Write the general form of the capacitor voltage for the electrical network shown in Figure 1. Use MATLAB to plot the capacitor voltage. Show all your workings, MATLAB codes and results. R₁ = 10 kQ W

Write the general form of the capacitor voltage for the electrical network shown in Figure 1. Use MATLAB to plot the capacitor voltage. Show all your workings, MATLAB codes and results. R₁ = 10 kQ W

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3PA: You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors...

See similar textbooks

Related questions

Q: 7. Find the impulse response of the following systems in the time domain. a) h(t) = cos(2t) u(t) b)…

Q: contains a dependent source. 3 Ω 5Ω 5 Ω Μ το 1Ω 2 Ω 20 V Sio 4Ω

A: Given Data:A DC resistive circuit with,Dependent and independent sourcesTo Find:The value of the…

Q: Can duality principles be applied to understand the relationship between time and frequency domains…

A: Statement:By this property,If , then orIf , then

Q: 6. In the circuit shown, Ics = VB 0.5fA, VB = 4V, VA = ∞, and B voltages and branch currents. Q₁…

A: Given data, , , and ., To find outNode voltages and branch currents for the circuit.

Q: Calculate Vx in the following circuit using (a) nodal analysis and (b) superposition.

A: Given circuit is shown below:

Q: 1. How many nodes? Mark the nodes on the following circuit. How many independent loops, mark them on…

A: Given Data:A DC resistive circuit with,Voltage source Current source To Find:The number of nodes.The…

Q: Write a KCL at node A. Write a KVL of loop 1. Introduce currents and voltages as necessary to write…

Q: The magnetic field of a wave propagating through a certain nonmagnetic material is given by: H = x̂…

A: Given Data:The magnetic field of a wave propagating through a certain nonmagnetic material…

Q: ______ protection of equipment shall be provided for solidly grounded wye electrical services of…

A: Short-circuit protection of equipment shall be provided for solidly grounded wye electrical services…

Q: 1. Perform the following calculations and report your answer in phasor form. Show the application of…

Q: Problem 1 Determine the admittance, Y for the given circuit below.

A: Given circuit is shown below:

Q: What is the value of capacitance of a capacitor which has a voltage of 4V and has 16C of charge? A.…

A: Given information is shown below:

Q: Consider the circuit given below. 603 www 202 www 20 1002 www 50 www 50 V. V. V. lx V. 49 ΤΩ www www…

A: Given current values :Ix = 6 A , Iy = 11 A. Asked to find the node voltages Given circuit :

Q: Why are gold-plated connectors often used in high-quality audio and video cables?

A: To explain:Why are gold-plated connectors often used in high-quality audio and video cables?

Q: Example 2: Find current io and voltage vo in the circuit shown below 9A 252 ww 892 www

Q: 4. Find the voltage at node P in the following figure.

A: Given circuit is shown below:

Q: 2. Transform the following into their phasor-form counterparts: a. i(t) = 20sin(1600πt – 35°) A b.…

A: Phasor form is a way to represent sinusoidal signals using complex numbers. In phasor form, the time…

Q: E9.21 Find the value of capacity to be connected in parallel with the load in Fig. E9.21 to make the…

A: Given circuit is shown below:

Q: Example: Find current across each element in the circuit shown in figure below.

A: Given circuit is shown below:

Q: Find equivalent impedance of below circuit.

A: Given circuit is shown below:

Q: Calculate Vx in the following circuit using (a) nodal analysis and (b) superposition. 10V 3 3V

A: It is given that:

Q: What factors determine the maximum transmission distance for different types of cables?

A: The maximum transmission distance for different types of cables is influenced by a combination of…

Q: 1. Calculate the value of V1 and V2. B 11 12V V1 www ww + V2- U www D

A: The circuit diagram,

Q: x(n) = 3 cos wn x(n) = sin² wn

Q: Determine the reading of the measurements below. (Do not type the unit of measurement. Just input…

A: According to the question, we need to determine the reading of the measurement shown below,

Q: Problem 7. A source e.m.f. of 5 V supplies a current of 3 A for 10 minutes. How much energy is…

A: Given information is shown below:E = 5 VI = 3 At = 10 minute = 600 second

Q: What is the mutual admittance, Y24, of the electric circuit shown in Figure 1?

A: Given circuit is drawn below:

Q: The following system given by input (t) and output y(t) is linear. g(t) = 2r(t) + 2 True False

A: The following system given by input x(t) and output y(t) is linear. y(t) = 2x(t) + 2True False

Q: Voltage across 2 ohm?

A: Given circuit is shown below:

Q: Construct the Bridge Network circuit in Multism, as shown in Figure 1. All resistors are in Ohms

A: According to the question, for the circuit shown belowWe need to design the above circuit in…

Q: A linearisation of a nonlinear state-space model about an equilibrium point has the following A…

A: After linearization, we get a matrix A. (Around a equilibrium point)1) If all the eigen values are…

Q: 4. Find out the value of Rf that will produce the indicated closed-loop gain in each amplifier in…

A: Given circuit:

Q: Problem 7. A source e.m.f. of 5 V supplies a current of 3 A for 10 minutes. How much energy is…

A: Given information is shown below:E = 5 VI = 3 At = 10 minute = 600 second

Q: A compact disc(CD) records audio signals digitally by using PCM. Assume that the audio signal…

A: It is given that:

Q: E1.3 Find the power that is absorbed or supplied by the elements in Fig. E1.3

A: Given circuit is shown below:

Q: How can electromagnetic interference (EMI) affect the data transmission quality of unshielded…

A: Electromagnetic interference (EMI) can significantly impact the data transmission quality of…

Q: The charge entering the positive terminal of an element is given by the expression q(t) = -17…

A: Given that the power P(t)=3.3e−3t W and that P(t)=i(t)⋅v(t), where i(t)=I⋅eat and v(t) is the…

Q: A DC machine has total armature ampere conductors of 4500 and total flux in the machine is 0.14 wb.…

A: Given information is shown below:

Q: Why are braided cables often more durable than their non-braided counterparts?

Q: Fill in the timing diagram for a falling-edge-triggered J-K flip-flop. Assume Q begins at 0. Clock K…

A: The circuit diagram for the Flip-flop is shown below,

Q: Given charge q(t) as shown: q(t) 2- 4 Then find and sketch the current i(t) Solution: time

A: Given detailsThe waveform for the charge is given by,To find outSketch the waveform for

Q: Why might pipeline flushes be considered wasteful in terms of computational resources?

A: Pipeline flushes, also known as pipeline stalls or pipeline bubbles, occur in processor pipelines…

Q: S 8(t) ejut dt =

A: According to the question, we need to solve

Q: Why is grounding essential in transmission cabling installations?

A: For a number of crucial reasons, grounding is required in transmission cabling installations,…

Q: What considerations should be taken into account when choosing cables for outdoor installations?

A: We need tell about considerations should be taken into account when choosing cables for outdoor…

Q: b) Find current using nodal analysis. 252

A: Given circuit is shown below:

Q: Discuss the impact of cable thickness on its resistance and data transmission capabilities.

Q: The expressions for the steady-state voltage and current at the terminals of the circuit seen in…

A: The source voltage,The current supplied by the source,

Q: The impedance of the stator winding of a 440 V, star-connected, three-phase inductio n motor is (0,2…

Q: Given the following circuit, if V= 79V, R1=128 Ω , R2=331 Ω and R3=215 Ω Find the value of the…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Pls solve question by hand and matlab also

Write the general form of the capacitor voltage for the electrical network shown in Figure 1. Use MATLAB
to plot the capacitor voltage.
Show all your workings, MATLAB codes and results.
R₁ = 10 ΚΩ
M
v(t) = u(t) (±
R₂ = 10 kQ
L = 200 H
Figure 1
oooo
C = 10 μF

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Determine the given variables:-

VIEW

Step 2: Using Nodal analysis:-

VIEW

Step 3: Calculating the capacitor voltage:-

VIEW

Step 4: MATLAB code:-

VIEW

Step 5: Capacitor voltage graph:-

VIEW

Solution

VIEW

Step by step

Solved in 6 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
List the five capacitor replacement rules.
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
The figure below shows a simple RC circuit with a 3.30-μF capacitor, a 4.40-M resistor, a 9.00-V emf, and a switch. What are the following exactly 9.00 s after the switch is closed? (a) the charge on the capacitor 13.7204 UC (b) the current in the resistor 0.0110522 x Your response is off by a multiple of ten. HA (c) the rate at which the capacitor is storing energy μW (d) the rate at which the battery is delivering energy μW