Which of the following statements is true? A Liquids can be weighed using a weighing paper. B In weighing hygroscopic substances, containers should always be kept close when not in use. After drying a sample in the oven, you can place it immediately inside the analytical balance. D Place solid reagents / precipitates directly on top of the balance pan.

Which of the following statements is true? A Liquids can be weighed using a weighing paper. B In weighing hygroscopic substances, containers should always be kept close when not in use. After drying a sample in the oven, you can place it immediately inside the analytical balance. D Place solid reagents / precipitates directly on top of the balance pan.

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter6: Steam Distillation, Vacuum Distillation, And Sublimation

Section: Chapter Questions

Problem 11Q

See similar textbooks

Similar questions

A silver chloride precipitate is a type of gelatinous precipitates * True False
Ammonium sulfate is added to an unknown mixture of ions. A precipitate forms. The solution is centrifuged, and the remaining solutions is decanted. Ammonium oxalate is then added to the solution and no precipitate forms. Sodium monohydrogen phosphate and sodium hydroxide are added to the decanted solution, and no precipitate forms. Sodium hydroxide is added to a fresh sample of the unknown. A damp piece of litmus paper over the opening of the test tube remains red. Select the ions present. Question 5 options: Ba2+ Ca2+ Mg2+ NH41+
Ammonium sulfate is added to an unknown mixture of ions. A precipitate forms. The solution is centrifuged, and the remaining solutions is decanted. Ammonium oxalate is then added to the solution and no precipitate forms. Sodium monohydrogen phosphate and sodium hydroxide are added to the decanted solution, and no precipitate forms. Sodium hydroxide is added to a fresh sample of the unknown. A damp piece of litmus paper over the opening of the test tube turns blue. Select the ions present. Question 4 options: Ba2+ Ca2+ Mg2+ NH41+
[Review Topics] [References] Use the References to access important values if needed for this question. An aqueous solution of ammonium acetate, NH, CH3COO, is made by dissolving 8.30 grams of ammonium acetate in sufficient water in a 100. mL volumetric flask, and then adding enough water to fill the flask to the mark. What is the weight/volume percentage of ammonium acetate in the solution? Weight/volume percentage = % Submit Answer Retry Entire Group 4 more group attempts remaining Previous Email Instructor Next Save and Exit
Volumetric Analysis Liza carefully pipets 25.0 mL of 0.525 M NaOH into a test tube. She places the test tube into a small beaker to keep it from spilling and then pipets 75.0 mL of 0.355 M HCl into another test tube. When Liza reaches to put this test tube of acid into the beaker along with test tube of base, she accidentally knocks the test tubes together hard enough to break them and their respective contents combine in the bottom of the beaker. Is the solution formed from the contents of the two test tubes acidic or basic? What is the pH of the resulting solution?
The following volumes of 0.000300 M SCN- are diluted to 15.00 mL. Determine the concentration of SCN- in each sample after dilution. These values will be used during the experiment. Sample 0.000300 M SCN- (mL) [SCN-] (M) 1 1.50 2 3.50 3 7.00 4 10.00
B. Determining the Composition of a Mixture of Sodium Chloride and Sodium Nitrate Partner I Prepare a solution of sodium chloride + sodium nitrate and indicator. Obtain a dropper bottle of potassium chromate (indicator) solution. To a clean and dry 125 mL Erlenmeyer flask, add about 40 mL of water and 8 drops of indicator solution. Weigh out approximately 0.05 grams of sodium chloride + sodium nitrate solid and record its exact mass. Dissolve the solid in the solution from step 1, stirring with a stirring rod to ensure complete dissolution. Determine and record the total mass of the Erlenmeyer flask and solution, noting the balance that you use to weigh. Rather than measuring the volume of silver nitrate solution added as in Part A, we will measure the mass of titrant added and make use of the weight-percentage concentration of silver nitrate in calculations. Prepare the silver nitrate solution. Obtain about 15 mL of 1.70% w/w silver nitrate solution in a 50 mL beaker. Designate a…
Weigh accurately 4.0 g of sodium chloride into a 250cm3 volumetric flask. Using a wash bottle add about 200cm3 of distilled water. Stopper the flask. Shake vigorously for three minutes. Remove the stopper for a second then continue to shake for about another two minutes until all the solid has dissolved. Add more water slowly upto exactly the 250 cm3 mark. 1.Calculate the number of moles of sodium chloride present in: (i) 4.0 g (ii) 250 cm3 solution in the volumetric flask. (iii) one decimeter of solution
1. Precipitates are produced from a chemical reaction. Give at least 3 types of appearances or textures of precipitates. 2. Determine the strength of a Test Solution in millimolar concentration. [express answer up to 4 decimal places] 3.What gas (chemical name) is evolved when the odor observed is sour-like, and not too irritating to the nose? 4.Give at least 8 manifestations or observable results after a chemical reaction has completed.
In the event of subsequent sedimentation, it must: 1- filtration quickly 2- disturbing the sediment 3- Digestion of the precipitate 4- Add the electrolyte solution
A student was tasked to perform gravimetric analysis of a soluble sulfate. His unknown sample weighed 0.7543 g. The sample underwentprecipitation using BaCl2 and was digested for overnight. The precipitate was then filtered off to obtain white crystalline precipitate that was collected inan ash less filter paper. In performing constant weighing, he obtained a crucible mass that is 29.9442 g. After burning his samples inside the crucible,the obtained mass was 30.3375 g. Compute for the theoretical % SO3 obtained by the student and the theoretical mass (g) of SO3 that should be obtained by the student using his weighed sample
A student was tasked to perform gravimetric analysis of a soluble sulfate. His unknown sample weighed 0.7543 g. The sample underwentprecipitation using BaCl2 and was digested for overnight. The precipitate was then filtered off to obtain white crystalline precipitate that was collected inan ash less filter paper. In performing constant weighing, he obtained a crucible mass that is 29.9442 g. After burning his samples inside the crucible,the obtained mass was 30.3375 g.29. Compute for the mass (g) of BaSO4 from the experiment.A) 0.3933B) 0.3393C) 0.3133D) 0.3951E) 0.359130. Compute for the experimental mass (g) of SO3 in grams obtained by the student.A) 0.1439B) 0.1349C) 0.1943D) 0.1394E) 0.359131. Compute for the experimental % SO3 obtained by the student.A) 73.21B) 56.33C) 17.89D) 56.89E) 72.8032. Compute for the theoretical % SO3 obtained by the studentA) 0.3933B) 56.37C) 17.33D) 17.89E) 0.425233. Compute for the theoretical mass (g) of SO3 that should be obtained by the student…