Why in high voltage system, we prefer direct or small resistance? How to define the classes of load? Why we should to do such classification??(find answer from website) what are the main load curves of the power system? What is the maximum load utilization hours?

Q: Ass 18 (a) Find the voltage vy in the circuit in Fig. P2.18. (b) Show that the total power generated…

A:

Q: 6. Draw the output voltage waveform for each circuit in the figure below and include the voltage…

A: In this question we need to draw the output voltage waveform of the given circuit and we also need…

Q: The voltage (Vi) shown in the graph is applied to the amplifier below.  2.1 Find Vo at t = 6 ms…

A: Since you have posted the questions with multiple subpart and so we are supposed to answer 3…

Q: Design a shift register using d flip flop and logic gates to go from 0001 to 0010 to 0100 to 1000…

A: Given

Q: Design a length M = 6 FIR filter with real coefficients so that the filter's frequency response H(w)…

A:

Q: 12 V M 4Ω ΑΛΛ 4Α 3Ω M 10 Ω 2Ω M 5Ω ( 24

A:

Q: = . Show that δ(n) =u(n) - u(n-1) and u(n) = - Σ - () = Σδ(n-1). k = = 00

A: According to the question, we need to show and,

Q: The circuit shown in the figure consists of a real battery with emf, ε = 24 V, and internal…

A:

Q: (33) ㅋ Req 50n سله Josh 7022 You ww 13052 15052 M 5052 20052

A:

Q: Draw the output voltage waveform of the circuit shown. Do not forget to label the values.

A:

Q: a. Draw a block diagram of an encoder with 10 input lines b. Make a truth table to represent such an…

A:

Q: For each transistor shown in the Figure, determine whether the BE and BC junctions are forward- or…

A:

Q: (2) A circuit has the terminal voltage and line currents as v(t)=3x10-03 cos(100nt- ) volts and…

A: Answer: given that a circuit has terminal voltage    v(t) =3×10-3 cos(100πt -π6) V line current is…

Q: In this circuit, what will be the voltage peaks of the output, if the input is 20Vp-p sine wave?…

A:

Q: 11. Which one of the following diagrams illustrates the correct polarity relationship for an…

A:

Q: Consider the circuit in the drawing. Determine (a) the magnitude of the current in the circuit and…

A:

Q: For the circuit shown: Will |Vb/Va| have the form of the Bode Plot below?

A: The Circuit is given as To find the transfer function, make the dc voltage source short circuit.

Q: Using the properties of the z-transform, find the z-transform for each of the following b. x(n)= e)…

A: Q-(b) Answer:—

Q: Consider the following circuit where the switch is turned on at t = 0. V R = 100 kn, R G(s) = C =…

A:

Q: 7. A 3-phase, Y-connected, 2-pole alternator runs at 3,600 r.p.m. If there are 500 conductors per…

A:

Q: 6. A system is described by the following differential equation. Find the expression of the transfer…

A:

Q: Answer the following questions: 1. Simplify the function below using a three-variable K-Map. F…

A:

Q: Prove that in Maxwell, be used to measure inductanceby Comparison either with a variable Standard…

A: In this question We need to verify the Maxwell bridge circuit.  We know Admittance Y= 1/Z We are…

Q: is given The initial capacitor voltage, and equal to Vc (0) = 10V. Determine and sketch vc (t) for…

A:

Q: t) = 5 sm (6283t) V + 10 mH 20 Oscilloscope Channel 1 Y(0) 1kQ Figure 2. Circuit with an inductance…

A:

Q: What will be the negative peak output voltage (in V) of the circuit below if the diode VTH is 0.7 V…

A: In this question We need to determine the negative peak output voltage of the given circuit.  We…

Q: I: An incoming sine wave results in a gain of -5db. The output sine wave has a peak value of 1V.…

A: Given Data: An RC High Pass Filter has, Peak Output voltage Vb=1 V Voltage gain AV=-5 dB To Find:…

Q: Find the equivalent impedance Zeq seen by the source when Vs = 4 cos (2t) v, C = 1 F, R = 3 2 and L…

A:

Q: 18. If the current flowing in an operating circuit must be approximately measured without…

A: the answer is option C, split-core-type.

Q: 3. Determine Req if each R is 5 ohms. M M W -M N M

A: We need to determine the equivalent Resistance, Req.

Q: Explain the phenomenon of superconductivity and its potential applications.

A: We need to explain the phenomenon of superconductivity and its potential applications.

Q: inputs Clock and D. The initial value of the clock and Q is 1. When the clock is 1, the…

A:

Q: Example 3. Determine v for the network of Figure 6. Example 4. Repeat Example 3 using Silicon diode.…

A: In  this question We need to determine the output voltage waveform.  If diode is ideal and silicon…

Q: What value of filter capacitor is required to produce a 1% ripple factor for a full-wave rectifier…

A: Given: Load Resistor = 1.5kΩ, Peak output voltage = 18V and the ripple factor is 1% of peak output…

Q: JFF w m + 4-23 Vo(t) 35-2 Find G(s) = Vo(s) Vi (s)

A: Here we have to find transfer function.

Q: + v υ 10Ω i₁ 603 40 ΜΗ· 1 μF Click to see additional instructions The sinusoidal current source in…

A: here we have to find the current i3.

Q: QUESTION 5 Analog output modules are used to simply set an output either on or off True False

A: Given, Statement is  Analog output modules are used to simply set an output either on or off. We…

Q: Dose antenna 4g or 5g have heatlh effect on people? How much does this effect goes does it depend on…

A: We all know that 4G and 5G network technology has the high speed network with the help of it we can…

Q: Simplify F=A’B’C’ + A’B’(C’+C)+ABC

A:

Q: vi(t) Find the transfer function of the given network. 0000 2 H 192 + Vo(t)- 0000 3 H (a)…

A:

Q: Schottky diode Select one: a. is a diode with zero diffusion capacitance O b. None of the answers c.…

A: We need to select correct option for Schottky diode .

Q: What is the total resistance if all resistors have 8Ω resistance? (Transform Wye to Delta/Delta to…

A: The given circuit is shown below. All resistors have value of resistances 8 Ω. We need to determine…

Q: 1. Describe in generic terms the type of unit you think this is based on your interpretation of the…

A: Mini Split heat pump : Mini-break up heat pumps are a not unusual form of smaller HVAC unit. They…

Q: SOLVE THE CIRCUIT BY USING SUPERPOSITION THEOREM TO FIND THE CURRENT FLOWING THROUGH EACH RESISTOR

A: It is given that:

Q: A three phase 50 Hz transmission line has impedance of (25.3+ j66.5) ohms and a shunt admittance of…

A: It is given that: Z=25.3+ j66.5 ΩY=j4.42×104 mhoP=50 MWVr=220 kVcosϕ=0.8 lagging

Q: B=2V, Vcc= 12V, and 3 = 120. VBB Ra www Figure P9.11 Voc ww Rc ww

A: Here we have to find the current IR.

Q: Q1)information signal is PCM using 8 levels quantization if the signal is given as cos(4лt) with…

A: Given: In PCM, Quantization levels = 8,  The signal is, cos(4πt) with a sampling rate 10Hz. To do:…

Q: Your company is considering the installation of a 2 MW wind turbine with a rotor diameter of 90 m in…

A: Given: 2 MW wind turbine with a rotor diameter of 90 m in a location with average wind v = 8.5 m/s.…

Q: Using the partial fraction expansion method, find the inverse of the following z-transforms: b. X(z)…

A: here we have to find the partial and then inverse Z-transform.   we know that Z-1 zz-a = an un…

Q: Find R initial at T initial=3°C where the temperature coefficient a-20, R final 6032 and T final…

A:

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.