What will happen to the value of the impedance if the resistance will be increased or decreased? Explain...
Q: b) What is the average power consumed by the resistance in the circuit in the figure?
A:
Q: What are the characteristics of an excellent DC power source? Give 3 and explain.
A:
Q: What are the advantages of renewable energy over
A:
Q: A dc-source has positive and negative polarities. Is it correct to say that an ac-voltage source has…
A: Given statement Polarity of AC and DC sources
Q: What are the elements which contribute to the cost of the electricity? And discuss how the “load…
A: COST OF ELECTRICITY Different methods of electricity generation can result in a variety of costs,…
Q: 2. Give at least 3 advantages of AC to DC and 3 disadvantages of AC to DC.
A:
Q: What is the effect of cross section on resistance?
A: Resistance :- It is the opposition offered by the elements to flow of current. Mathematical written…
Q: What is the phase relationship between the voltage and current in an AC resistive circuit?
A: We need to find out phase relationship for resistive network .
Q: equation for Kirchhoff's Current Law
A:
Q: What is metastability? How to avoid this.
A: Flip flop is a latch with additional control input (clock or enable ). A flip flop is used to store…
Q: What do the conductors have in common? What do the insulators have in common?
A: A conductor means a kind of material that allows the flow of electric charge that is electrons in…
Q: Explain the hysteresis that can be found in materials due to force, magnetic and electrical…
A:
Q: You want to demonstrate charging the electroscope by the induction process. However, it does not…
A: The constraint given in the question is that there is no conducting wire to make the ground…
Q: What is meant by FACTS in power systems? Discuss about STATCOM type FACTS device.
A: Power system - Power system is a network of electrical components that are used to supply,…
Q: What is the rating and application of extra high tension
A: The voltage rating of extra high tension line is from 345 KV upto 800 KV .
Q: please write introduction about AC Circuits – Series and Parallel connected Circuits
A: Given introduction about AC Circuits – Series and Parallel connected Circuits.
Q: er and Power factor in AC
A: If we talk about the power then it will always about the useful power. The useful power is also…
Q: Describe the steady-state similarities and differences of DC and AC circuits with purely resistive…
A: The Steady state is the condition of equilibrium in a circuit. In the case of DC circuits, the…
Q: A chopper circuit in the figure, 400 ? (???) Control the power of an ohmic load from a 50 ?? source.…
A: “Since you have posted a question with multiple sub-parts, we will solve first three sub- parts for…
Q: What is the mathematical definition of Kw?
A:
Q: (i) Explain why voltages and currents in ac circuits are typically described using root mean square…
A: As per our policy, i am attempting first question. The AC voltage varies over time, and the…
Q: What is practical application of PWM?
A: PWM stands for pulse width modulation. In this the signal is varied by varying the width of the…
Q: Find the currents and voltages shown in the figure below:
A:
Q: Derive the expression for power developed due to wind energy
A: Let v is the speed of wind, d is the height of the blade, Cross section area of blade is given by,…
Q: What is the application and rating for extra super tension
A: Extra super voltage cables: These are used for applications with voltage requirement above 132 kV
Q: Q2: A) Sketch the block diagram of thermal power station, then state the main parts of the plant and…
A:
Q: C- List the name of FIVE surfaces shown in figure below by matching I. II &ll I II III AEHD dodz…
A: given diagram is a part of cylindrical coordinate system (ρ,ϕ,z) ρ is the distance from Z axis (…
Q: What is the physical meaning of the reactivepower and the power triangle? Explain how
A:
Q: In the figure below, find currents ı, lz and I. If the current should point in the opposite…
A: To find the current i1. i2, and i3 we can apply mesh analysis. There are two meshes, the respective…
Q: (b) What additional component would you add to an ideal current source to "model" realistic…
A: Ideal current source: It is a two-terminal device that supplies consistent current independent of…
Q: How to calculate the impedance of a coil?
A:
Q: How would you calculate active, reactive and apparent power?
A: In AC Circuits, Voltage and currents are not in the phase. There may be a phase difference between…
Q: What is AC and DC Power Source? ( 5 sentences each )
A: AC refers to an Alternation Current DC refers to Direct current
Q: Inductive reactance, resistance, and impedance are all measured in ohms. What is the common…
A: When an electric current flows through a resistive circuit, the current faces an opposition. In…
Q: (a)Using the current sheet concept derive the peak value of mmf of a machine in terms of uniform…
A: Current sheet concept: It was seen over that a distributed winding brings about an MMF wave in…
Q: What is relationship between Ac resistance and dc resistance? (report)
A: AC resistance is always higher than DC resistance. Let's understand what the difference is between…
Q: What is the physical meaning of the reactive power and the power triangle? Explain how
A:
Q: Is the relationship between the change in Vgs and the resulting change in In linear or non- linear?…
A: The relation between the gate-source voltage and the diode current can be given by the Shockley’s…
Q: Discuss the difference between Alternating Current (AC) and Direct Current (DC)
A:
Q: please write introduction about AC Circuits and Parallel Circuits
A: Ac circuits Generally, series A.C circuits are of 3 types- R-L series A.C circuit R-C series…
Q: Field current If can be varied by varying the resistance of field resistance which is connected in…
A: Field current if can be varied by varying the resistance of field resistance which is connected in…
Q: Write the application of extra super tension that have rating 132KV and what used for?
A: Extra super tension cable have voltage rating upto 132 KV .
Q: Q6.Using Kirchhoff's current law, find the values of the unknown currents in Figure .below SA
A: To solve above problem, we will use Ohm's law and Kirchhoff's law: Ohm's law state that in a current…
Q: (A) The circuit shown in figure below has a Ves(oft) = -4V. Assume that you increase the supply…
A: A) The given circuit is, By increasing a supply voltage the drain current ID also increases from…
Q: What is the average Power at maximum resistance? Why? What is the effect to the voltage and current…
A: Part 1: The instantaneous power is the multiplication of the instantaneous voltage and the current.…
Q: b. i.Use Kirchhoff's Voltage Law to mathematically write an expression for the figure below
A: Circuit diagram is given as,
Q: 1) According to the figure given below: a) Determining the dc resistance at 2 mA. b) Determining the…
A:
What will happen to the value of the impedance if the resistance will be increased or decreased? Explain...
Step by step
Solved in 2 steps with 2 images
- B. Define ( resistance, reactance, impedance. rks rksBasic Electrical EngineeringDraw symbols of electrical components. Note: You may use both IEC and NEMA symbols. - Conductors crossing but not connected- Conductors crossing and connected - DC source other than battery- DC generator- AC voltage source- Ideal current source- Ideal Voltage Source- Current Controlled Current Source- Current Controlled Voltage Source- Voltage Controlled Current Source - Voltage Controlled Voltage SourceB.. What is the load current for the circuit shown in the figure? Please choose one: a. 6.0 mA b. 3.0 mA C. 9.0 mA D. 7.5 mA
- Which of the following statement is true? a. Angle between load voltage and load current in a pure capacitive load is 45 degree. b. Angle between load voltage and load current in a pure capacitive load is is 180 degree. c. Angle between load voltage and load current in a pure capacitive load is is zero. d. Angle between load voltage and load current in a pure capacitive load is is 90 degree.The ratio of the . between the ends of the wire to its . . is .22 ............ * .constant Power, Current P.D, power O power, P.D Current, resistance O P.D, current OA circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the source voltage and the current through the circuit? a. Insufficient information is given. b. The source voltage will lag the current. c. The source voltage will lead the current. d. The source voltage will be in-phase with the current.
- a) Graphically show the differences between alternating current voltage (A.C) and direct current voltage (D.C). What are the advantages of A.C compared to D.C?N.theory question electrical engineering.An AC circuit is shown in the diagram. The source of emf has a peak voltage of 9.00 V and a frequency of 60.0 Hz. Assume the wires contribute a negligible amount to the resistance and the AC source has negligible internal resistance. 524 2 493 2 1.56 k2 a) Find the equivalent resistance of the circuit. Redraw the circuit showing the equivalent resistor and use this simplified circuit for the rest of the problem. 315 2 Re = b) Find the rms current. 9.00 V, 60.0 Hz c) If the current is zero at time t= 0, find the first two times (after time t-0) that the current is equal to its rms value. and d) Find the average power dissipated by the circuit.
- If a circuit has two equal parallel resistances connected to a 150V DC power source , then the P.D. exist between the mid-point of one resistance and a point that is one-third from the other resistance equal to -----2 The figure is a graph of ... 5 (5 Points) Current Voltage the current across a voltage as a function of the potential difference through it the resistance as a function of the current across a component the current through a component as a function of the voltage across it All three of the above (a), (b), and (c) are true None of the above (a), (b), or (c) is trueSteady current circulation is desired for a lamp connected in a circuit to light. For this, explain how a stable current will occur from any part of the circuit with the conservation law of the charge. Give me detail pls.