Answered: Which of the following is the correct…

Which of the following is the correct comparison of the specific gravity of the fluids indicated in the table below? * Fluid Density (g/mL) A B O A>B>C O B>A>C O B>C>A C>A>B 3. 5.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter15: Fluids

Section: Chapter Questions

Problem 23PQ: What fraction of an iceberg floating in the ocean is above sea level? Assume the density of the...

See similar textbooks

Related questions

Q: We have two barometers, like the one shown in the figure. One uses mercury and the other uses an…

A: Pressure can be calculated by the quantities, height, density and acceleration due to gravity.…

Q: The flat surface shown is submerged vertically in water. Find the fluid force against the surface.…

A: Given: Length L' = 2 m Breadth B = 8 m The weight density of water D = 9810 Nm3 To determine: Force…

Q: The figure below shows a spring scale and a platform scale. A beaker containing water rests on the…

A: Here given two scale of spring and platform scale.The mass of the beaker ,copper block and fluid is…

Q: A wood block with a mass of 15.9 kg is floating in water. What is the weight of the displaced water…

A: For a floating object, the weight of the object will be equal to the buoyancy force exerted by the…

Q: A container is partially filled with a known amount of fluid that has a density of 984 kg/m3. When…

Q: The Venturi tube shown in the figure below may be used as a fluid flowmeter. Suppose the device is…

A: ρ = 711 kg/m3 r1 = 2 cm = 0.02 m r2 = 1 cm = 0.01 m P1 - P2 = 1380 Pa v1 = ?

Q: Which has the greater density—1 kg of sand or 10 kg of sand? Explain

A: Mass of first sample of sand = 1 kg Mass of other sample of sand = 10 kg

Q: What is the principal cause of action of the buoyant force on a body submerged partially or fully in…

A: Explanation: According to Archimedes's principle states that a body partially or fully submerged in…

Q: A hydraulic press for compacting powdered samples has a large cylinder with a diameter of 10.0 cm…

Q: The inside diameters of the larger portions of the horizontal pipe are 2.50 cm. Water flows to the…

A: Let d1 be the inner diameter of the cross-section of the larger horizontal pipe, and R be the flow…

Q: Calculate the fluid force on one side of a semicircular plate of radius 1 ft that rests vertically…

Q: Current Attempt in Progress The flat surface shown is submerged vertically in water. Find the fluid…

Q: 1. Bernoulli's equation can be directly applied to viscous flow. a. True b. False 2. A chocolate bar…

A: 1. False, Bernoulli's equation does not include viscous forces, since Bernoulli's equation is based…

Q: . Which statement is TRUE? A. When the area of the tube is small, the speed of the fluid is great…

A: 1) continuity equation : According to continuity equation area of a tube is inversely proportional…

Q: 令 9:59 AM * 72 A webassign.net 19. 0/1 POINTS PREVIOUS ANSWERS OSCOLPHYS2016 12.1.WA.005. MY NOTES A…

A: Here, density is given as below: During the first four hour after the surgery the patient…

Q: The large piston of a hydraulic lift had a cross-sectional area 25 times more than the small…

Q: how to calculate volume of the fluid displaced from a partially submerged object?

A: As per the Archimedes principle, when an object is submerged either partially or fully in a fluid,…

Q: ottom of a cylindrical container with a cross-sectional area of 45.5 cm2 and holding a fluid of…

A: We know that We have given that The pressure at the bottom of a cylindrical container is 115 kPa…

Q: Find the fluid force on the vertical side of the tank, where the dimensions are given in feet.…

Q: calculate the fluid pressure on an object that is at a depth of 9.90m in pure water

Q: AV= constant, where A= area of cross-section and V= velocity of fluid. This equation is called…

A: Equation of continuity states that rate of flow of ideal liquid is constant. Rate of flow of liquid…

Q: What is the buoyant force that an object experiences if when inserted in a liquid, it displaces 5 N…

A: Weight of fluid displaced by an object when immersed in a liquid = 5 N

Q: The figure above shows an object of mass 0.7 kg that is suspended from a scale and submerged in a…

Q: HYDRAULIC LIFT. In the figure below, a hydraulic lift has one piston of diameter 8.0 cm and the…

Q: The large piston of a hydraulic lift had a cross-sectional area 18 times more than the small…

A: Given data: F1=30 NA2=18A1 Need to determine the magnitude of the force F2.

Q: Water (η = 1.00E-3 Pa·s) is flowing through a horizontal pipe with a volume flow rate of 0.0132…

A: Find the gauge pressure.

Q: What is the velocity of water given the following?

A: Given:Diameter of pipe = 0.4 mDynamic viscosity of water = 0.01 kg m/sDensity of water = 997…

Q: The viewing portion of the rectangular glass window in a fish tank is 69 inches wide and runs from…

A: Concept to be used: Pressure due to fluid of density ρ at a depth h from its surface by the…

Q: The water flow rates of the liquid with the density 7,1 kg/m in all sections of the inclined pipe…

Q: Two identical semicircular windows are placed at the same depth in the vertical wall of an aquarium…

A: Both of them will have same fluid force

Q: Several common barometers are built, with a variety of fluids. For which of the following fluids…

Q: Determine the buoyant force for the following situation. A block with a volume of 350 cm3 is…

A: buoyant force is an upward force, that exerted by a fluid which opposes the weight of an immersed…

Q: Consider a block of wood that floats with 60% of its volume above water along a portion of creek at…

Q: The horizontal constricted pipe illustrated in Figure below, known as a Venturi tube, can be used to…

Q: If there were no gravity, which of the following will not be there for a fluid? A) Viscosity B)…

A: Introduction: Gravity is defined as the force of attraction applied by the Earth on the objects near…

Q: The mass of a piece of ice is 0.850 kg. density of water 10 water = 100-10³ kg/m³, and density of…

A: Buoyant force is the net high ward force on any object in any fluid. If the buoyant force is higher…

Q: A plate in the shape of an isosceles triangle with base 1 m and height 20 m is submerged vertically…

Q: Calculate the fluid force on a side of the plate in the figure below, submerged in fluid of mass…

A: Given: Density of the fluid ρ = 975 kg/m3 Acceleration due to gravity = 9.8 m/s2

Q: A car weighting 10,000 N supported by a hydraulic car lift. The large piston supporting the car has…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: Fluid flows in a pipe of different radii: point A - 3 cm; point B – 1 cm; point C - 5 cm. If the…

A: the equation of continuity says,A1v1=A2v2where, A1=cross-sectional area of region 1 v1=flow velocity…

Q: The large piston of a hydraulic lift had a cross-sectional area 30 times more than the small…

Q: A stone of weight 69 N is tied to a scale and lowered completely into water. The reading of the…

Q: QUESTION 7 Bernoulli's Principle states that where the velocity of the fluid is high, the is low.…

A: Bernoulli's Principle states that as the speed of a moving fluid increases, the pressure within the…

Q: Choose the correct answer: Buoyant force =Weight of the displaced fluid. O True %3D O False O…

Question

Which of the following is the correct
comparison of the specific gravity of
the fluids indicated in the table
below? *
Fluid
Density (g/mL)
A
O A>B>C
B>A>C
O B>C>A
O C>A>B
3.
5.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Liquid toxic waste with a density of 1752 kg/m3 is flowing through a section of pipe with a radius of 0.312 m at a velocity of 1.64 m/s. a. What is the velocity of the waste after it goes through a constriction and enters a second section of pipe with a radius of 0.222 m? b. If the waste is under a pressure of 850,000 Pa in the first section of pipe, what is the pressure in the second (constricted) section of pipe?
Archimedes' principle can be used to calculate the density of a fluid as well as that of a solid. Suppose a chunk of iron with a mass of 390.0 g in air is found to have an apparent mass of 350.5 g when completely submerged in an unknown liquid. (a) What mass of fluid does the iron displace? (b) What is the volume of iron, using its density as given Table 14.1? (c) Calculate the fluid's density and identify it.
(a) Verify that a 19.0% decrease in laminar flow through a tube is caused by a 5.00% decrease in radius, assuming that all other factors remain constant, as stated in the text. (b) What increase in flow is obtained from a 5.00% increase in radius, again assuming all other factors remain constant?
Pascal’s Principle and Hydraulics 59. How much pressure is transmitted in the hydraulic system considered in Example 14.3? Express your answer in atmospheres.
(a) Using Bernoulli's equation, show that the measured fluid speed v for a pitot tube, like the one in Figure 12.7(b), is given by v=( 2gh)1/2 , where h is the height of the manometer fluid, is the density of the manometer fluid, is the density of the moving fluid, and g is the acceleration due to gravity. (Note that v is indeed proportional to the square root of h, as stated in the text.) (b) Calculate v for moving air if a mercury manometer's h is 0.200 m. Figure 12.7 Measurement of fluid speed based on Bernoulli's principle. (a) A manometer is connected to two that are close together and small enough not to disturb the flow. Tube 1 is open at the end facing the flow. A dead spot having zero speed is created there. Tube 2 has an opening on the side, and so the fluid has a speed V across the opening; thus, pressure there drops. The difference in pressure at the manometer is 12v22 , and so h is proportional to 12v22 . (b) This type of velocity measuring device is a Prandtl tube, also known as a pitot tube.
Water is moving at a velocity of 2.00 m/s through a hose with an internal diameter of 1.60 cm. (a) What is the flow rate in liters per second? (b) The fluid velocity in this hose's nozzle is 15.0 m/s. What is the nozzle's inside diameter?
Does atmospheric pressure add to the gas pressure in a rigid tank? In a toy balloon? When, in general, does atmospheric pressure not affect the total pressure in a fluid?
What effect does capillary action have on the reading of a manometer with uniform diameter? Explain your answer.
Many figures in the text show streamlines. Explain why fluid velocity is greatest where streamlines are closest together. (Hint: Consider the relationship between fluid velocity and the cross-sectional area through which it flows.)
(a) Using Bernoulli's equation, show that be measured fluid speed v for a pitot tube, like the one in figure 14.32(b), is given by v=( 2gh)1/h , where h is be height of be manometer fluid, p' is the density of the manometer fluid, p is the density of the moving fluid, and g is be acceleration due to gravity. (Note that v is indeed proportional to the square root of h, as stated in text) (b) Calculate v for moving air if a mercury manometer's h is 0.200 m. Figure 14.32 Measurement of fluid speed on Bernoulli’s principle. (a) A manometer is connected to two tubes close together and small enough not to disturb the flow. Tube 1 is open at the end facing the flow. A dead spot having zero speed is created there. Tube 2 has an opening on the side, so the fluid has a speed v across; thus, pressure there drops. The difference in pressure at the manometer is 12v22 , so h is proportional to . 12v22 (b) This type of velocity measuring device is a Prandtl tube, also known as a pitot tube.
The water supply of a building is fed through a main pipe 6.00 cm in diameter. A 2.00-cm-diameter faucet tap, located 2.00 m above the main pipe, is observed to fill a 25.0-L container in 30.0 s. (a) What is the speed at which the water leaves the faucet? (b) What is the gauge pressure in the 6-cm main pipe? Assume the faucet is the only leak in the building.
Considering the magnitude of typical arterial blood pressures, why are mercury rather than water manometers used for these measurements?