shown in Fig. 11.96. Calculate:tariff if the revenue to the utility company is toremain the same as for the two-part tariff.(a) the currents I₁, I₂, and I,,(b) the total complex power supplied(c) the overall power factor of the circuit120 /0° V120/0° VFigure 11.96For Prob. 11.85.10 2210 Q215 mHLamp30 ΩRefrigeratorKitchen rampToolsCustomFill & Sign31°C Mostly sunny ^x 4) ENG2:4731/5/2

In this questionsWe need to determine the unknown currents as shown the circuit and also determine…

01- t K h e num, 11.85 A regular household system of a single-phase three- wire circuit allows the operation of both 120-V and 240-V, 60-Hz appliances. The household circuit is modeled as shown in Fig. 11.96. Calculate: (a) the currents I₁, I₂, and I, (b) the total complex power supplied (c) the overall power factor of the circuit 120 /0° V 120 /0° V -1 1₂ Figure 11.96 For Prob. 11.85. 10 Q2 10 Q2 15 mH www Lamp 30 92 Refrigerator Kitchen ramp

01- t K h e num, 11.85 A regular household system of a single-phase three- wire circuit allows the operation of both 120-V and 240-V, 60-Hz appliances. The household circuit is modeled as shown in Fig. 11.96. Calculate: (a) the currents I₁, I₂, and I, (b) the total complex power supplied (c) the overall power factor of the circuit 120 /0° V 120 /0° V -1 1₂ Figure 11.96 For Prob. 11.85. 10 Q2 10 Q2 15 mH www Lamp 30 92 Refrigerator Kitchen ramp

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 3-phase star-connected alternator is excited to give 6600 V between lines on open circuit. It has a resistance of 0.5 Q and synchronous reactance of 5 2 per phase. Calculate the terminal voltage and regulation at full load current of 130 A when the P.F. is (i) 0.8 lagging, (ii) 0.6 [Rajive Gandhi Technical University, Bhopal, 2000] [(1) 3318 Volts/Ph, + 14.83% (ii) 4265 Volts/Ph, - 10.65%] leading.
Q2) A three phase load (motor) draws 30 kW when connected to 440 V rms, 50 Hz line if the power factor is 0.85 lagging, Determine: a) The line current drawn by the motor. b) The KVAR rating of the three capacitors - connected in parallel with the motor that will raise the power factor to 0.95 lagging, and c) The capacitance of each capacitor.
6. An 8 pole, 30 diesel generator has a line voltage of 450V at 62.5 Hz when its circuit breaker is open. At full load it supplies a line current of 410 Amps at a power factor of 0.83 lagging, its line voltage droops to 440V and the frequency droops to 60.0 Hz. The generator's full load efficiency is 85%. The efficiency of the diesel engine is 36%. a) What is the generator's % voltage regulation? b) What is the diesel engine's no load speed RPM, its full load speed RPM and its % speed regulation? c) What is the alternator's output apparent kVA, active kW, and reactive kvar power at full load? d) What is the full load output power in horsepower and shaft torque in kNm of the diesel engine? e) What are the power losses in the generator and diesel in kW? f) The diesel burns heavy fuel oil with a calorific value of 40.7 MJ/kg. Estimate the engine's fuel consumption in kg/hour at full load.
A factory is supplied by a single-phase network of 220 V - 50 Hz. It contains in parallel: - 2 motors, each of active power 3000 W and of reactive power 2775 VAR. 14 incandescent lamps each of 100W. - 2 air conditioners, each of useful power 2400W, efficiency 0.8 and of power factor 0.8. One compressor of absorbed power 2440W and of power factor 0.8. • At full load, calculate: 1) The total active power absorbed by the factory. 2) The total reactive power. 3) The total apparent power. 4) The power factor of the factory. 5) The current absorbed by the factory.
Q1.An industrial load can be supplied on the following alternative tariffs. (a) H.V. supply at Rs. 70 per kVA per annum plus 5 p per kWh (b) L.V. supply at Rs 75 per kVA per annum plus 6 p per kWh (c) Transformers and switchgear suitable for the HV supply cost Rs 60 per kVA, the full load transformation losses being 3%. The fixed charges are 20% per annum on the capital cost of the H.V. plant and the installation works at full load. If there are 50 working weeks in a year find the number of working hours per week above which the H.V. supply is cheaper. Assume a load of 2000 kW at unity power factor.
4. A generating station supplies the following loads : 15000 kW, 12000 kW, 8500 kW, 6000 kW and 450 kW. The station has a maximum demand of 22000 kW. The annual load factor of the station is 48%%. Calculate () the number of units supplied annually () the diversity factor and (il) the demand factor. T 925 x 10 kWh (i) 52-4% (iin 1-9| 5. Agenerating station has a maximum demand of 20 MW, a load factor of 60%, a plant capacity factor of 48% and a plant use factor of 80 Find: A the daily energy produced )tche reserve capacaty ofthe plant
1. Consider a building with a real power demand of 650 kW and reactive power demand of 480 KVAR. Determine the current power factor and then find the required size of a set of capacitors to be installed in parallel with the building service entrance so that the power factor becomes at least 0.90.
A three phase energy meter having a meter constant of 0.12rev/kWh isused with a potential transformer of ratio 22000/110V and a currenttransformer of ratio 500/5 amperes. When connected to a load of unitypower factor , the disc makes 40 revolutions in 61 seconds. If theinstrument readings are 110V and 5.25A, find the percentage error.
Problem 4 An electric saw, a wood shaper, and a motor load of a workshop establish a 18 kVA power demand at 0.5 power factor lagging on a 208 V, 60 Hz supply. a) Establish the power triangle for the load. b) Determine the power-factor capacitor that must be place in parallel with the load to raise the power factor to 0.9 lagging. c) Determine the change in supply current from the uncompensated to the compensated system. d) Determine the power-factor capacitor that must be placed in parallel with the load to raise the power factor to unity.
The average load of a dairy plant at 11 kV, 50 Hz is 950 kW at 80 percent power factor but the maximum contract load of plant is 1200 kW. As per local electricity regulating authorities norms, consumer must keep the power factor of 95 percent to avoid any poor power factor penalty. Determine the following (i) Rating of capacitor bank (in kVAr) (ii) The capacitance of the capacitor bank (in micro Farad) (iii) Explain why the power factor becomes low and how the capacitor bank will assists to improve the power factor?
An industrial plant consumes 87.77 kW with a power factor=0.9(-) at 440 V, powered by a 2300 V line with a delta system. Determined: a) The capacity in KVA and the transformation relationship of each of the transformers that must conform to the bank.b) If you add the third transformer to complete the delta delta, it is the same as the power capacity of the bank.
Q1: A 50HZ,11KV,3-ph,alternator with earthed neutral has a reactance of 50\ph and is connected to bus bar through a C.B.The distributed capacitance up to C.B between phase and neutral is 0.01HF,Determine: 1-The restriking voltage across the contacts of the breaker, 2-The frequency of oscillation,and 3-The voltage across the capacitance. (if the disconnecting capacitive tank)? Q2:Repeat (1,2,and 3) in Q1 if the P.F. of the fault was capacitance current breaking due to 0.4? Q3:Repeat (1,2,and 3) in Q1 if the current chops at an instantaneous rate of 8A?