Q: Why would industry prefer to purify solids by sublimation or zone refining rather than…
A: The advantage of sublimation for purification process are i) Minimum amount of product is lost. ii)…
Q: What is the significance of crossing aline in a phase diagram?
A: The significance of crossing a line in phase diagram are discussed as shown below, Consider…
Q: Ethanol is miscible with water. Assuming that caffeine is soluble in ethanol, could you use ethanol…
A: Let us assume that caffeine is soluble in ethanol
Q: When water is shaken with hexane, the two liquids separate into two phases. Which compound is…
A: When two liquids are mixed. If it is immiscible then the two phases are formed in which one is…
Q: Describe a binary eutectic diagram and show all phase regions with all the relevant information for…
A: The binary eutectic phase diagram explains the chemical behavior of two immiscible (unmixable)…
Q: If acetone is miscible with both water and xylene, then why can’t all three form a clear single…
A: "Like dissolves Like" which means polar solute dissolves in polar solvents and non- polar solute…
Q: Illustrate dissolution of the ionic solid NaCl in water?
A: The compounds can be classified on basis of bonding as: Covalent compounds ionic compounds The…
Q: Describe the molal boiling point-elevation constant for the solvent?
A: We a non volatile solute is added to the solution to a pure solvent then there is an eleviation in…
Q: does the boiling point of liquid solution independent of its composition (yes or no?)
A: To explain: does the boiling point of a liquid solution independent of its composition.
Q: Describe the ideal condition/set-up for recrystallization of substances. What are the factors to…
A: A question about re-crystallization, which is to be accomplished.
Q: Why is it necessary to completely dry the Erlenmeyer flask, after removing it from the ice-bath?
A: If Erlenmeyer flask would not be completely dry =====> Some mass of water droplet added in the…
Q: Describe the distillation of partial miscible liquid in terms of phase diagram.
A:
Q: Describe in detail the process of purification of a compound via crystallisation by gradual cooling.…
A: Purification of compounds can be achieved by various processes such as crystallization, sublimation,…
Q: What type of solid-liquid extraction is done when the tea leaves is boiled in water?
A: Answer. Tea leaves boiled in water undergo two separations 1. hydrophilic contents absorbed in…
Q: How can solid solution occur between materials?
A: Solid solutions occur between materials as follows.
Q: Hydrophobic colloids are stabilized in water by adsorbed anions. Explain with an example?
A: Hydrophobic colloids are stabilized in water by adsorbed anions has to be explain with an example,
Q: explain the difference gel filitration and gel permeation ?
A: Both Gel filtration and gel permeation techniques involves the separation of molecules in a sample…
Q: provide a reason for the increase in the condutance with increase in temperature for electrolytes
A:
Q: Explain how vacancies are introduced in a solid NaCl crystal when divalentcations are added to it.
A: The properties of a solid can be changed desirably by adding known amount of impurities in its…
Q: Describe how fractional distillation can better purify a mixture of liquids by discussing a liquid…
A: To achieve a desired degree of separation of a mixture of liquids, the general method involves…
Q: Calculate the weight of benzene codistilled with each gram of water and the percentage composition…
A: Distillation is the process involving the conversion of liquid into vapour and subsequently…
Q: Phase changes; Show the water phase changes diagram and how it's difficult from the Carbon dioxide…
A: Phase diagrams shows the preffered physical states of matter at different thermodynamic variables…
Q: Explain the process of detergency using micelle formation.
A: A colloidal solution is a heterogeneous system in which one substance is dispersed as very fine…
Q: An unknown substance in a container is a single phase and the components were not separated using an…
A: Solution is a homogeneous mixture of two or more than two components, whose composition vary to the…
Q: .Why is slow cooling required to produce pure crystals?
A: We are to discuss why slow cooling is done to form pure crystals.
Q: 4. The water levels inside and outside the flask when it was submerged in cold bath must be equal…
A: The detailed solution of the given question is typed below. Here it is important to note that the…
Q: What is suspensions? Select one: Dispersed systems in which one liquid is dispersed as finite…
A:
Q: Give clear handwritten solution- What is the normal boiling point of this compound? (Using phase…
A: Before solving this question, in the phase diagram assignment of the phases and equilibrium curves…
Q: Phase Diagram for Solution Critical Point 217.75 (Critical pressure) Normal freening point 1.00 New…
A: normal boiling point is the temperature at which the vapour pressure is equal to 1 atm or 760 mmHg.…
Q: In Purification by Sublimation, what improvement can suggest to increase the amount of crystals that…
A: Sublimation refers to when a substance in a solid-state and changes into vapours without going into…
Q: Research on the process of desalination with the use of distillation. Write how vapor-pressure…
A: Desalination is a process that takes away mineral components from saline water. More generally,…
Q: Consider the phase diagram below for Na, K, and the compound Na2K. For each region 1-6 give the…
A: Phase diagram describes the different physical states of a substance under different conditions of…
Q: Does it take longer to boil water with salt added to it; if so, why is this?
A: The answer to the following question is- when we boil water the water molecule escape to air in form…
Q: What is the normal boiling point of this solvent?
A:
Q: Crystals of a substance changed their colour on heating in a closed testtube but regained it after…
A: A chemical reaction involves the reactants, substrates, catalyst, temperature-pressure conditions,…
Q: The vapor pressure of aniline near 100°C is approximately 46 mm Hg. Estimate the amount of aniline…
A: Given Vapor pressure of aniline, Paniline=46 mm Hg Total Pressure = 760 mm of Hg Total Pressure =…
Q: 2. With the help of the Phase rule, draw and describe the phase diagram of Sulphur system.
A:
Q: What are the purposes of the following in recrystallization of solids? I) boiling stones – II)…
A: The addition of seed crystals leads to create nucleation sites which help in forming crystals. The…
Q: Explain the principle behind vacuum distillation.
A: Vacuum distillation is one of the processes that made industrial wastewater reusable. In this…
Q: Which statement best describes the differences in the melting temperatures (Tm) of CaO and MgO?
A: Tm(MgO)>Tm(CaO): Stronger ionic forces due to smaller distance between the ions (size) This is…
Q: Solution Solute Solvent solid Hydrogen in palladium solid Mercury and sodium bronze solid liquid…
A: A solution is a homogenous mixture of two or more substances whose composition can varied within…
Q: Why does micelle formation take place when soap is added to water? Will a micelle be formed in other…
A: When we will add soap in water. There are two ends of soap molecule, one end is hydrocarbon chains…
Q: Aside from London dispersion forces, which substance d interactions to be effective?
A: There are different types of forces act between the molecules:- Hydrogen bonding Dipole-dipole…
Q: It is preferable to use the conical beaker for the crystallization process
A: Beakers (cylindrical) have a very wide surface area, which allows hot liquids to evaporate more…
Q: What is true about the miscibility of water and cyclohexane?
A: Miscibility is the property of two or more liquids to mix in all proportions so as to make…
Q: why crystallization is considered as a First-order Phase transition?
A: Analysing change during crystallization process.
What limitations are encountered in the apolication of sublimation as a general method of purification?
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
