water which is to be drained completely. The exit pipe is exposed to the atmosphere. The distance from the water surface to the exit pipe is 6 m. And the distance from the water surface to point B is 1.2 m. a. Calculate the pressure at point B. b. Calculate the velocity at point B and point C

Q: Draw the relation between Re. and velocity. Draw the relation between Re. and Q.

A: Relation between Re vs V Re vs Q

Q: A pump is used to deliver 50 liters/sec at 120 rpm. If the rpm is increase to 140, determine the new…

A:

Q: Liquid water is flowing at a rate of 25 gpm in a pipe. At one end of the pipe, the internal diameter…

A:

Q: wind tunnel has an inlet section with a velocity of 360 ft/s at standard atmospheric conditions. The…

A:

Q: Initially tank I and tank II each contains 100 gal of brine, tank I having 200 lb salt and tank II…

A: Write the given data in the problem. V1=100 galm1=200 lbm2=50 lb v˙1=2 gal/min v˙2=3 gal/min    t=50…

Q: 6. Compressor blades are designed to produce: Turbulent flow into the combustion chamber. A steady…

A:

Q: respectively. The outlet end is 2m above the inlet end. Calculate the magnitude and direction of the…

A:

Q: Calculate the volume flow rate of oil from the nozzle and the pressure at point B and D.

A:

Q: (b) A jet of water, having a velocity of 30 m/s impinges on a series of vanes with a velocity of 15…

A: Concept Of Hydraulic Machinery Is Used Note: There are four question and we are bound to solve only…

Q: . The circular tank of water is being filled from a pipe shown in figure below. The velocity of…

A:

Q: 3. A water hose on the ground discharges water at a velocity 20 m/sec at an angle of 35 degrees with…

A:

Q: How much flow energy in kW required to move 3000liters/min. of water inside the pipe against a…

A:

Q: An irrigation pump delivers water through a 6 - inches horizontal pipe flowing full at the outlet,…

A: If an object travels with constant velocity, then the motion of the object is said to be uniform…

Q: a radius r before emptying into a holding tank. What is the difference in pressure between the water…

A:

Q: A pipe reducer with the pressure at A and B is 345kPa and 290 kPa respectively. the diameter at A…

A:

Q: Find the coefficlent of velocity.

A:

Q: Q.2: This system of blades develops 149kW under the influence of the jet shown. Calculate the blade…

A: Given   Jet velocity, V1 = 90 m/s   Jet diameter, d = 25 mm                 Angle = 30o Find   Blade…

Q: The energy wasted as compressed air escapes through the leaks is equivalent to the energy it takes…

A: Consider a system A with air inside it at relatively high pressure than the surrounding. If the air…

Q: How much energy is lost by a fluid when suddenly discharging to the open atmosphere from a pip

A: Here, due to sudden discharge there is minor loss due to sudden discharge. head loss (hL) = v22g…

Q: A conical reservoir is 6 meters in diameter and 10 meters in height. If it is initially half-full…

A: Density of a fluid is defined as the mass of the fluid per unit volume of the substance. Weight is…

Q: In a centrifugal pump, the liquid enters the pump _________ a.At the centre b.At the top c.From…

A:

Q: A twin-engine jet aircraft is climbing at a 10 degree angle, measured from the vertical, at 260…

A:

Q: Say an aircraft equipped with a turbofan engine has a net thrust of 40,000 N. The mass of ai flowing…

A:

Q: Q.3 Briefly explain why it is necessary for gases to flow in and out of a cylinder with minimum…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 6. Water enters a hydraulic reaction turbine with a velocity of 12 ft per sec and leaves it 3 ft…

A:

Q: Determine the mass fow rate of the liquid through the pump?

A: Given;  An idealized centrifugal pump, data given as ;   N=2000 rpm   r=45 mm=0.045 m   P=3 KW=3000…

Q: A two-blade wind turbine is exposed to 60 mile/h wind. Downstream of the propeller the wind speed is…

A:

Q: An office room has a dimensions of 3x4x3 meters. It is desired to ventilate theentire air in 20…

A:

Q: Compute the energy requirements to convert 50°C water to superheated steam at 170°C when the…

A: At P=210.82KPa State-1 water T1=50°C P1=210.82KPa (Using saturated steam table) h1=209.5108 KJ/Kg

Q: Air 4ft Water Air 2ft + 2ft Find the pressures at A, B, C and D 4t Water

A:

Q: The angular momentum of the body is equal to?

A: L=mvr L=p*r P=momentum V=velocity r=radius L=angular momentum L=axial vector

Q: Water flows at 6 gal/min through a small circular hole in the bottom of a large tank. Assuming the…

A:

Q: Explain the substance leaves actual nozzles at a higher temperature (thus a lower velocity) as a…

A: A substance leaves actual nozzles at a higher temperature (thus a lower velocity) as a result…

Q: The graph shown provides the pump characteristics (performance) curves. There are two pumps in the…

A: For given characteristic curves for pump 1 and pump 2, When pumps will be connected in series, their…

Q: a) The mass flow rate of alcohol. b) The pressure at section (1) if there is no losses in the…

A:

Q: 5. A pump draws water from reservoir A and lifts it to reservoir B. The loss of head from A to 1 is…

A:

Q: rocket is released at point A fi

A: Dear Student detailed Solution given below.

Q: Find the velocity of the steam at the exit of the nozzle

A: Given data: Dry saturated steam at a:      pressure(p1)=10 barIt leaves at a:      pressue(p2)=1 bar…

Q: (b) A jet of water, having a velocity of 30 m/s impinges on a series of vanes with a velocity of 15…

A:

Q: 1. Calculate the pressure of the air in kPa leaving the compressor (State 3).

A:

Q: Water is flowing in a pipe with varying cross-sectional area, and at points the water completely…

A:

Q: A liquid is flowing from one large tank to another through a 1 in. diameter pipe. The level in tank…

A: The direction of water flow: Tank B ---> Tank A

Q: An industrial tank is discharging a fluid through a 5-inches nozzle with a velocity of 5 meters per…

A: Given data Discharge nozzle diameter = 5 inch = 0.127 mDischarge nozzle velocity = 5 m/sInlet flow…

Q: a) Find the net drop of the turbine. b) Find the specific velocity of the turbine. c) Find the…

A: Refer below content for solution.

Q: When there is an excess potential energy during the fluid flow, it can be stored using --

A: When there is an excess potential energy during the fluid flow, it can be stored using Answer: c)…

Q: Compute the lost pressure in a 150 mm, 90-degree pleated elbow that has 70.8 L/s of air flowing…

A: D=150mm=0.15m Q=70.8 L/s=0.0708 m3/s r/D=1.5

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.