We are designing a small office building with exterior siding finish: What is the code requirement for maximum spacing and nominal thickness of the direct to studs lap siding for 2”x4” framing? What must be for over sheathing of the shiplap edge panel siding? Use 2007 California Building Cod

Q: A basin is divided by 1-h isochrones into four sub-areas of size 200, 250, 350 and 170  hectares…

A: We have to find out the peak rate of runoff, So we have ,

Q: 13-33 Water at 20°C flows at a depth of 0.4 m with an average velocity of 4 m/s in a rectangular…

A:

Q: 14.2 Identify the type of bond patterns in the following 2 masonry walls. WALL 1 WALL 2 MO

A:

Q: Can you do a procedure on this using three moment diagram equation?

A:

Q: 15 ft 2.5 k/ft B A El= constant 15 ft 50 k-ft с

A:

Q: Find the missing rainfall (in mm) at station X. (given data are in mm) Rain gauge Normal Actual A…

A:

Q: 1. y=kx4 le b Find the moment of inertia of the shaded area with respect to the x-axis.

A: A curve y = kx4 is given and an area is shaded between the x-axis and the curve. The shaded area is…

Q: Q7. A flocculation. Chamber 30 m long, 12 m wide and 4.5 deep is to treat (y) MLD (million liter per…

A:

Q: Give me sample problem on cables carrying concentrated load.. Show how to solve the support…

A: Solution: Consider a basic parabolic cable with a span as L and with a deflection or dip at the…

Q: Three pipes A, B, C joins at D. A reservoir whose water elevation +140 is connected to pipe A 0.25 m…

A:

Q: Knowing that P = 5.4 kN, determine the factor of safety for the structure shown. Use E = 202 GPa and…

A: A) P = 5.4 kN E = 202 GPa To Determine : The factor of safety for the structure ? A problem of…

Q: What is the maximum moment at midspan in the following beam? Use L = 22, a = 3, b = 3, P₁ = 4, P₂ =…

A:

Q: 8-96 A certain part of cast iron piping of a water distribu- tion system involves a parallel…

A:

Q: K= 2 x 10³ cm/sec 2. Elev. = 100 shale (impermeable) b he h₂ A 14' 65 B Fill in the blank total,…

A: A flow net for underground flow is given below, Total equipotential drop, ND = 7 Total flow…

Q: What is the settling velocity of a discrete particle in a wide body of water when the relevant…

A: Given data : Diameter of particle = 2 X 10-3  Specific gravity = 2.65  Water temperature = 20oC…

Q: A Single rivet lop joint is to connect 12mm thick plates by providing 20mm dia. rivet at so mm…

A:

Q: An over dried soll mass of 200 gm is placed is pycnometer and completely filled wi water. Combined…

A: Given : Oven dried soil mass = 200 gm Mass of soil + bottle + water = 1605 gm Weight of pycnometer…

Q: Water flows from a lake into a rectangular channel 3.0 m wide, and the lake level is 3.0 m above the…

A:

Q: Q1. For a city (A), given the following table of population: Year 1950 1960 1970 Pop. 157,000+x…

A: Note: As per guidelines, we will only discuss first question. Here x and y is not mentioned. So…

Q: 6. In a longitudinal profile, which is rotated at center lane. The height of the outer lane is 0.80…

A: given:  height of outer lane (h) = 0.8m superelevation (e) = 0.08 To find : width of road (w)

Q: Question 2 A road is being designed for a speed of 110 km/hr on a horizontal curve with a super…

A: Given- Speed V=110 km/hr, Super-elevation e=8%=0.08, f=0.10, Minimum radius of the curve R=?

Q: EXAMPLE: For the foundation shown in the below; estimate quantity of Reinforcement. Depth of…

A:

Q: Problem 3.11. At a point within a body subjected to two mutually perpendicular directions, the…

A: Given : Stress 1 = 80 N/mm2 Stress 2 = 40 N/mm2 Shear stress = 60 N/mm2 This is a problem of…

Q: 8-42E Water at 60°F passes through 0.75-in-internal- diameter copper tubes at a rate of 1.2 lbm/s.…

A: Diameter of copper tube = 0.75 in Mass flow rate = 1.2 lbm/s   To determine the pumping power,P per…

Q: What is the difference between three-moment equation and moment distribution methods if applied to…

A: What is the difference between three-moment equation and moment distribution methods if applied to…

Q: ← Fluid Properties The diameter of droplet is 0.075 mm. What is the intensity of the pressure (N/sq.…

A: Given Data  Diameter of droplet (d) = 0.075 mm  Surface tension = 0.000075 N/mm  Find the intensity…

Q: 94444% 00962% 11702% 25000% 41892% ne of the Choices

A:

Q: 17.6 A solid steel shaft 3 in. in diameter and 4 ft long is fixed at one end and free at the other,…

A: Given data  Diameter of shaft =3 in  Length of shaft = 4 ft  Axial tensile force = 50000 Lb

Q: பாத்மகளம்பழியபப்ரீமகவதிபபபபபபபபபய்பா Problem 11.1 - Determine the product moment of inertia of the…

A:

Q: Problem: A load of 2 MN is applied on a short concrete column 500 mm x 500 mm. The column in…

A: Given : Applied load = 2 MN Column size - 500 mm X 500 mm Steel - #4 - 10 mm E for Steel = 2.1 X 105…

Q: 8. Calculate the uplift force on the lift station box. The base of the box is 3' x 3'. 424 2' 3' 7'

A: Uplift Force: The uplift force is the upward force that is applied to the structure. The pressure of…

Q: A town with a population of 150000 people is supplied with water through a pipeline from a reservoir…

A: Given: A town with a population of 150000 people. Supplied with water through a pipeline from a…

Q: are

A: In the question we are asked about the civil    engineering  we will discuss in the next three steps…

Q: 13-45 Water is flowing uniformly in a finished-concrete channel of trapezoidal cross section with a…

A:

Q: Replace the force system acting on the post by a resultant force(Figure 11. Figure 1 m 500 N 0.5 m…

A:

Q: for the truss find the following members: BD,CD,CE using methos of joints, starting by finding the…

A:

Q: The speed of the brake drum shown is controlled by a belt attached to the control bar AD. A force P…

A: We have to fnd out the magnitude of the couple being applied to the drum.

Q: : Design the T-Beam section shown in fig. f'c-24 Mpa, fy=414 Mpa. L.L=24 kN/m D.L=15 kN/m -5m- -2 m-…

A:

Q: sketch the NFD, SFD, BMD, and deformed shape

A: A frame is given with roller support at A and fixed support at D. A hinge is also present at C. The…

Q: H.W 13. A cylindrical vessel of radius ro filled with water to height h is rotated around the…

A:

Q: Can you list the benefits of good building design? Let's examine a project and compare its potential…

A:

Q: Calculate the diameter of a pipe that would carry 75.0 ft/s of a liquid at an average velocity of…

A:

Q: Calculate the resultant moment of forces F1 = 23 lb, F2 = 76 lb, and F3 = 58 lb about point A.…

A:

Q: 1. A symmetrical parabolic curve passes through point A whose elevation is 23.23 m at a distance of…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Problem 11.5 - Determine the product of inertia of the crosshatched region with respect to the x-…

A:

Q: Cars are entering a parking lot at a rate of 7 cars in the first minute, 10 cars in the second…

A:

Q: (a) List at least five examples of a discrete variable and five continuous variables.

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 1. Taking soil samples and testing the soil properties takes an engineer an average of 35.5 days per…

A: Given data, Average expected time to execute(TE )= 35.5 days  Standard deviation = 1.9 days  For…

Q: Question 8 In a two-dimensional field the velocity of fluid flow is given byv = (y³ - 5x²y)i +…

A: Given: In the two-dimensional field the velocity of fluid, v→=y3-5x2yi+3Cxy2j

Q: 7.12 The saturation flow rate of an approach to a pretimed signal is 6000 veh/h. The signal has a…

A: