which of the ff will maximize magnitude of average power supplied by AC source to simple RLC series 1. capacitive reactance is half of inductive 2.angular frequency of source current is 1/sqrt(LC) 3.voltage source amplitude=to capacitro 4.resistance is larger either inductive or capacitive

which of the ff will maximize magnitude of average power supplied by AC source to simple RLC series 1. capacitive reactance is half of inductive 2.angular frequency of source current is 1/sqrt(LC) 3.voltage source amplitude=to capacitro 4.resistance is larger either inductive or capacitive

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: Find voltage across the inductor, v(t). Use phasor technique. Vs(t)=15 cos(20t) V

Q: 13.) Calculate the inductance or capacitance in series for the impedance 7.5z-53.13° ohms. Assume…

Q: Given V 20 sin(@t + 60°) and V = 60 cos(@t- 10°) What is the phase angle %3D between the waveforms?…

A: In the question Two waveform are given Find the phase difference between both waveform. We are…

Q: If the capacitive reactance Xc is equal to 350n, f= 120HZ, the capacitance C is equal a) 1 μF b)…

A: Given: The capacitive reactance, Xc=350 Ω Frequency, f=120 Hz

Q: At 60 Hz, what is the power factor of the circuit below ?. What Capacitor connected across the input…

Q: In RLC series circuit, if the voltage across capacitor is greater than voltage across inductor, then…

A: Series RLC circuit- Applying KVL we get-

Q: A 12 V, 1kHz ac voltage source is connected to a parallel RC circuit. Given that R = 220 22 and Xc =…

Q: A coil and capacitor are connected in series. The inductive reactance is 250 W, and the capacitive…

A: Brief description: Note : In the above given question inductive and capacitive reactances must be in…

Q: 3. A series circuit composed of a 0.2 henry inductor and a 74 micro farad capacitor is connected to…

Q: A coil of resistance 20000 and self- inductance 1.0 Henry has been connected to an a.c. source of…

A: The coil can be thought of as the resistance connected in series with the inductor. The inductive…

Q: ic + Xc LET ic 30mA sin(280t+80 ) and Xc = 4.5 k 2 %3| then Calculate the voltage across the…

Q: The reactance X of capacitance =jwc O True O False

Q: Calculate the phase angle of the inductor current in the AC circuit given below. 150 250

A: The solution ca be achieved as follows.

Q: A 10 V ac source is connected to a series RL circuit which has a resistance of 1 k2 and an inductive…

Q: An inductor and a resistor are connected in series with a function generator. The voltage across the…

Q: Increasing the capacitance of an AC circuit causes the capacitive reactance to: a) decrease. Ob)…

A: We need to select correct option for reactance .

Q: convert the figure and calculate the magnitude and the angles of Za, Zb and Zc

Q: For the circuit shown below, determine the voltage of the -j10 2 capacitive reactance. -js a 0.5L-90…

A: In this question We need to find a voltage across -j10 ohm capacitor .

Q: An RC series circuit is connected to a 240-V, 60-Hz power source. An ammeter indicates a current of…

A: An RC series circuit is connected to a 240-V, 60-Hz power source. An ammeter indicates a current of…

Q: In case of Inductive circuit, Frequency is directly Proportional to the inductance (L) or inductive…

A: A pure inductive circuit is those which contain Inductor as a component. Considering the formula for…

Q: culate the real power P, reactive power Q and apparent power S, inclu Xc R A .07S XC = 35, R= 150N;…

Q: A 25 µF (25E-06 F) capacitor is connected in parallel with an 90 resistor across a Vrms = 230<0° V,…

A: Given R = 90 F = 60 Hz C = 25 microF

Q: What will be the magnitude and phase angle of impedance when a 50 ohm resistor and 500 mH inductor…

A: Given; Resistor and inductor are connected in series R=50 ΩL=500 mHω=100 rad/s

Q: Phasor A: magnitude 10, angle 45° Phasor B: magnitude 10, angle -45°

Q: In the phasor diagram of balanced star connected system the angle between VY and - VY is 180 degree.…

Q: A series RL combination in an AC circuit has R = 100 and X = 120. A capacitor is connected across…

Q: )calculate the magnitude of the voltage across the j9 ohm inductor. b) calculate the magnitude of…

A: In order to determine the voltage and current across the required elements. The above circuit is…

Q: For each set of ac phasors, find the indicated resultant. 10. RC series circuit: VR 8 20° V, Vc 5…

A: The total voltage of the series RC circuit can be calculated by using kirchhoff's voltage law.

Q: A círcuit havingaresistance of 42 an inductance of o.5H and a variable capacitance in series, is…

Q: Problem: Suggestion easuring circuits in the laboratory using meas u method for the time constant of…

A: Time constant is defined as the time to reach 53% of steady state value in charging circuit It is…

Q: an rc series circuit is connected to a 240v 60 hz power source an ammeter indicates a current of 20…

A: We have drawn a circuit diagram corresponding to the given information. The RMS value of input…

Q: 7. What is the capacitance value of the impedance 18.97 cis -18.2° with an angular frequency of w =…

Q: An RL series circuit consists of a resistance of 15 ohm and an inductor which has an inductive…

Q: 5. At what frequency does a 35 mH inductor have 47 k2 of reactance? Answer : f = kHz

A: This question belongs to circuit theory . It is based on the concept of formula of inductive…

Q: A series circuit like the circuit in (Figure 1) consists of a 1.40 mH inductor, a 115 N resistor,…

A: The values series circuit components are,L=1.40mHR=115ΩC=95nFvRMS=55V

Q: What capacitance must be placed in series with an inductance of 0.05 Henry so that at 100 Hz, the…

Q: An inductive circuit has a resistance of 10 ohms and an inductance of 2 henrys. The total impedance…

Q: In an RL circuit, the impedance is determined by both the resistance and the inductance combined.…

A: We need to tell about the given statement is true or false

Q: Problem: The voltage across an 0.2H coil is V= 10 sin (10t+ 10 ) find the equation of the current,…

Q: A capacitor of reactance 50 n and a resistor of 40 N are connected in series across the AC source.…

A: The solution is given below.

Q: A 12V,1KHz AC voltage source is connected to a parallel RC circuit .Given that R=220Ω and Xc=150Ω.…

Q: While Thevenizing a circuit between two . . terminals, VTH is equal to rms voltage available in the…

A: In a linear active bilateral network consisting no. of energy sources, resistances etc with open…

Q: 3-Evaluate Sin (") (Using reference angle)

Q: Find the phase relation of the following pair of sinusoids: (a…

A: The given voltage and current phasors are in sine and cosine notations. Convert voltage phasor into…

Q: The phasor of the impedance of an AC circuit has no vertical component. What does this mean? there…

A: Consider in case of a pure inductive circuit the current lags the voltage by an angle of 90 degree.…

Q: Identify the circuit element from the given Phasor diagram. 245° V a. Resistor O b. Capacitor O .…

Q: H.W: The voltage source 60 the magnitudes of the inducto

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

which of the ff will maximize magnitude of average power supplied by AC source to simple RLC series

1. capacitive reactance is half of inductive

2.angular frequency of source current is 1/sqrt(LC)

3.voltage source amplitude=to capacitro

4.resistance is larger either inductive or capacitive

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
4) Determine the value of voltage across resistor and capacitor5) Convert in rms values
TOE This is a photo of a capacitor that corrects the power factor in an AC setup, in DC it is used in electronic board for appliances and other small devices. Tell me something about this photo.
Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
The below figure shows the waveform of the voltage and current in a purely inductive AC circuit. Voltage Current Using the voltage phasor as the reference, the current phasor Lags by 90° Is in phase with the voltage Leads by 90° Lags and then leads by 160°
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms
Explain the following 1. Diffrence between DC and AC Electricity. 2. how to convert rectangular form to polar form and polar form to rectangular form. 3. why need to improve a power factor
The maximum value of sinusoidal voltage is given by Vm= 1 V, What is the value of Peak to Peak voltage?
What is the relationship between R, L, and C components in a series AC circuit?
Determine the rms current in the figure for Vrms = 16 V and C = 74µF V f=10 kHz